Originally Posted by
AlGio
Check Two things. First is that if your servo is not digital then your system must be in PPM mode and not HRS. Two is try to reset your ESC. Usually the servo problem is the PPM/HRS modes.
Hi
thanks for the reply, have only got non digital servo's to test with (have ordered digital one)
Set mode to PPM -
Reset ESC to default settings (running in blinky mode)
Turn on TX, then turn on car
Steer left then right - RX flashes green then red - steering not responsive
Replaced servo with new one - identical issue.
Am at a bit of a loss what i have done wrong with this one