Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: urnotevenwrg2
Showing results 1 to 25 of 500
Search took 0.16 seconds.
Forum: Chat Lounge
09-07-2018, 02:11 PM
Replies: 112
Views: 5,004
Posted By urnotevenwrg2

Thats the thing, we are saying that we know you...

Thats the thing, we are saying that we know you will not gain any useful data from this. You are saying you want to test to prove us right by producing inconsistent and quantifiably useless data. By...
Forum: Chat Lounge
09-07-2018, 01:27 PM
Replies: 112
Views: 5,004
Posted By urnotevenwrg2

Unless all of your tests are done with brand new,...

Unless all of your tests are done with brand new, perfectly built kits, your data will be tainted from the start.

Cars age as they are used, slop develops, and after a certain number of use cycles...
Forum: Chat Lounge
09-07-2018, 12:58 PM
Replies: 5,211
Views: 99,548
Posted By urnotevenwrg2

Josh Cyril (CEFX)*Kody Numedahl (Team...

Josh Cyril (CEFX)*Kody Numedahl (Team Associated)*
Billy Easton (Serpent)*
Juraj Hudy (Xray)
Josh Alton (HB, Team Associated, ADI)*
Kurt Wenger (Team Associated, Schelle)*
Frank Root (TLR)*...
Forum: Chat Lounge
09-07-2018, 11:51 AM
Replies: 112
Views: 5,004
Posted By urnotevenwrg2

Your results won't correlate to anything. You...

Your results won't correlate to anything. You fail to realize that the flex characteristics of one chassis means d*ck all compared with flex characteristics of a different chassis. Each car is...
Forum: Chat Lounge
09-06-2018, 11:42 PM
Replies: 112
Views: 5,004
Posted By urnotevenwrg2

Nerobro, your entire reason for doing this is...

Nerobro, your entire reason for doing this is based off a massively flawed misconception.



The ultimate goal of vehicle and setup development is to lower the lap times. "Guess and check" as you...
09-06-2018, 09:35 PM
Replies: 131
Views: 12,963
Posted By urnotevenwrg2

The 1.5mm hex wrench is easier to break than a...

The 1.5mm hex wrench is easier to break than a 2mm wrench, especially if you are forcing threads into the material for the first time. I would tap the holes, but leave a little bit untapped to act as...
09-06-2018, 06:30 PM
Replies: 7,289
Views: 1,177,253
Posted By urnotevenwrg2

Go look at the times from when you practiced on...

Go look at the times from when you practiced on September 1st. After you left there was a guy turning 13.8's with a stock buggy. The problem with a rear motor is how it doesn't like to change...
08-30-2018, 03:09 PM
Replies: 4
Views: 477
Posted By urnotevenwrg2

The timing in the esc is ramped in by degree of...

The timing in the esc is ramped in by degree of timing over rpm, so the adjustments reflect that. Basically you can adjust how much timing the esc adds, and how quickly it add the timing. The timing...
08-30-2018, 01:08 PM
Replies: 13
Views: 702
Posted By urnotevenwrg2

Bill, I just went and weighed a 2wd and 4wd front...

Bill, I just went and weighed a 2wd and 4wd front wheel, and the 2wd wheel was less than a gram lighter. You saved weight because of the tire and insert. Stop saying you saved weight because of the...
Forum: Chat Lounge
08-29-2018, 01:16 PM
Replies: 63
Views: 2,367
Posted By urnotevenwrg2

I have an under tray and diffuser on my rc F1...

I have an under tray and diffuser on my rc F1 car, but it is really just to protect the chassis.

Do you only race roar and ifmar sanctioned events? Does your car go through full tech inspection...
Forum: Chat Lounge
08-29-2018, 11:24 AM
Replies: 63
Views: 2,367
Posted By urnotevenwrg2

Does every track enforce the ifmar worlds rules? ...

Does every track enforce the ifmar worlds rules?

The rule above that says exotic materials like titanium are illegal. How many people have titanium parts on their cars?
Forum: Chat Lounge
08-29-2018, 09:25 AM
Replies: 63
Views: 2,367
Posted By urnotevenwrg2

Where in the roar rule book does it say ground...

Where in the roar rule book does it say ground effect aero is illegal? The only mention of anything is under the vta rules stating that additional side skirts are illegal.

Do you know the rules at...
08-27-2018, 02:28 PM
Replies: 404
Views: 58,273
Posted By urnotevenwrg2

Stickied right at the top of the page. LOOK...

Stickied right at the top of the page.

LOOK FOR A THREAD ON YOUR VEHICLE BEFORE POSTING NEW THREADS....
08-26-2018, 11:41 PM
Replies: 7
Views: 340
Posted By urnotevenwrg2

It could be a bearing has gone bad somewhere....

It could be a bearing has gone bad somewhere. Usually that will mean the motor will run hot.

It is very likely the battery. Try a different battery to see if the problem goes away.
08-26-2018, 11:34 PM
Replies: 643
Views: 80,467
Posted By urnotevenwrg2

The SC6.1 has a lay back transmission stock, not...

The SC6.1 has a lay back transmission stock, not a lay down. A lay down moves the motor weight forward from where it is with a lay back. The gear diff and ball diff both fit in any of the...
08-26-2018, 07:49 PM
Replies: 643
Views: 80,467
Posted By urnotevenwrg2

Look at the B6.1 and B6.1D setup differences and...

Look at the B6.1 and B6.1D setup differences and copy the same ideas. A lay down gear box, gear diff, and some thick sway bars are probably going to be stuff you will have to buy to make an SC6.1C.
08-26-2018, 12:00 AM
Replies: 48
Views: 2,462
Posted By urnotevenwrg2

What kind of internal resistance numbers are you...

What kind of internal resistance numbers are you seeing on the cells?
08-24-2018, 07:41 PM
Replies: 8
Views: 390
Posted By urnotevenwrg2

Yes, that is normal. That happens because of the...

Yes, that is normal. That happens because of the discharged capacitors on the esc.
Forum: Chat Lounge
08-24-2018, 06:34 AM
Replies: 5,211
Views: 99,548
Posted By urnotevenwrg2

Get some link parts for a different car. Get some...

Get some link parts for a different car. Get some piano wire of the correct sizes and bend up your own sway bars.
Forum: Chat Lounge
08-24-2018, 01:48 AM
Replies: 5,211
Views: 99,548
Posted By urnotevenwrg2

​​​​​​Add a 2mm spacer inside each front shock,...

​​​​​​Add a 2mm spacer inside each front shock, and unscrew the front shock eyelets two turns. Unscrewing the eyelet negates the spacer, but now you can adjust the shock length with the shock eyelet...
Forum: Chat Lounge
08-23-2018, 09:22 PM
Replies: 5,211
Views: 99,548
Posted By urnotevenwrg2

Because the wing would be heavy, and adding...

Because the wing would be heavy, and adding weight up high, behind the axle is not good for the handling. SWorkz makes a very durable plastic wing, but it is going to be heavier than a lexan wing.
...
08-23-2018, 06:25 PM
Replies: 4,134
Views: 884,796
Posted By urnotevenwrg2

What is the fastest lap you have seen someone do...

What is the fastest lap you have seen someone do at your track?
Forum: Chat Lounge
08-23-2018, 03:59 PM
Replies: 15,480
Views: 685,338
Posted By urnotevenwrg2

Looks like they changed the name of Force India...

Looks like they changed the name of Force India to Racing Point Force India. New name means they now have 0 points. The drivers get to keep their points though. I wonder if they have to keep Force...
Forum: Chat Lounge
08-23-2018, 01:29 PM
Replies: 5,211
Views: 99,548
Posted By urnotevenwrg2

Locally the stadium truck class has picked back...

Locally the stadium truck class has picked back up (probably because of the T6.1 coming out). Instead of getting a new mid motor truck I've been working on reviving my old rear motor truck. Got a new...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service