R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: geeunit1014
Showing results 1 to 25 of 500
Search took 0.12 seconds.
09-23-2022, 08:16 AM
Replies: 1,142
Views: 235,137
Posted By geeunit1014

I think if you update the firmware for the box,...

I think if you update the firmware for the box, then it will work with the esc. Depending what firmware version your box is, if the esc has a newer version than the card, that could be why it won’t...
09-22-2022, 10:00 AM
Replies: 1,142
Views: 235,137
Posted By geeunit1014

I would make sure the throttle and brake...

I would make sure the throttle and brake endpoints are set at 100%. You say it accepted throttle/brake, so it did go into calibration but now there is some other error? If the setup box is not...
09-19-2022, 08:12 AM
Replies: 58
Views: 4,646
Posted By geeunit1014

If anyone is looking to split a hotel, pm me

If anyone is looking to split a hotel, pm me
08-31-2022, 02:39 PM
Replies: 1,450
Views: 318,252
Posted By geeunit1014

The v2 is thicker in the middle. The part number...

The v2 is thicker in the middle. The part number did not change so some websites may not have updated the picture
08-20-2022, 06:12 AM
Replies: 58
Views: 4,646
Posted By geeunit1014

Full post w/ class rules from Facebook: ...

Full post w/ class rules from Facebook:

Registration is now open for the 2022 ROAR Electric Onroad Paved Nationals to be held at Valkaria RC Raceway in Valkaria, FL.

The event will feature...
08-09-2022, 08:17 AM
Replies: 58
Views: 4,646
Posted By geeunit1014

Entries are not open yet. I would expect them to...

Entries are not open yet. I would expect them to open in a week or 2. Roar will announce when they are open, and they should be open up until 2 weeks before the race
08-07-2022, 09:37 AM
Replies: 1,450
Views: 318,252
Posted By geeunit1014

I would not put any oil, it will attract dust and...

I would not put any oil, it will attract dust and debris that could bind the arm. I would check you didn’t get a little piece of material dislodged when you pushed the ball into the arm

The rear...
06-19-2022, 10:23 AM
Replies: 1,450
Views: 318,252
Posted By geeunit1014

Do you have a setup sheet? We could make more...

Do you have a setup sheet? We could make more accurate suggestions that way. If it’s only at speed it may be the body, that body is not particularly popular. Best options are the pzero, bwoah or the...
06-03-2022, 10:12 AM
Replies: 557
Views: 55,892
Posted By geeunit1014

You could run a topdeck on the Awesomatix as well

You could run a topdeck on the Awesomatix as well
04-04-2022, 07:30 PM
Replies: 1,450
Views: 318,252
Posted By geeunit1014

The horn should be perpendicular to the link to...

The horn should be perpendicular to the link to make the same mechanical throw both ways.
03-22-2022, 01:49 PM
Replies: 5
Views: 566
Posted By geeunit1014

The weight balance of the cars is designed with...

The weight balance of the cars is designed with the esc behind the motor. Unless you want an extreme front weight distribution, behind the motor is better.
03-15-2022, 10:15 AM
Replies: 1,450
Views: 318,252
Posted By geeunit1014

The loaded answer to the loaded question is, if...

The loaded answer to the loaded question is, if you want the car to rotate hard on power, Robbie’s setup is probably more ideal, whereas if if you want the car to steer more with the input of the...
02-17-2022, 12:00 PM
Replies: 1,450
Views: 318,252
Posted By geeunit1014

There is not. IMO, the camber gain adjustment by...

There is not. IMO, the camber gain adjustment by moving the upper link a couple mm is not super significant, and unless everyone was compensating the shims every time the link moved probably had more...
02-14-2022, 10:53 AM
Replies: 1,450
Views: 318,252
Posted By geeunit1014

The new wheels are 10-12 grams lighter for the...

The new wheels are 10-12 grams lighter for the set, so I would expect them to be different. Normally lighter wheels are more agile than heavier ones
12-17-2021, 01:26 PM
Replies: 134
Views: 16,034
Posted By geeunit1014

Hard to argue. Karl comes out of retirement, wins...

Hard to argue. Karl comes out of retirement, wins roar title, leaves, refuses to elaborate
12-09-2021, 08:42 AM
Replies: 1,450
Views: 318,252
Posted By geeunit1014

In my experience with the amx (same size bearing)...

In my experience with the amx (same size bearing) stock bearings will fail quickly, but the aura bearings hold up much better, I expect the x4 to be the same way
11-21-2021, 05:19 AM
Replies: 1,450
Views: 318,252
Posted By geeunit1014

Having seen many bent upper bulkhead clamps in a...

Having seen many bent upper bulkhead clamps in a past life, I think most likely one of the screws may have been loose. This makes bending that part extremely easy, especially in the middle of part as...
10-20-2021, 06:04 AM
Replies: 1,240
Views: 308,770
Posted By geeunit1014

There are optional hexes, 4, 4.5 and 5mm

There are optional hexes, 4, 4.5 and 5mm
10-18-2021, 05:54 AM
Replies: 1,240
Views: 308,770
Posted By geeunit1014

Haven’t tried them yet… supposed to get them this...

Haven’t tried them yet… supposed to get them this week I think, should be able to try them next weekend
10-17-2021, 08:47 AM
Replies: 1,240
Views: 308,770
Posted By geeunit1014

The way the “shock towers” are on the mtc2 make...

The way the “shock towers” are on the mtc2 make it easier to implement this, traditional shock towers on a buggy would probably take a bit of redesign on the diff cases to make it work.. and in 1:8...
10-04-2021, 10:37 AM
Replies: 1,240
Views: 308,770
Posted By geeunit1014

I don’t think you would have to change anything....

I don’t think you would have to change anything. More of a see how the change affects the car and your driving and work from there
10-04-2021, 09:08 AM
Replies: 1,240
Views: 308,770
Posted By geeunit1014

I am not sure exactly, I believe they are...

I am not sure exactly, I believe they are shipping now that they have been announced, so it may be a couple weeks. Mugen normally posts on Facebook when shipments get in.



We will have to test...
10-02-2021, 06:16 PM
Replies: 1,240
Views: 308,770
Posted By geeunit1014

Its definitely an option, I was actually testing...

Its definitely an option, I was actually testing that again today. The stock top deck is less agile, and the rear is a little more in the track than the rcmaker 1.6mm split top decks. The grip would...
09-30-2021, 05:06 PM
Replies: 1,240
Views: 308,770
Posted By geeunit1014

The flex will depend on your track and...

The flex will depend on your track and conditions. You can see the settings on my nats setup sheet, which was high grip. And then this past weekend in low grip I removed the rear top deck motor mount...
09-30-2021, 02:56 PM
Replies: 1,240
Views: 308,770
Posted By geeunit1014

You only need the smaller spur if gearing is an...

You only need the smaller spur if gearing is an issue. For asphalt I do prefer the stock top deck, it has more overall traction than split decks.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.