Originally Posted by
mhavlena
Guys:
using 1XA and 1E blocks in the rear, but my setup system shows me that I am 3 deg toed-in on the left, but 3.5 deg toed-in on the right...
Has anyone experienced this before? How can I rectify? Perhaps I need to purchase new mounts?
Any experience would be appreciated!!
try loosening the screws under the blocks and re-tightening them. Also, check all the blocks for any kind of bend (this can happen after hits), and if bent, replace. If it's still the same, it's most likely just some slack in the setup system or bearings... put it down and run it.
HiH
Ed