Originally Posted by
Lake Ober
I think I am going to put the 12mm hex adapters on my FT SC10, because I am interested in using the Pro-Line Split Six wheels. I have always been a fan of the beadlocks and would like to get them again. Do you know what the part number is on the 12mm hex adapters that fit on the FT SC10?
Rear 12mm Hex - Jconcept #2081
Front part #'s I am using Factory RS parts. I like keeping things factory if I can
Steering block - #9880
axle - # 9881
Ball stud is long silver #6277
Locking nut for ball stud # 4449
12mm Hex #9883
The bearing # is 3977. You can use the ones in the rims. Same bearing, to save a few bucks,
The Hex kit comes with front/rear hex. You can just use them. I am not a fan of the rear plastic hex though.
You can also run different locking front hex. I don't. It makes the front to wide for me. I have the plastic ones with a small hole drilled in it to and a pinion set screw in it. They like to come off with the rims. No real big deal though
Hope that helps