Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: SpeedBump57
Showing results 1 to 25 of 500
Search took 1.66 seconds.
03-30-2007, 07:33 PM
Replies: 5
Views: 549
Posted By SpeedBump57

Stick with the JP-2 then like Yanman suggested....

Stick with the JP-2 then like Yanman suggested. It too is a fine pipe for the B3 just not as much run time as the 2050
03-30-2007, 04:57 PM
Replies: 5
Views: 549
Posted By SpeedBump57

XXX if you have a OS 2050 it works very well on...

XXX if you have a OS 2050 it works very well on the B3. ;)
03-30-2007, 08:58 AM
Replies: 6
Views: 920
Posted By SpeedBump57

Actually MMO is not really good for some engines...

Actually MMO is not really good for some engines as an ARO. Engines that have had crank mods with putty in the crank journal this oil MMO is not good for as it can and will cause the putty to come...
03-29-2007, 07:34 AM
Replies: 7
Views: 796
Posted By SpeedBump57

LSN is too rich. Run some hot laps and get it up...

LSN is too rich. Run some hot laps and get it up to temp. Bring it in and if the engine rpm is high and then drops down real low you are too rich. Lean one hour and do it again. Keep doing this until...
03-28-2007, 04:14 PM
Replies: 13
Views: 1,659
Posted By SpeedBump57

IMO it is not so much that the oil is too thick...

IMO it is not so much that the oil is too thick as it is too runny. That motor oil can absorb dirt & dust and carry it down the filter neck and into the engine. Heck I have even seen that with some...
03-28-2007, 11:23 AM
Replies: 6
Views: 776
Posted By SpeedBump57

If it were me I would send it back in but if you...

If it were me I would send it back in but if you must run it I have used ATV before and it worked well. Take out the idle screw and place a small amount of silicone on the threads and put it back in....
03-28-2007, 11:18 AM
Replies: 13
Views: 1,659
Posted By SpeedBump57

You are better off to use the right oil so you...

You are better off to use the right oil so you don't suck dirt!
03-24-2007, 11:05 AM
Replies: 27
Views: 2,880
Posted By SpeedBump57

Ya they were talking off-road but a cool pic none...

Ya they were talking off-road but a cool pic none the less. I really don't think you could balance an off-road car. You could probably get it close but the fuel is going to mess it up. I guess you...
03-23-2007, 10:22 PM
Replies: 1
Views: 397
Posted By SpeedBump57

Yes a leak in the fuel tank will cause all kinds...

Yes a leak in the fuel tank will cause all kinds of tuning issue's. It's best to replace the tank.
03-23-2007, 10:18 PM
Replies: 15
Views: 4,190
Posted By SpeedBump57

The key to long engine life is in the AIR FILTER!...

The key to long engine life is in the AIR FILTER! Keep it clean and your engine will reward you............;)
03-23-2007, 10:11 PM
Replies: 27
Views: 2,880
Posted By SpeedBump57

You mean like this? ;) This is my 1/12th...

You mean like this? ;)

This is my 1/12th scale, it is balancing on two pins!


http://img299.imageshack.us/img299/4341/Web-DSCN4351.jpg
03-23-2007, 07:28 AM
Replies: 32
Views: 5,764
Posted By SpeedBump57

+1 to Les & Carl But I would also through in...

+1 to Les & Carl

But I would also through in the RB S7II with the Sportwerks 053. It's an easy engine to tune has a great power band and can be had for about 240.
03-23-2007, 07:26 AM
Replies: 32
Views: 5,764
Posted By SpeedBump57

vv

vv
01-26-2007, 12:12 PM
Replies: 1,461
Views: 102,875
Posted By SpeedBump57

Couldn't you just put a front bushing in that had...

Couldn't you just put a front bushing in that had a middle hole?
01-20-2007, 12:54 AM
Replies: 9
Views: 1,031
Posted By SpeedBump57

I have used all of the above, the Acetone works...

I have used all of the above, the Acetone works the best! ;)

Do it just like wingnut said............
01-16-2007, 11:08 PM
Replies: 14
Views: 859
Posted By SpeedBump57

Don't over look the Werks TLB7 or TLB3 for that...

Don't over look the Werks TLB7 or TLB3 for that matter. The customer service is second to none!
01-11-2007, 07:49 AM
Replies: 4,524
Views: 256,172
Posted By SpeedBump57

Put the metal towards the shoes. The rubber...

Put the metal towards the shoes. The rubber shields the dust out better so it goes to the outside.
01-10-2007, 10:13 PM
Replies: 1,461
Views: 102,875
Posted By SpeedBump57

Hum............I don't think I would change a...

Hum............I don't think I would change a thing on that buggy! Just clean it up and put it back on the trailer......... ;)

Nice video by the way.
01-06-2007, 01:15 AM
Replies: 1,461
Views: 102,875
Posted By SpeedBump57

Ryan, Ok here is what I came up with. With...

Ryan,

Ok here is what I came up with. With the 2mm clip in front on the lower arm I get a range from 18* to 24*. I use the King Headz upper rear block which leaves 3mm of play total. So that comes...
01-05-2007, 08:25 AM
Replies: 1,461
Views: 102,875
Posted By SpeedBump57

Ira can you shoot me yours and Allen's e-mail...

Ira can you shoot me yours and Allen's e-mail addy?

[email protected]
01-05-2007, 08:21 AM
Replies: 1,461
Views: 102,875
Posted By SpeedBump57

Thanks Ryan! I have the Hudy as well but don't...

Thanks Ryan! I have the Hudy as well but don't really trust it for accurate castor measurements. I am working on a little project for my MBX5R and really need to have what the manufacture intended...
01-05-2007, 07:46 AM
Replies: 1,461
Views: 102,875
Posted By SpeedBump57

? Can anybody tell me what the min & max...

?

Can anybody tell me what the min & max castor is on the MBX5R? My guess would be 17* - 22* but I need to confirm.
01-02-2007, 08:42 AM
Replies: 1,461
Views: 102,875
Posted By SpeedBump57

Greetings Ira, Where did you and Allen wind...

Greetings Ira,

Where did you and Allen wind up Sunday? Sorry we didn't get to stay to watch, we had to get with the two hour drive. One less bobble in the B and I would have stayed though! LOL...
12-18-2006, 08:51 PM
Replies: 4,524
Views: 256,172
Posted By SpeedBump57

JFC this thread was 3 pages back with no posts...

JFC this thread was 3 pages back with no posts for about 4 days. Just thought I would move it to the top! ;)
12-17-2006, 08:17 PM
Replies: 4,524
Views: 256,172
Posted By SpeedBump57

Boo! :)

Boo! :)
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service