R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: orcadigital
Showing results 1 to 25 of 500
Search took 0.05 seconds.
Forum: Racing Forum
06-18-2021, 11:55 AM
Replies: 332
Views: 40,953
Posted By orcadigital

Or maybe it's because our only track within 100...

Or maybe it's because our only track within 100 miles is only open a couple times a month for racing...

As to actual constructive conversation, I wonder how the liverc numbers are calculated. Is...
Forum: Racing Forum
06-18-2021, 11:42 AM
Replies: 26
Views: 3,843
Posted By orcadigital

I would say one of the largest barriers to RC...

I would say one of the largest barriers to RC racing in general is the cost. The primary thing I see as an issue with an RTR class is that, as has been stated, to move up to the next class, most of...
04-20-2021, 08:44 AM
Replies: 2
Views: 383
Posted By orcadigital

PM Sent

PM Sent
09-06-2019, 07:13 AM
Replies: 290
Views: 70,318
Posted By orcadigital

So the Serpent manual shows that inline battery...

So the Serpent manual shows that inline battery is for high traction and transverse is for low traction. The understanding F1 tuning thread states the opposite, that inline is for low traction. I...
08-29-2019, 06:23 AM
Replies: 290
Views: 70,318
Posted By orcadigital

So i have an SF2 which uses those pieces and it...

So i have an SF2 which uses those pieces and it would make sense that would be the method to change track width. Except those pieces are all the same length. So what is the method for changing...
08-28-2019, 07:51 AM
Replies: 290
Views: 70,318
Posted By orcadigital

The setup sheet shows 3 front track widths, but i...

The setup sheet shows 3 front track widths, but i dont see how the width is adjusted. Rebellion has the different width arms but it seems odd to be on the Serpent setup sheet needing an aftermarket...
05-29-2019, 07:37 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

From the picture, he is using the EZLap timer. ...

From the picture, he is using the EZLap timer. My club uses it as do i at my home track. Its quite economical, transponders are $20 and quite small, and there are several free software packages...
05-28-2019, 09:58 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

I picked the car up used a while back so I am not...

I picked the car up used a while back so I am not entirely sure if it is a pro or not. It does do MHS though. I was struggling a bit with my HFAY car at 94mm with ASF and brushed, and had build the...
05-24-2019, 05:20 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

Switching to the EVO was the single best change I...

Switching to the EVO was the single best change I have made for lap times. The car is night and day faster then my ASF cars and even my VE. None of my other cars have stacked FETS so that may be a...
05-22-2019, 06:07 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

I wired my EZLap directly to the wires going to...

I wired my EZLap directly to the wires going to the power switch on my stock car so it turns on and off with the car. The issue with the EZLap harness for the sport models that connects to the...
05-20-2019, 06:04 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

Can you clarify this? My experience using...

Can you clarify this?

My experience using EZLap transponders:

ASF - Plug and play w/4 pin connector
VE - Plug and play w/4 pin connector
EVO - Plug and play w/4 pin connector
RWD...
05-08-2019, 11:58 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

Unless you have a transponder hard wired in or...

Unless you have a transponder hard wired in or something else that would drain the batteries (like how the EZLap transponder wires into the RWD/Sport cars), I am not sure that you are necessarily...
05-08-2019, 06:34 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

EMU you know way more then me, but could it just...

EMU you know way more then me, but could it just be FETS? If it still has normal reverse, and I assume steering, and the issue is in forward, I wonder if replacing the forward FETS would fix it?
...
05-06-2019, 11:52 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

Both guys who have tried it out here, have it...

Both guys who have tried it out here, have it sitting in their parts boxes as well.
05-06-2019, 07:25 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

So just a note here. I have the Loco ICS...

So just a note here. I have the Loco ICS bluetooth programmer from PN. It works on the ASF cars both off the laptop (Kyosho software) and my android phone with the software linked from PN. The...
05-03-2019, 09:41 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

I looked for that after seeing your setup, but...

I looked for that after seeing your setup, but its out of stock everywhere. Might see if i can find a machinist to make some out of some brass plate using the PN one as a guide. It seems like the...
05-01-2019, 11:30 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

I'm definitely not there yet. I do like the Next...

I'm definitely not there yet. I do like the Next Level Timing software for practice as it focuses on consistent laps, but with changing layouts as often as we are for HFAY, I seem to always be...
04-29-2019, 06:00 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

Sorry, i mis-spoke. New front PN tires are 23...

Sorry, i mis-spoke. New front PN tires are 23 and change. Truing the mold lines and to a round tire usually takes it to 23.1-23.2. I have found issues with regular wheels going down to 22.3-22.4...
04-29-2019, 05:52 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

Ironically, your post and reasoning is why I do...

Ironically, your post and reasoning is why I do all my practice with a transponder. I find that i start to push the car more to the edge, and the lap times tend to increase accordingly as I get more...
04-26-2019, 04:22 AM
Replies: 1,437
Views: 171,298
Posted By orcadigital

Thats impressive with stock tires.

Thats impressive with stock tires.
04-24-2019, 09:45 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

I would estimate the fronts around 26/27mm. I...

I would estimate the fronts around 26/27mm. I run about the same on my LM EVO and no traction roll. My 98mm VE setup I am closer to the 22mm, but its more I got a little crazy with the truer. ...
04-12-2019, 10:46 AM
Replies: 6
Views: 7,307
Posted By orcadigital

On RCP Track, I have run the Kyosho LM high grip...

On RCP Track, I have run the Kyosho LM high grip tires with great success. This is with everything from a PN70T to a Kyosho XSpeed motor. The tires are very round and take some time to wear in but...
04-12-2019, 10:26 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

Thats very interesting. I guess i find without...

Thats very interesting. I guess i find without the standard adjustments that I have on the larger scales (primarily roll centers) that i need the wider wheels to keep traction rolling under check. ...
04-12-2019, 05:22 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

EMU, why don't you like a greater front offset? ...

EMU, why don't you like a greater front offset? I have found that i really like 2 front 3 rear and 3 front 3 rear. I find when i go narrower, especially when the tires are new I am much more...
04-01-2019, 05:40 AM
Replies: 7,384
Views: 1,384,371
Posted By orcadigital

I use the EZlap system. We use the same at the...

I use the EZlap system. We use the same at the track we race at, so I don't need to do anything different with transponders. The system is relatively inexpensive and the transponders are cheap. We...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.