R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 01-09-2012 | 12:45 PM
  #9477  
brent701's Avatar
brent701
Tech Master
iTrader: (8)
 
Joined: Oct 2011
Posts: 1,590
Default
Originally Posted by bilster44
Does anyone else on this thread agree that the front hex axles that use a "C" clip to keep the bearings apart is a bad design? I keep getting one wheel that rolls nice and free, and one that is somewhat "bound" up...
Originally Posted by bilster44
I was asking about people that have had the same problem, not the people that it has worked out just fine for. But in noticing that you have posted OVER 15 thousand times on one thread, that tells me that you will ALWAYS have to throw your opinions out there regardless of what the question is...STFU for a bit wild cherry !
Chill out there.

It's a opinion. Welcome to the internet. EVERYTHING anyone says is a opinion. we are not all 100% the same in thought.

You asked a question. Did you really think only the people who agree with you are going to post about it?

I run the style with C-clips on the axle. Yes I have toasted a bearing. It cost me 2 bucks to fix.. not that big of a deal. Each has it's pro/con..

wild cherry Has added some damn good info, that I know for a fact lots of people have used.

Play nice
brent701 is offline  
Reply