Originally Posted by Pointy71

Just finished building my new B44.1. Setup is all stock.

Strange thing is that the rear wheels have way too much camber; 4-5 degree negative.

As per p13 of the manual I made the rear camber link 67mm (actually the manual which is supposed to be scale 1:1 results in just below 66mm).

I checked all other setting several times but I did not do anything wrong... Manual must be wrong?!??!

Can anyone check the length of your rear turnbuckle? Please let me know if you measure end to end or center of ball cup to center of ball cup (as per the manual). I'd like to achieve -1 degrees camber which is stock. I know I can use the setup tool but I'd rather find out what went wrong and what the correct length should be.

I've been google-ing for an hour but can't find anything...