Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Search: Posts Made By: nlmbc
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Forum: Ask Hitec
04-09-2010, 08:32 AM
Replies: 10
Views: 2,511
Posted By nlmbc

linkage is in a straight line endpoints are set...

linkage is in a straight line endpoints are set to 99% open and no load on close ( gas carb cam leaver set up ) no brakes needed.

Have put new servos in to different boats and have them burn out...
Forum: Ask Hitec
08-10-2009, 05:31 PM
Replies: 10
Views: 2,511
Posted By nlmbc

battery pack is a 5 cell nim pack 1200-1400 mah ...

battery pack is a 5 cell nim pack 1200-1400 mah

I know the votage limitations on the servos.

All my boats are on 6v.

Yes the servos are rubber mounted as they would be in most instalations....
08-10-2009, 04:28 PM
Replies: 3
Views: 3,717
Posted By nlmbc

Angry Just found out that HiFLIGHT misplaces my package...

Just found out that HiFLIGHT misplaces my package sent to them.:flaming:

They never even entered it into there system, package signed for on June 2

After a week of phone calls they found...
Forum: Ask Hitec
08-10-2009, 04:04 PM
Replies: 10
Views: 2,511
Posted By nlmbc

I too have had alot of trouble with these servos...

I too have had alot of trouble with these servos this year.

Seven in total burnt out all used as throttle in gas boats.

Worst part is a bunch were sent out for service to the Canadian repair...
08-08-2009, 04:40 PM
Replies: 3
Views: 3,717
Posted By nlmbc

It is a motor issue as there is no stress on the...

It is a motor issue as there is no stress on the linkage.

Had another one burn out on me today in my gas mono. Have adjusted the epa to make sure servo is not over stroking.:eek:

As for water I...
Forum: RC Boating
08-02-2009, 03:37 PM
Replies: 8
Views: 2,814
Posted By nlmbc

look up capricorn boats as they made a version of...

look up capricorn boats as they made a version of that drive as well.

Alot less than the MHZ units.
Forum: RC Boating
08-02-2009, 03:34 PM
Replies: 4
Views: 916
Posted By nlmbc

Also check out IMPBA.com

Also check out IMPBA.com
Forum: RC Boating
08-02-2009, 03:31 PM
Replies: 3
Views: 927
Posted By nlmbc

they get you started. They are fun to run...

they get you started.

They are fun to run yet if speed is your thing and you can handle the higher sticker price get a custom boat from CC racing or other boat builders out there.

What ever you...
08-02-2009, 03:23 PM
Replies: 3
Views: 3,717
Posted By nlmbc

Angry servo burn out

Have been having the worst luck with ht225mg , ht225bb as well as ht645mg servos this year.

One boat has gone threw 3 of the 225mgs so far this year. Just built another boat and had the same issue...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service