R/C Tech Forums - View Single Post - B44.1 Thread
Thread: B44.1 Thread
View Single Post
Old 12-26-2011 | 07:35 PM
  #1015  
SpraydbySprague's Avatar
SpraydbySprague
Tech Elite
iTrader: (64)
 
Joined: Jun 2008
Posts: 3,301
From: Conducting aggressive board meetings at my local track
Default
Originally Posted by Pointy71
I changed to 68+mm and then it was around -2 degrees. Did notice the wheels were not symmetrical (same angle of camber) even though the turnbuckles were EXACTLY the same length... Had to make small adjustments.
Are you using wheel with the tires mounted? I prefer to use bare wheels to set camber and toe. It gives a more accurate reading then dealing with the flex of the tire. Also, be sure the vehicle is on a clean, flat, smooth surface. Cutting boards make for good inexpensive set up boards.

Acrylic cutting board
SpraydbySprague is offline  
Reply