Originally Posted by
MarkMcC
Hi Alan
This is ok, as long as the screws are corrrect there should be a bit resistance, the last mil or so, the holes are not tapped the whole way.
Hope this helps
Mark.
Originally Posted by
MDawson
You can also use a .5mm or 1mm spacer to provide some extra shoulder to support the screw/ball studs.
Originally Posted by
Oleg Babich
The last turns of the lover ST03 Ball Studs and SB3x5 screws are tight.
Screw them with force.
Thanks guys .. was just concerned about stripping the thread from over tightening.