Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: Quad Racer 34
Showing results 1 to 25 of 500
Search took 1.95 seconds.
01-20-2015, 06:21 AM
Replies: 3,780
Views: 758,332
Posted By Quad Racer 34

TLR3510 I felt that the OD gear gave some more...

TLR3510
I felt that the OD gear gave some more on power steering, maybe a little less mid corner. The OD gear helps a lot on loose and blown out tracks. It allows the front end to pull the car more...
10-17-2014, 08:13 PM
Replies: 3,780
Views: 758,332
Posted By Quad Racer 34

As much grip as the worlds track had, the wider...

As much grip as the worlds track had, the wider chassis and stability that it provides, most likely wasn't needed.

A wider chassis like that would be more beneficial over here on tracks that blow...
07-20-2014, 01:09 PM
Replies: 3,780
Views: 758,332
Posted By Quad Racer 34

Have you tried replacing the bladders?

Have you tried replacing the bladders?
05-02-2014, 05:40 PM
Replies: 2,912
Views: 721,308
Posted By Quad Racer 34

The ETA is 5/29

The ETA is 5/29
04-21-2014, 05:15 PM
Replies: 3,780
Views: 758,332
Posted By Quad Racer 34

Matt, When I was at dirt burners last summer...

Matt,

When I was at dirt burners last summer for the os futaba nitro challenge I really liked AKA soft Impacts. It was really hot outside so depending on the temperature now, super softs may work....
04-14-2014, 05:24 PM
Replies: 1,470
Views: 244,456
Posted By Quad Racer 34

Frank posted a while back that there is no plan...

Frank posted a while back that there is no plan for an e specific truggy kit. TLR has an e conversion kit for the 2.0 buggy/truggy which also works on the 3.0.
03-04-2014, 03:19 PM
Replies: 3,780
Views: 758,332
Posted By Quad Racer 34

For a rough blown out track, you would want to...

For a rough blown out track, you would want to run the taper UP (^) This position will soak up the bumps better. But, keep in mind, if there are big jumps, the car will bottom out easier because...
02-11-2014, 06:00 AM
Replies: 1,470
Views: 244,456
Posted By Quad Racer 34

The truck comes stock with a hrc front rear block...

The truck comes stock with a hrc front rear block and a lrc rear rear block. With the stock setup that gives you 4deg of anti squat with the 1up pill in the front rear block.
02-10-2014, 07:06 PM
Replies: 1,470
Views: 244,456
Posted By Quad Racer 34

To be completely honest with you, I didn't even...

To be completely honest with you, I didn't even notice he had HRC checked on that setup sheet. I'm running LRC and the truck feels great.

In order to achieve HRC, you would need to get the...
02-09-2014, 07:16 PM
Replies: 1,470
Views: 244,456
Posted By Quad Racer 34

I'm running Drake's setup and I'm digging it....

I'm running Drake's setup and I'm digging it. It's very easy to drive and the truck works great everywhere. I built the truck with his setup so I didn't get a chance to try the stock setup. I don't...
02-05-2014, 04:53 AM
Replies: 4,170
Views: 847,133
Posted By Quad Racer 34

Tlr242001 is the front center dog bone for the...

Tlr242001 is the front center dog bone for the nitro car.

TLR242002 is the front center dog bone for the E car, which is the same length bone as the nitro rear.
01-29-2014, 05:17 PM
Replies: 3,780
Views: 758,332
Posted By Quad Racer 34

I'm pretty sure that one does not fit. This one...

I'm pretty sure that one does not fit. This one does though.
http://www.horizonhobby.com/products/DYN1419?cm_mmc=BrandSiteReferral-_-VTR-_-ProductPage-_-DYN1419
01-11-2014, 08:59 PM
Replies: 1,470
Views: 244,456
Posted By Quad Racer 34

They are supposed to ship on the 17th of this...

They are supposed to ship on the 17th of this month according to fast serve.
01-01-2014, 05:26 PM
Replies: 12,804
Views: 2,002,184
Posted By Quad Racer 34

You can get the weight of the battery further...

You can get the weight of the battery further back. It also allows for more chassis flex therefore creating more traction on looser tracks.
01-01-2014, 10:59 AM
Replies: 12,804
Views: 2,002,184
Posted By Quad Racer 34

I believe the specs are the same. One...

I believe the specs are the same.


One thing ive changed for a high speed, high bite track (ohio rc factory) is 30wt front amd 27.5wt rear.
01-01-2014, 10:56 AM
Replies: 12,804
Views: 2,002,184
Posted By Quad Racer 34

Oops. 1.6x2 22.5wt. I added that to my original...

Oops. 1.6x2 22.5wt. I added that to my original post.
01-01-2014, 10:15 AM
Replies: 12,804
Views: 2,002,184
Posted By Quad Racer 34

My rx is on its side next to the battery on the...

My rx is on its side next to the battery on the left side of the car, behind the battery hold down post. I just ran my wiresalong the side pod.
01-01-2014, 08:54 AM
Replies: 12,804
Views: 2,002,184
Posted By Quad Racer 34

Tony, I run on medium and high bite tracks with...

Tony, I run on medium and high bite tracks with this setup. A lot of guys here in ohio have tried it and really like it. I wasnt a fan of the other setups posted online so Another local TLR driver,...
01-01-2014, 05:59 AM
Replies: 3,780
Views: 758,332
Posted By Quad Racer 34

The radio tray screws are the correct length. No...

The radio tray screws are the correct length. No problem there. I just built a new kit a month ago and all the screws that were in the kit are the correct length.

For the front bulkhead screws,...
01-01-2014, 05:37 AM
Replies: 12,804
Views: 2,002,184
Posted By Quad Racer 34

It depends on the track conditions and what tire...

It depends on the track conditions and what tire it is. For indoor high bite tracks I prefer the closed cell inserts mainly because it smooths out the steering and doesnt make the car so agressive....
12-31-2013, 04:37 AM
Replies: 8,894
Views: 1,545,966
Posted By Quad Racer 34

They are saying the same release date still....

They are saying the same release date still. Looks like everything is on schedule.
12-30-2013, 07:32 PM
Replies: 4,170
Views: 847,133
Posted By Quad Racer 34

Congrats, Martin. Welcome to the team!

Congrats, Martin. Welcome to the team!
12-30-2013, 07:01 PM
Replies: 4,170
Views: 847,133
Posted By Quad Racer 34

Yes it will mount up just fine but there will...

Yes it will mount up just fine but there will about a 1 inch gap on each side because the new chassis is much narrower.
12-30-2013, 05:31 PM
Replies: 8,894
Views: 1,545,966
Posted By Quad Racer 34

JP Richards just got his this weekend so he'll...

JP Richards just got his this weekend so he'll have it at the midwest race.
11-28-2013, 02:31 PM
Replies: 4,170
Views: 847,133
Posted By Quad Racer 34

Yes they will work on the 2.0's. You won't need...

Yes they will work on the 2.0's. You won't need to cut them. They are the correct length.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service