Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: MaricopaAgent
Showing results 1 to 25 of 500
Search took 0.22 seconds.
06-07-2019, 08:19 AM
Replies: 775
Views: 140,565
Posted By MaricopaAgent

Check pinion and ring gear, I would replace...

Check pinion and ring gear, I would replace pinion.

Then try shimming like this.
...
05-29-2019, 07:52 AM
Replies: 11
Views: 2,900
Posted By MaricopaAgent

Imma assume less than 3 months.

Imma assume less than 3 months.
05-26-2019, 02:26 PM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

Thicker front fluid for sure. rear pills...

Thicker front fluid for sure.

rear pills inside and down c and d blocks.
05-18-2019, 07:20 AM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

Yup. I prefer them a little loose.

Yup. I prefer them a little loose.
05-18-2019, 07:19 AM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

42/12 HTC front and rear is good. Takes some low...

42/12 HTC front and rear is good. Takes some low end punch out, making it easier to drive.
05-04-2019, 10:56 PM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

Mugen arms are softer than AE, then they have the...

Mugen arms are softer than AE, then they have the stiffners.
05-01-2019, 05:39 AM
Replies: 8
Views: 381
Posted By MaricopaAgent

I would go with the TBL for both. We have broken...

I would go with the TBL for both. We have broken many SBL's.
04-29-2019, 08:35 AM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

Xray

Xray
04-21-2019, 02:44 PM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

The threads have nothing to do with it breaking....

The threads have nothing to do with it breaking. The Pin fully floats and holds the spring. This is why most of the threads come out.

Run yours much longer, it'll break.
04-20-2019, 08:40 PM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

So, after snapping yet another screw, I thought...

So, after snapping yet another screw, I thought about this thread today.

Since almost all of the threaded part comes out when it breaks, I bent the shoe as far back as possible, which in turn ,...
04-15-2019, 02:55 PM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

Have broken many.. Probably in the 5 to 7 range....

Have broken many.. Probably in the 5 to 7 range. Unfortunately, I just trash it. Hard to justify the time to get the screw out. But, I do install new screws often now.
03-01-2019, 07:38 AM
Replies: 775
Views: 140,565
Posted By MaricopaAgent

Aj runs an Orange rear bar. Pretty much all the...

Aj runs an Orange rear bar. Pretty much all the time.

The front pills are what get me. Opposite of what I believed for rough track.
02-28-2019, 08:13 AM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

This.. ^^ The buggy and truggy shock bodies...

This.. ^^

The buggy and truggy shock bodies are the same. Worst case scenario, you carry 2 less part numbers..
02-14-2019, 06:33 PM
Replies: 36
Views: 5,106
Posted By MaricopaAgent

Is E Truggy Confirmed?

Is E Truggy Confirmed?
02-12-2019, 07:42 AM
Replies: 11
Views: 2,900
Posted By MaricopaAgent

Just goes faster now...

Just goes faster now...
01-20-2019, 08:25 PM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

The angle of the upper arm changes the "active"...

The angle of the upper arm changes the "active" caster. Most people cannot explain it, so I recommend you keep them equal front to back.
The arm position, front to rear changes the actual caster. ...
01-06-2019, 03:52 PM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

They did wear pretty bad. The newer cases (About...

They did wear pretty bad. The newer cases (About 6 months) are harder Plastic.
01-03-2019, 07:39 AM
Replies: 12
Views: 1,168
Posted By MaricopaAgent

On the OS, I run the Mid needle farther in than...

On the OS, I run the Mid needle farther in than a factory setting. Which in turn you have to fatten the Low speed and Lean the High Speed. Mid range needle is also the forbidden fruit to 90% of...
12-31-2018, 05:44 PM
Replies: 24
Views: 2,347
Posted By MaricopaAgent

https://www.homedepot.com/p/3-in-x-10-ft-Drain-Pip...

https://www.homedepot.com/p/3-in-x-10-ft-Drain-Pipe-Solid-3550010/100185642
12-23-2018, 07:08 PM
Replies: 27
Views: 2,054
Posted By MaricopaAgent

well, I have seen a car feel better, but be...

well, I have seen a car feel better, but be overall slower by almost two seconds, in the hands of a experienced driver.
Forum: Chat Lounge
12-20-2018, 05:15 PM
Replies: 147
Views: 14,325
Posted By MaricopaAgent

JQ was going to sign a top driver.. Wonder how...

JQ was going to sign a top driver.. Wonder how that's working out..
Forum: Chat Lounge
12-18-2018, 08:14 AM
Replies: 147
Views: 14,325
Posted By MaricopaAgent

I see a King back in play.. I see a...

I see a King back in play..

I see a manufacturer split their program for a driver.

I see Nothing going on at TLR.. What's the scoop over there? Only Rumors of SR going...
12-16-2018, 10:34 AM
Replies: 64
Views: 8,057
Posted By MaricopaAgent

Sure hope Kyosho doesn't ruin it.

Sure hope Kyosho doesn't ruin it.
12-10-2018, 08:31 AM
Replies: 3,987
Views: 944,569
Posted By MaricopaAgent

Never had an issue. Run it.

Never had an issue. Run it.
11-25-2018, 06:58 AM
Replies: 23
Views: 2,500
Posted By MaricopaAgent

And the Xray XB8 resembles? Wait for it..... ...

And the Xray XB8 resembles? Wait for it.....

The Serpent looks like a? well, A better version of the ?
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service