Originally Posted by
zleader_99
Hi
I bought a new to me VTX10, with usb cable and No progauge. I update the firmware to the A30 which I think is latest. I was trying to do the calibration to my radio, but hit a road block. I am using a 4pk verified epa 100% and trims are fine. I did check out the facebook info on setting up the esc but I dont have a proguage to verify the voltage outs.
This is what happens, I hold the button for 3 secs and the two light blink green. I hold my throttle and try pressing the button for one sec. Some times I can press the button but nothing happens, other times it just starts flashing. Each time it sets my reverse as forwards.
I did read somewhere to set my throttle end point to max. I have not tried that yet. I also read reversing the servo. Tried that but it did not work. I do have a pro guage coming in a week or so.
Any idea would be appreciated. I going to try it again, maybe it was a little late and I missed something.,
Try this step for step.
Turn on your transmitter.
Press and hold the ESC power button for three seconds.
You will hear a beep tone. and see the F/N lights lit.
Pull full throttle for one second, you will hear a beep ad the lights will change to N/R.
Push full brake and release. You will hear a beep and the LEDs will cycle.
and you are done it will go to run mode on its own. I think you are just pressing to many buttons. lol try with your throttle endpoints at 100% if it fails Max them out and repeat.