Hi im a newbie on this forum
ive been reading thru 100+ pages on this thread and im having probs with my ver 2
The problem is that on the straights and high speed corners the car just spins even with a little tap on the controller and hardly runs straight, On the low speed corners its just about borderline and the rear just wanna break loose (as theres enough grip up front to throw it off)
(I checked the arms are equal length etc etc)
Specs:
TA05 ver 2
Brand new carbon reinforced chassis
Universal front driveshafts
Front medium sway bar
Rear soft sway bar
TRF dampers with medium springs ( 2 holes, 55wt oil)
Tamiya SS-RZ motor 5.75.1 gear ratio
Tamiya medium narrow tyres all round
Front ball diff (tight as i dare)
Rear ball diff (loose)
I kinda know how to tune a car and i have the xray setup manual to guide me thru, plus ive done things to make it 'understeer more' but its still the same (without going to extreme angles on toe and camber)