R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 9
1
2
3
Last »
Search: Posts Made By: aaron_buran
Showing results 1 to 25 of 206
Search took 0.02 seconds.
Forum: Electric Off-Road
12-15-2013, 02:18 PM
Replies: 4,174
Views: 973,306
Posted By aaron_buran

Shorty 4S Battery

Hi all,

I bought some Spec Point Concepts 4S shorty packs, they are great. ~420 grams, 4500mAh, 70C.

Great for racing your 3.0E Indoor's.

Check em out on their website if your interested.
Forum: Electric Off-Road
10-10-2013, 04:33 PM
Replies: 4,174
Views: 973,306
Posted By aaron_buran

Casper and Hacker, Where are you get the...

Casper and Hacker,

Where are you get the lightweight hardware from?

Also when your running the lighter package what oil and spring are you running?
Forum: Electric Off-Road
09-14-2013, 07:56 PM
Replies: 4,174
Views: 973,306
Posted By aaron_buran

Shorty Packs

Hi Ryan -

Who's shorty packs are you running?

Thanks,

Aaron
Forum: Electric Off-Road
02-27-2013, 12:55 PM
Replies: 9,438
Views: 1,575,813
Posted By aaron_buran

Body mounts

I have a nice new body done up, are the mounts different on the 2.0? Should I save it?

Thx,

-A
Forum: Nitro Off-Road
05-19-2012, 11:42 AM
Replies: 14,693
Views: 1,443,025
Posted By aaron_buran

Ofna dog bones

I saw a factory guy last weekend running ofna dog bones and axles in the rear instead of cvd's, anybody know what part numbers I need to do this?

Thx

-A
Forum: Electric Off-Road
04-17-2011, 08:45 AM
Replies: 21,236
Views: 3,151,816
Posted By aaron_buran

Is there another wheel that I can buy now... via...

Is there another wheel that I can buy now... via Horizon, that will work on this car?

Thx,

-A
Forum: Nitro On-Road
08-30-2010, 05:16 AM
Replies: 238
Views: 33,190
Posted By aaron_buran

Nice job Paul, congrats!

Nice job Paul, congrats!
Forum: Electric On-Road
12-01-2009, 11:39 AM
Replies: 1,259
Views: 190,043
Posted By aaron_buran

I use a small 2 cell lipo pack, direct into the...

I use a small 2 cell lipo pack, direct into the rx, no regulator.
Forum: Electric On-Road
12-01-2009, 04:16 AM
Replies: 1,259
Views: 190,043
Posted By aaron_buran

Yes, CRC should have hard pink's publically...

Yes, CRC should have hard pink's publically available soon, standard pinks are very close, hard pinks are much like the Jaco Magenta, same shore as pink, but the cells of the foam are tighter, and...
Forum: Electric On-Road
11-30-2009, 06:12 PM
Replies: 1,259
Views: 190,043
Posted By aaron_buran

Buran's Gen X Setup 1.12th Mod

.50 fronts
5 degree blocks
30,000wt lube on the kingpins
Upper brace long arm, lower carbon brace w/ center cut out
all shims back (max caster) 8 degrees
.25 degrees camber
servo up
CRC...
Forum: Electric On-Road
11-15-2009, 08:04 AM
Replies: 1,259
Views: 190,043
Posted By aaron_buran

To tweak the car, as Ian says the front droop has...

To tweak the car, as Ian says the front droop has to be equal. With the the car setup with fresh equal size tires, motor, bettery etc, you should see about the same amount of visible kinpin above...
Forum: Electric On-Road
11-12-2009, 05:56 AM
Replies: 1,259
Views: 190,043
Posted By aaron_buran

I use Kyosho silicone diff oil in my tubes I...

I use Kyosho silicone diff oil in my tubes

I prefer the graphite horns on the sterring blocks over the plastic ones that come with the new XL, I think the steering geometry is better for me. ...
Forum: Electric On-Road
11-10-2009, 06:12 PM
Replies: 1,259
Views: 190,043
Posted By aaron_buran

The sides don't matter on the damper tubes, I...

The sides don't matter on the damper tubes, I wanted to achieve 15k (of which I didn't have), and I had 20 in them already, so I just changed 1 tube to 10k. :sneaky:
Forum: Electric On-Road
11-10-2009, 05:27 PM
Replies: 1,259
Views: 190,043
Posted By aaron_buran

Here is my XL setup from the Halloween Classic: ...

Here is my XL setup from the Halloween Classic:

.50 fronts
10 degree blocks
20,000wt lube on the kingpins
no upper brace long arm
all shims back (max caster)
.5 degrees camber
servo up
CRC...
Forum: Nitro On-Road
10-05-2009, 05:04 AM
Replies: 1,002
Views: 211,763
Posted By aaron_buran

Yes, I ran the entire Mugen clutch.

Yes, I ran the entire Mugen clutch.
Forum: Nitro On-Road
07-17-2009, 05:04 AM
Replies: 1,002
Views: 211,763
Posted By aaron_buran

The bulkhead molds for the front and rear don't...

The bulkhead molds for the front and rear don't appear to have changed, although for some reason my side belt is tighter with the stand gear ratio, so the layshaft may be closer to the rear axle,...
Forum: Nitro On-Road
07-16-2009, 05:50 PM
Replies: 1,002
Views: 211,763
Posted By aaron_buran

dameetz - Shimo and Lamberto were both running...

dameetz - Shimo and Lamberto were both running the EVO car, Shimo's evo setup is posted on Kyosho.com, I run JR 8800S's, however they have been recently discontinued, not sure what I will be running...
Forum: Nitro Off-Road
05-26-2009, 06:11 AM
Replies: 545
Views: 67,818
Posted By aaron_buran

Hi Adam, I have a couple questions for you: ...

Hi Adam, I have a couple questions for you:

1.) This past weekend I had a re-occuring problem, if I overshot the landing on a jump and landed hard the car would flame out. I checked the clutch...
Forum: Nitro Off-Road
04-27-2009, 05:43 PM
Replies: 580
Views: 115,412
Posted By aaron_buran

I was in Medina the last 2 weekends. The...

I was in Medina the last 2 weekends.

The first weekend I ran the standard diffs and had decent results. Went back to the track and A/B'd the smart diffs again in practice prior to last...
Forum: Nitro Off-Road
04-13-2009, 07:07 PM
Replies: 580
Views: 115,412
Posted By aaron_buran

Me either, but I have actually had some fun...

Me either, but I have actually had some fun lately doing something different. :D
Forum: Nitro Off-Road
04-13-2009, 05:58 PM
Replies: 545
Views: 67,818
Posted By aaron_buran

Adam, one other question. I have been...

Adam, one other question.

I have been running the Truhe setup since I purchased the car, and other than trying the smartdiff, and different tires and inserts, what other advice can you offer to...
Forum: Nitro Off-Road
04-13-2009, 05:50 PM
Replies: 545
Views: 67,818
Posted By aaron_buran

Hi Adam, I posted this on the smart diff thread,...

Hi Adam, I posted this on the smart diff thread, but I am not sure you would see it there, let me know your toughts please:

I have only tried the center and here is what I have seen. I am a little...
Forum: Nitro Off-Road
04-13-2009, 05:48 PM
Replies: 580
Views: 115,412
Posted By aaron_buran

Ok, here is my feedback on the smartdiff, I have...

Ok, here is my feedback on the smartdiff, I have only tried the center and here is what I have seen. I am a little new to off-road, but have been racing on-road longer than I'd like to admit. I...
Forum: Nitro On-Road
07-28-2008, 11:27 AM
Replies: 327
Views: 31,698
Posted By aaron_buran

If anyone running an M3 needs setup help please...

If anyone running an M3 needs setup help please see me at the track.
Forum: Nitro On-Road
07-28-2008, 10:06 AM
Replies: 327
Views: 31,698
Posted By aaron_buran

I also made a couple of changes to my car that...

I also made a couple of changes to my car that contributed to the higher than normal tire wear. I suspect my wear could/should have been better, that track was the fastest it had been all year.
Showing results 1 to 25 of 206
 
Page 1 of 9
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.