Originally Posted by
magicrobots
I have a Spektrum 6030 servo, and I needed a longer arm so I got a JR splined alloy arm. The spline slides right on, and then has a teeny bit of play when the retaining screw is tightened up. Like half a degree or something; it's barely noticeable, but it's there.
Is that going to chew up my spline? Or is it no big deal?
Does anyone have some tips on marrying the teeth on the splines more tightly? Scotch tape? Cake?
Any help would be greatly appreciated. Thanks!
Is the play like moving up and down or side to side.
Will did you get the right tooth count horn like furtab a 25 airtroincs a 23 i dont know the rest cause i dont have them. that might be something to look at or at lest post that you have the right horn cause mine all fit nice and tight. Is this new horn deeper than the stock version or kinda on the money. some are thinner than other which mean you might have to change the screw that holds it now if it too long now or add a waser. these are some of the casueses i have found over some time.