I just bought my first Fukuyama pack this week, and although I havent run it yet I was very impressed with your ultra fast service. In 48 hours from my placing an order online I had a fresh soldered pack on my door step waiting for this weekend's race.
I opted to let you guys solder it for me, and the joints almost look machine done.
Anyways I did have a question for you guys concerning equalizing Ni-Mh on a discharge tray. I just picked up an Integy Activator tray, and was hoping to use it on some older 3300 HV celled packs that I picked up second hand. I am a bit unsure about using it though, as I was always told to Never discharge my Ni-Mh packs past 0.9V a cell, and the tray has a cut off @ 0.0v
Is it okay to tray my Ni-Mh HV packs down to 0.0v ? What about my new GP cells I just bought? Or do I have to modify my tray's diodes for a higher cutoff point?