Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: downunder23
Showing results 1 to 25 of 500
Search took 0.10 seconds.
10-10-2011, 06:46 PM
Replies: 12,372
Views: 1,198,293
Posted By downunder23

i use long ballons skinny ones first get the rim...

i use long ballons skinny ones first get the rim piece on balloon around where the rim for xray boots sit in then i put a second balloon on a bit fatter ones and slide that over the whole shock so it...
07-29-2011, 01:34 PM
Replies: 12,372
Views: 1,198,293
Posted By downunder23

i have used avid disces and psm discs work well...

i have used avid disces and psm discs work well but because they arnt re-enforced they flog out especially if u set the brakes to grab too hard ive rounded out a few discs.

i have looked at the...
07-24-2011, 07:39 AM
Replies: 183
Views: 14,265
Posted By downunder23

besides spiking my self with hex drivers i...

besides spiking my self with hex drivers i managed to change two worn muck around tyres (pretty worn by this stage) and got distracted after replacing two left hand side front and rear tyres with new...
07-22-2011, 03:32 AM
Replies: 485
Views: 102,846
Posted By downunder23

my recently completed xray xb808 '11' spec buggy ...

my recently completed xray xb808 '11' spec buggy
lil bit dirty sorry not neat but here goes.

http://i1232.photobucket.com/albums/ff370/bluexile67/101_0234.jpg
...
07-21-2011, 05:29 AM
Replies: 1
Views: 1,258
Posted By downunder23

orion vortex 8 bl system for 1/8 buggy

anyone know the specs on the motor for this system? i have the specs for esc but not motor i have the 2300kv after the amp draw.

whats everyones opinions on these? they certainly look good and are...
07-21-2011, 05:22 AM
Replies: 4
Views: 595
Posted By downunder23

+ 1 on the savox ive had mine in steering for...

+ 1 on the savox ive had mine in steering for like 8 months now its great has like 12kg of torque with like .08 or .07 speed at 6 volts 60 degrees which is from when i was searching all different...
07-21-2011, 01:03 AM
Replies: 3,166
Views: 1,187,029
Posted By downunder23

MIT b5 they are called .21 engine plenty of power...

MIT b5 they are called .21 engine plenty of power and good run time.

had mine for 20 litres now so far expecting at least 30 litres or more.
07-21-2011, 01:02 AM
Replies: 3,166
Views: 1,187,029
Posted By downunder23

is an MIT engine .21 engine now running it with...

is an MIT engine .21 engine now running it with aplus pipe
the mit engine i have installed is basically an oem modded alpha made by MIT.

very good motors for the price check em out at ebay store...
07-20-2011, 03:18 PM
Replies: 3,166
Views: 1,187,029
Posted By downunder23

my xray xb808 11 spec nitro buggy this car is...

my xray xb808 11 spec nitro buggy this car is wicked to drive.

http://i1232.photobucket.com/albums/ff370/bluexile67/SP_A0020.jpg
07-20-2011, 06:50 AM
Replies: 12,372
Views: 1,198,293
Posted By downunder23

also i spoke to one of the xray pro drivers at...

also i spoke to one of the xray pro drivers at the track and he said he hadnt had a problem with his and that 'maybe theres a problem with ur car'

i couldnt figure it out if there is a problem...
07-20-2011, 06:43 AM
Replies: 12,372
Views: 1,198,293
Posted By downunder23

yes i got 4 of them made up and they have been...

yes i got 4 of them made up and they have been machined to the thousandth of a mm and fit like a tight glove really well fitting.

i dont know what it is but i have had trouble with my rear pin...
07-20-2011, 01:58 AM
Replies: 12,372
Views: 1,198,293
Posted By downunder23

i have two 808 11's all i can say is wicked cars....

i have two 808 11's all i can say is wicked cars.

all problems with my previous 09 spec have vanished and it drives better once i had found my likable setup.

only thing i have done as far as...
07-20-2011, 01:36 AM
Replies: 21
Views: 3,162
Posted By downunder23

my xray xb808 11 is near flawless handles great...

my xray xb808 11 is near flawless handles great steers unreal is tuff.

only thing is a tad expensive but you dont go thru so many parts as a cheaper car.

only things i have modded is the front...
07-19-2011, 11:36 PM
Replies: 2
Views: 702
Posted By downunder23

1/8th electric brushless setup current draw etc

just a question on 1/8 brushless setups.

wondering how current draw works with these things.

i have the orion vortex 8 1/8 brushless system i think is a 150a with 2300 kv motor. running on 4s...
06-03-2011, 10:25 PM
Replies: 3
Views: 1,067
Posted By downunder23

lipo rx pack losing mah capacity.

hi guys just wondering why from the two lipo packs i have used they both lost mah capacity they both started as 2300 mah now im lucky to get 1500 mah charge into them and they are not lasting as long...
11-21-2010, 03:27 PM
Replies: 28
Views: 5,863
Posted By downunder23

has any of you guys ever had a leaky front...

has any of you guys ever had a leaky front bearing that made the engine rev higher after full throttle between that and idle it loads up a bit.

and did a new bearing fix the problem.

i remember...
11-18-2010, 02:05 PM
Replies: 28
Views: 5,863
Posted By downunder23

well somehow with taking a shim out of the head...

well somehow with taking a shim out of the head and resealing the front bearing i have managed to gain some compression my ninja was idling real high and immediately thought air leak which was found...
11-14-2010, 11:44 PM
Replies: 28
Views: 5,863
Posted By downunder23

how long is your nitro engines lasting?

hi guys just would like to know how many litres people are getting out of there engines.

how long until the nip is lost usually on average and then how long do they last after the nip has gone on...
10-07-2010, 08:16 PM
Replies: 3,166
Views: 1,187,029
Posted By downunder23

yes ive had it for about 12 months now but havnt...

yes ive had it for about 12 months now but havnt done full on racing in that 12 months tho i clean her with degreaser and water then blow dry then wd-40 the whole buggy then blow off excess with...
10-07-2010, 03:49 AM
Replies: 3,166
Views: 1,187,029
Posted By downunder23

heres one i threw together using tape and cans...

heres one i threw together using tape and cans didnt take long at all sorta a bit bodgy and simple was either this or all one colour lol . the body is a proline, mugen mbx6 bulldog body sitting on an...
09-29-2010, 03:15 AM
Replies: 12,372
Views: 1,198,293
Posted By downunder23

hi guys just wondering if the xray xb808 2010...

hi guys just wondering if the xray xb808 2010 spec radio box will fit an original 808 '08'spec?
07-22-2010, 04:02 PM
Replies: 889
Views: 172,544
Posted By downunder23

hi guys i need some help. i managed to figure...

hi guys i need some help.
i managed to figure out how to get the custom tracks to load up in game i just have no idea how to load the custom cars to get them to appear in the list in game where do i...
07-16-2010, 03:40 PM
Replies: 889
Views: 172,544
Posted By downunder23

ya i dled thunder ally but like my other custom...

ya i dled thunder ally but like my other custom tracks the one track came in 3 different files like my other custom tracks i put them into my custom tracks folder for rrg2 but when playing the game...
07-15-2010, 08:05 PM
Replies: 889
Views: 172,544
Posted By downunder23

where can i dl some good tracks?

where can i dl some good tracks?
07-15-2010, 01:24 AM
Replies: 889
Views: 172,544
Posted By downunder23

any idea how to run on the custom tracks in game...

any idea how to run on the custom tracks in game i can only seem to access the original ones in the game wich arnt too crash hot.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.