Originally Posted by
thefatkid
I run at an indoor clay/dirt track with very high bite. The track is very rough on the rear of the chassis, toe block and bumper/skid plate thing. The track has worn the back 1" of the chassis and related componets 1/8" or more. the arm pins are about to show through the toe block. Anyone have a fix for this after I replace the chassis, toe block and bumper so it does not happen again? I was going to switch to the STRC toe block and use large amounts of chassis tape. Have any other thoughs that I have not seen?
Its due to your rear suspension being soft and hitting jumps. Either you can deal with it, or work on a new setup to stiffen up the back a bit. You may want to limit shock travel or ride hight to start. You can go to the AL parts but they will scrape just as much, they will only last a bit longer.