View Single Post
Old 08-02-2004, 03:51 AM   #9160
Matt Howard
Tech Champion
 
Matt Howard's Avatar
 
Join Date: Aug 2001
Location: Abilene TX
Posts: 5,952
Trader Rating: 6 (100%+)
Default Re: setup

Quote:
Originally posted by shortygy
Matt I was just wondering with the 2 last setups that you posted, that I have on my site www.yokomo.tk. I was wondering about the outer hinge pin placement, on the front c hub and the rear hubs. you dont sepcify a hole there. also with the shims on the knuckles in between the front c-hub.... Could you please just interpert that for me to clarify

Thanks Greg
sure, I used the lower holes in both the front and rear. The shim should be above the steering knuckle.
__________________
Official member of The Guild of Calamitous Intent and proud supporter of Conjectural Technologies.
Serpent S411 LE kit #192
RCTech #361
Matt Howard is offline   Reply With Quote