R/C Tech Forums - View Single Post - Team Associated TC6 Thread
Thread: Team Associated TC6 Thread
View Single Post
Old 12-17-2011 | 04:45 AM
  #5045  
Chaz955i's Avatar
Chaz955i
Tech Master
iTrader: (5)
 
Joined: May 2009
Posts: 1,108
From: NE Ohio
Default
Originally Posted by R Doyel
Me too......... Having a good time doing it.

Question for you guys who have had the previous models. The bird's foot looking spacer between the supension mounts and the bulkhead......these seem pretty flimsy to me. When I install them, they crush a bit, and the mount ends up not being square. Has anyone else noticed this? I decided to put some metal suspension shims I had from another car in there. I'm curious to hear what you guys have experienced.

Thanks
THose clips work ok up front when running no toe. any mismatch from the front to the back of the inner pin and the plastic clips just deform and do not hold a setting. Most of us have either done what you have done or switched to the 12r5 bulkhead washers.
Chaz955i is offline  
Reply