Originally Posted by
CristianTabush
These DCJ's use a 5mm bearing. They should drop right in, although I have not had the 6.1 caster blocks in my hand to test them. With the 6, you have to shave the caster block a bit to make them work. I have not had increased breakage due to this though.
We can certainly look into the Schumacher. It is just a matter of getting some schumacher drive shafts in my hands.
At the moment, we were not really planning on different lengths for the TC6. However, if we see that there is enough demand for it, we can look into it.
If they are about the same size as the HB DCJ's, they will drop into the 6.1 C hubs. If they are the same size as the Xray ECS's, you will need to sand the 6.1 C hub edges ever so slightly.
Originally Posted by
Edwin Pibal
hiya
i thought the tc6 was 6x10 and the 6.1 was 5x10 ?
well, according to the manuals they are.
Ed
These will drop into the 6.1. You can get some 5x10x3 bearings and they will fit the 6 parts (you will need to dremel out the 6 c hubs as mentioned).