R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: gatorage
Showing results 1 to 25 of 192
Search took 0.05 seconds.
08-06-2015, 11:40 AM
Replies: 16
Views: 1,283
Posted By gatorage

best thing to do is throttle EPA % if you have....

best thing to do is throttle EPA % if you have. if they are real new start with 20% if it had a mod motor. let them run around 5 lap in the groove/race line if they can hold it in the groove move it...
07-15-2015, 10:39 PM
Replies: 21
Views: 6,662
Posted By gatorage

i never run MM set-up but 2wd SCT RM set-up on...

i never run MM set-up but 2wd SCT RM set-up on the faster/bigger jumps out door tracks you need to run the battery up front. the body make too much uplift. so i dont think RM in SCT has an advantage...
07-02-2015, 10:19 AM
Replies: 3
Views: 426
Posted By gatorage

well ball diffs!!! there always in contact with...

well ball diffs!!! there always in contact with the gear... try it for yourself take a ball diff and grab the gear and one out-drive (then move the other out-drive back in forth) you will see almost...
06-28-2015, 12:48 AM
Replies: 15
Views: 2,470
Posted By gatorage

Mantis Toboggan how can you cancel out battery if...

Mantis Toboggan how can you cancel out battery if his battery melts the plug and someone else battery runs ok? how you know what same size is? this tells me one might be his C rate is lower and make...
06-27-2015, 07:14 PM
Replies: 1
Views: 474
Posted By gatorage

well weight can help in the jump but a buggy run...

well weight can help in the jump but a buggy run skinny tires and will overload the tires easy even with stock weight so it will make it push in the turns. if you want a push it might help.
2nd you...
06-26-2015, 06:10 PM
Replies: 15
Views: 2,470
Posted By gatorage

1/8 run a lot less current but still is the wire...

1/8 run a lot less current but still is the wire hot where it come out the battery... if so it could be your running too low of a discharge rate/C rate. if you have good C rate then is the wire...
06-18-2015, 12:43 AM
Replies: 1
Views: 379
Posted By gatorage

the first pic the truck on the left look to be a...

the first pic the truck on the left look to be a MF1... the one in the middle look like a MF1... the one on the right (with the motor)look like it's not a true MF1... the rear shock dont have the...
06-05-2015, 10:31 PM
Replies: 391
Views: 32,741
Posted By gatorage

no i'm talking forward lay down servo so you have...

no i'm talking forward lay down servo so you have more room to put equipment behind it. it could be stand up (like the tekno sct410) but laydown you can mount the receiver on top of it (if no room)...
06-04-2015, 03:10 AM
Replies: 5
Views: 1,206
Posted By gatorage

so your saying the all the linkage moves but the...

so your saying the all the linkage moves but the wheel does not (all at the same time)??? if so the only think it could be if the screw came out the link.

or is it that the car stop turning to...
06-01-2015, 06:22 PM
Replies: 14
Views: 871
Posted By gatorage

well on amain the Mugen Seiki MBX7R has more...

well on amain the Mugen Seiki MBX7R has more sell, it's newer and lower price than the Losi. does not always = better but is a real good stats. Tekno has a newer EB48SL which could be the new wave...
06-01-2015, 02:28 AM
Replies: 391
Views: 32,741
Posted By gatorage

nice looking truck!!! their a few thing that i...

nice looking truck!!! their a few thing that i would do different in the layout but as a whole look well done... the thing that would be different in my build would be laydown servo (like on the s10...
05-30-2015, 09:18 PM
Replies: 9
Views: 1,982
Posted By gatorage

with the sc10 4x4!!! it has too much weight in...

with the sc10 4x4!!! it has too much weight in the rear and the weight sit low in the rear so it does not get on top the rear tire as well (so the weight just make it spin if you going too fast and...
05-30-2015, 07:11 PM
Replies: 17
Views: 1,972
Posted By gatorage

there is no right buggy only wrong buggy!!! all...

there is no right buggy only wrong buggy!!! all the top buggy are about the same. i would buy a old buggy first and get the electronics you need first since all the buggy take about the same...
05-30-2015, 06:16 PM
Replies: 6
Views: 439
Posted By gatorage

each motor not the same even if it has the same...

each motor not the same even if it has the same part number so there really know way to help for the right gear.... but i try to get the biggest spur i can get! then i tune with pinion (this will...
05-30-2015, 10:36 AM
Replies: 12
Views: 3,250
Posted By gatorage

well it is highly unlikely that you will have a...

well it is highly unlikely that you will have a lipo fire in place that is room temp/the battery not in use and it's keep at the right volt... i would worry more about your dryer!!! still scene it is...
05-19-2015, 11:12 AM
Replies: 12
Views: 689
Posted By gatorage

not sure what type of car your running or how...

not sure what type of car your running or how deep it is till you get to the hard pack???how it sounds you need something like Panther Boa (it's like a bow tie with much more side bite less forward...
03-06-2015, 01:14 AM
Replies: 8
Views: 805
Posted By gatorage

already been said kinda... but converting a 1/10...

already been said kinda... but converting a 1/10 SC would most likely be the best way. the spec are within 10mm on wheelbase and width. and the 1/10 SC are built to run on 2s... if you try to run a...
03-03-2015, 10:07 PM
Replies: 17
Views: 11,886
Posted By gatorage

you should be ok you front tire should be harder...

you should be ok you front tire should be harder and narrower vs you rear being softer and wide. the pressure of weight to the ground is about the same so it should handle about the same in the turns...
03-03-2015, 03:35 PM
Replies: 17
Views: 11,886
Posted By gatorage

i'am a little confused on this one... but i try...

i'am a little confused on this one... but i try to help you need a rim with a 12mm hex to work unless you have some type adapters. 2wd slash has a different off-set from front to rear. i forget but i...
03-01-2015, 11:39 PM
Replies: 118
Views: 33,391
Posted By gatorage

run bigger shock lol... but before the new big...

run bigger shock lol... but before the new big shocks i would put higher weight oil in. different types/brand of oil should for sure change. i think that angle of the shock might have effect on...
03-01-2015, 09:47 PM
Replies: 118
Views: 33,391
Posted By gatorage

no is said same track and for a 1/10 scale car vs...

no is said same track and for a 1/10 scale car vs 1/8 on same track. so to scale! the track is more inconsistent as a %... i run much lighter oil in 1/10 scale car so it moves around a lot more and...
03-01-2015, 05:55 PM
Replies: 118
Views: 33,391
Posted By gatorage

still i like emulsion most the time for 1/10......

still i like emulsion most the time for 1/10... the reason is inconsistent fit the track. i can run a lighter oil and not bottom out from the shock or over rebound from the spring. kinda like having...
03-01-2015, 09:33 AM
Replies: 16
Views: 1,119
Posted By gatorage

yes it funny how that works. 2wd is much harder...

yes it funny how that works. 2wd is much harder to drive on slippery track but they make the the beginner class 2wd. it funny to watch all of them spinning out but it make a lot of new racers quit....
02-28-2015, 11:53 AM
Replies: 16
Views: 1,401
Posted By gatorage

well .060 is a little over 1.5mm and .090 is a...

well .060 is a little over 1.5mm and .090 is a little under 2.3mm it will get you in the ballpark(which most of the time all you need) but Davidka ways is a homerun if your trying to replicate!!!
02-28-2015, 09:37 AM
Replies: 16
Views: 1,401
Posted By gatorage

here some more set-ups...

here some more set-ups http://www.tlracing.com/Products/Default.aspx?ProdId=LOSA0030#prodSetups ... i think Brian Kinwalds Worlds setup is the standard box setup
Showing results 1 to 25 of 192
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.