R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: Still Bill
Showing results 1 to 25 of 500
Search took 0.13 seconds.
10-04-2020, 04:30 PM
Replies: 1
Views: 1,695
Posted By Still Bill

Motiv Pro 40 Amp Lipo Discharger

Motiv Pro 40 Amp Lipo Discharger that pairs up with a iCharger/Junsi Duo charger to create the ultimate battery conditioning system. Assembled in the USA using heavy duty components to withstand high...
06-19-2020, 09:51 AM
Replies: 2
Views: 517
Posted By Still Bill

Sorry. Sold to Vintage earlier.

Sorry. Sold to Vintage earlier.
06-18-2020, 07:11 PM
Replies: 3,819
Views: 1,068,448
Posted By Still Bill

For a carpet track, Associated really redesigned...

For a carpet track, Associated really redesigned the B6; so, I would go with the new B6.2 to keep up with the forthcoming setups from team drivers.

The builds of all the B6 buggies has been a very...
06-18-2020, 03:27 PM
Replies: 2
Views: 517
Posted By Still Bill

Sanwa RX-482 Receiver

SOLD Sanwa RX-482 2.4Ghz 4-Channel FHSS-4 SSL Telemetry Receiver with built-in antenna. Compatible with M17, M12, M12S, M12S-RS, Exzes Z/ZZ, MT-44 and MT-S transmitters. Used; but, in excellent...
03-19-2020, 01:07 PM
Replies: 1,159
Views: 409,599
Posted By Still Bill

Agreed here; however, I had previously melted the...

Agreed here; however, I had previously melted the fans in my two original dischargers when using them back-to-back to discharge 2S packs at 40A. So, I have my 406 DUO with Motiv discharger set to...
12-20-2019, 08:40 AM
Replies: 1,159
Views: 409,599
Posted By Still Bill

Look up Progressive RC. They did help me with an...

Look up Progressive RC. They did help me with an AMain purchase a couple years ago.
10-13-2019, 07:33 PM
Replies: 1,159
Views: 409,599
Posted By Still Bill

Just higher charge rates. Using both ports of...

Just higher charge rates. Using both ports of the charger for synchronous mode charging eliminates having a separate discharger to discharge at a higher rate.
07-25-2019, 10:47 PM
Replies: 3,819
Views: 1,068,448
Posted By Still Bill

Addicted...With the high traction carpet at 702...

Addicted...With the high traction carpet at 702 Raceway, I would think you should have gone with a B6.1 Team Kit which has a gear diff. I never could get a ball diff to hold up on a carpet track.
04-15-2019, 06:33 PM
Replies: 0
Views: 291
Posted By Still Bill

WGT Foam Tires

Have a few sets of unused World GT Foam Tires for sale as follows:
- Team CRC World GT Control Fronts #2300 (2 pair)
- Team CRC World GT Control Rears #2302 (1 pair)
- Jaco World GT Spec Fronts -...
03-04-2019, 07:42 PM
Replies: 3,819
Views: 1,068,448
Posted By Still Bill

Only six more to go...LOL

Only six more to go...LOL
Forum: Crawler Room
03-04-2019, 03:16 PM
Replies: 13
Views: 14,538
Posted By Still Bill

Have a quick question...Has anyone noticed the...

Have a quick question...Has anyone noticed the rear wheels on their TRX-4 having positive camber (about +1 degree)? I assume either the plastic rear axle housing is bowed or the portals have pivoted...
02-25-2019, 11:55 AM
Replies: 3
Views: 700
Posted By Still Bill

Hudy Metric Socket Drivers and Hex Wrench SOLD

SOLD Complete your collection of Hudy metric wrenches and socket drivers:

Hudy Socket Driver 5mm (never used)
Hudy Socket Driver 6mm (never used)
Hudy Hex Wrench 3mm (barely used)

SOLD
...
02-22-2019, 09:30 PM
Replies: 0
Views: 460
Posted By Still Bill

Hudy US Standard Hex Wrenches and Socket Drivers (Used)

SOLD One set of nine (9) Hudy US Standard Hex Wrenches (6) and Socket Drivers (3) as used on my CRC pan cars: SOLD

.050" x 60 mm Hex Tip
1/16" x 120 mm Hex Tip
5/64" x 120 mm Hex Tip
...
02-20-2019, 08:39 AM
Replies: 1,223
Views: 380,268
Posted By Still Bill

Yes, I am having the same issue with my new MC3...

Yes, I am having the same issue with my new MC3 17.5; however, my sensor variances are a tad higher.

Does appear that tightening the three screws for the timing is the issue. I can vary 2-3...
02-18-2019, 11:50 AM
Replies: 3,819
Views: 1,068,448
Posted By Still Bill

When using the aluminum rear hubs, I now put set...

When using the aluminum rear hubs, I now put set screws in all the unused holes to prevent dirt from getting inside the hub. My lubrication and bearings last a lot longer.
02-17-2019, 05:46 PM
Replies: 4
Views: 648
Posted By Still Bill

SOLD.

SOLD.
02-16-2019, 10:10 PM
Replies: 3,819
Views: 1,068,448
Posted By Still Bill

Had that problem. So, I don't use the smaller...

Had that problem. So, I don't use the smaller (outer diameter) spacers provided in the kit. Associated has larger (outer diameter) spacers (.5, 1.0, 2.0mm) that help ballstuds stay tighter. Still...
02-13-2019, 09:43 PM
Replies: 2
Views: 942
Posted By Still Bill

SOLD

SOLD
02-13-2019, 05:53 PM
Replies: 2
Views: 522
Posted By Still Bill

Ahhhhh...I did not know it was you. Already...

Ahhhhh...I did not know it was you.

Already sold it earlier today.

Only thing left for sale at this point is my CRC WGT-R 1/10th scale car; but, its class is no longer supported anywhere in the...
02-12-2019, 09:05 PM
Replies: 2
Views: 522
Posted By Still Bill

SOLD. Set-Up System for Pan Cars 1/10 & 1/12 - SOLD

SOLD. Hudy Universal Exclusive Set-Up System for 1/10 & 1/12 Pan Cars P/N #10-9405. SOLD

Accurately checks for Toe, Caster, Camber and Steering Throw Symmetry at front end of any pan car.

Works...
02-12-2019, 08:48 PM
Replies: 1
Views: 471
Posted By Still Bill

KO Propo KR-413FH Receivers (2) SOLD

SOLD. Two (2) KO Propo KR-413FH Receivers. The KR-413FH is a 2.4 GHz FHSS 4-Channel Receiver.

Weight: 7.5 gm
Input Voltage: 4.8-7.4V
Quick binding
Fail safe function
Gold plated pins
...
02-06-2019, 10:04 PM
Replies: 2
Views: 942
Posted By Still Bill

CRC World GT-R/T Car SOLD

SOLD

CRC World GT-R/T car with servo, ESC, motor and upgrades including the following parts and estimated list pricing:
- CRC World GT-R/T kit $250
- KO Propo RSX12 steering servo $95
-...
02-04-2019, 09:58 AM
Replies: 3,819
Views: 1,068,448
Posted By Still Bill

3M double sided permanent tape. Comes precut in...

3M double sided permanent tape. Comes precut in little 1" squares in a package with three sheets. I usually get it at Home Depot or Lowes.

Hold down all my electronics with this tape.
02-01-2019, 11:08 AM
Replies: 3,819
Views: 1,068,448
Posted By Still Bill

First, drive it as-is; and, then decide where it...

First, drive it as-is; and, then decide where it needs the weight to help with front steering, rear traction and/or attack angle on jumps. Weight it to suit YOUR style of driving and track...
02-01-2019, 10:37 AM
Replies: 9
Views: 1,613
Posted By Still Bill

Yep. This is the car that I loaned to Scotty...

Yep. This is the car that I loaned to Scotty Ernst for the 2018 IIC. And he beat me with my newer CRC WGT-R/T car by one position. LOL
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.