Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: Eivind E
Showing results 1 to 25 of 500
Search took 0.62 seconds.
07-30-2018, 01:20 PM
Replies: 1,933
Views: 269,653
Posted By Eivind E

Adrien Bertin silicones the engines. He siliconed...

Adrien Bertin silicones the engines. He siliconed the one he rebuilt me at the EFRA Euros 2017. This engine has since had the best idle of any Orion I ever had, hence I recommend this practice to...
07-28-2018, 03:52 PM
Replies: 1,933
Views: 269,653
Posted By Eivind E

You have an air leak, this is not so unusual. The...

You have an air leak, this is not so unusual. The cure for these Orions is high temperature resistant silicone around the carb neck to crankcase, and where the carburettor boot attaches onto the carb...
07-05-2018, 12:31 PM
Replies: 703
Views: 202,123
Posted By Eivind E

They donít push the pin far enough in at the...

They donít push the pin far enough in at the factory.
For the last few years Iíve been using a vice to push pins further in.

Not being pushed in enough risks them falling out during use.
12-03-2016, 12:24 PM
Replies: 2,823
Views: 526,723
Posted By Eivind E

Protek Losi LRP

Protek Losi
LRP
11-26-2016, 08:38 AM
Replies: 10
Views: 841
Posted By Eivind E

It was a gimmick

It was a gimmick
11-25-2016, 02:40 PM
Replies: 251
Views: 80,826
Posted By Eivind E

It wouldn't have any overheating issues as it's...

It wouldn't have any overheating issues as it's probably very cold at Padova right now.
11-24-2016, 09:19 PM
Replies: 3
Views: 537
Posted By Eivind E

I have a theory on why this is going on. A...

I have a theory on why this is going on.

A guy at my local club had this.
Basicly if you set the initial servo horn setting wrong, so that the horn is in fact not straight, then that has a knock...
11-21-2016, 11:47 AM
Replies: 2,823
Views: 526,723
Posted By Eivind E

It hasn't changed since the 812 version. But they...

It hasn't changed since the 812 version. But they also make it for other brand cars, I think..
11-21-2016, 07:00 AM
Replies: 2,823
Views: 526,723
Posted By Eivind E

I like the Jconcepts body, it's nice. Especially...

I like the Jconcepts body, it's nice. Especially for the +4 chassis. The type R, because of the slope on the rear, sits lower on the back with the +4.
The Jconcepts body sits better with the longer...
11-16-2016, 02:59 PM
Replies: 906
Views: 232,990
Posted By Eivind E

Modelcars Reading Answer RC

Modelcars Reading
Answer RC
11-11-2016, 06:35 AM
Replies: 14
Views: 2,217
Posted By Eivind E

well, if you are serious about that, then you...

well, if you are serious about that, then you probably already know that the best drivers in Denmark, like Culmsee, Fischer, they all drive HB D815.
11-10-2016, 08:33 AM
Replies: 2,823
Views: 526,723
Posted By Eivind E

That would do it! if you omit the spacer, things...

That would do it! if you omit the spacer, things will go badly
11-10-2016, 07:20 AM
Replies: 2,823
Views: 526,723
Posted By Eivind E

"everybody" runs it, and we aren't breaking any...

"everybody" runs it, and we aren't breaking any spur gears.

The guy just said his spur gear was rubbing on the sides of the chassis, I don't even know what that means, but I tried to ask for...
11-08-2016, 07:37 AM
Replies: 2,823
Views: 526,723
Posted By Eivind E

why don't you take a few pictures of your centre...

why don't you take a few pictures of your centre diff mount, chassis, spur gear, how the engine sits in there, etc.
11-08-2016, 07:13 AM
Replies: 2,823
Views: 526,723
Posted By Eivind E

No. Most likely something else is causing your...

No. Most likely something else is causing your issue. Probably something like not setting gear mesh right, or clutch bell bearings.
11-07-2016, 12:37 PM
Replies: 8
Views: 2,674
Posted By Eivind E

The number one thing is run a good fuel. If you...

The number one thing is run a good fuel. If you run Byrons it leaves a healthy ammount of oil.

Some other fuels don't have enough castor oil, and have only synthetic oil. Those fuels will not...
11-06-2016, 02:00 AM
Replies: 599
Views: 64,509
Posted By Eivind E

OK soooo.. I just read a post on the facebook...

OK soooo.. I just read a post on the facebook about the recent EFRA AGM
And apparently it says "modified" for 1/12 is now 6.5T motor and blinky..
And according to them, 1/12 in the rest of the...
11-01-2016, 05:03 PM
Replies: 1
Views: 165
Posted By Eivind E

want: Turbomatcher, Competition Electronics

looking for an old CE Turbomatcher, any version
10-26-2016, 06:35 PM
Replies: 37
Views: 6,552
Posted By Eivind E

Does it only count when OS wins the championship?...

Does it only count when OS wins the championship?
Team Orion won this championship. Fair and square. Orion are world champion.
10-26-2016, 04:43 PM
Replies: 12
Views: 3,184
Posted By Eivind E

The Ronnefalk engine is different, it has an...

The Ronnefalk engine is different, it has an improved crankcase.
The other one is the previous model, which I have run and I was happy running that one too. For me the newer crank case tunes better....
10-26-2016, 03:31 PM
Replies: 37
Views: 6,552
Posted By Eivind E

2016 world champion engine is Team Orion.

2016 world champion engine is Team Orion.
10-26-2016, 03:30 PM
Replies: 49
Views: 8,321
Posted By Eivind E

2016 world champion engine is Team Orion

2016 world champion engine is Team Orion
10-26-2016, 01:50 PM
Replies: 12
Views: 3,184
Posted By Eivind E

Engine is great, good smooth controllable power...

Engine is great, good smooth controllable power delivery, low fuel consumption, yet good top speed down the straight.
10-23-2016, 02:14 PM
Replies: 37
Views: 6,552
Posted By Eivind E

Team Orion are world champions

Team Orion are world champions
10-21-2016, 10:53 AM
Replies: 2,823
Views: 526,723
Posted By Eivind E

no, HB prototype tower

no, HB prototype tower
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service