Originally Posted by
Steve Weiss
ioxqq,
I would recommend starting out with the zero degree hub inserts for most conditions.
Every 0.85 mm of shimming different between the front and rear produces 1 degree of toe in.
Generally, I like running 3 degrees of toe in on the rear, and to produce this I would recommend starting out with either 0.5 mm shim in the front and 3.0 mm in the rear or 1.0 mm in the front and 3.5 mm in the rear ...both of these will yeild approximately 3 degrees of rear toe in.
Hope this helps!
The new #31361 offset arm mounts already add 2mm of spacing so you would only need to add 0.5-1.5mm of washers to get the desired rear toe in. Correct?