R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: glassdoctor
Showing results 1 to 25 of 500
Search took 0.07 seconds.
09-08-2011, 04:40 PM
Replies: 168
Views: 22,597
Posted By glassdoctor

http://www.youtube.com/watch?v=QU5zNxW6w3g

http://www.youtube.com/watch?v=QU5zNxW6w3g
09-06-2011, 07:45 AM
Replies: 179
Views: 35,864
Posted By glassdoctor

Adding a lot of weight started when we switched...

Adding a lot of weight started when we switched from 15 oz nimh packs to 9-10oz lipos. To see the effect first hand.... put a lipo in the ole XXXT and see how it does. It will feel like crap :nod:
...
06-25-2011, 05:45 PM
Replies: 4
Views: 1,689
Posted By glassdoctor

I doubt it. The BEC output is isolated from...

I doubt it.

The BEC output is isolated from the ESC when you disconnect the red wire from the ESC plug.

If the BEC input leads short out, that is effectively shorting out both the BEC and the...
06-24-2011, 07:51 PM
Replies: 4
Views: 1,689
Posted By glassdoctor

Doesn't matter which slot you plug the BEC into....

Doesn't matter which slot you plug the BEC into. Servo and ESC will be CH1 and CH2. Any other "accessory" things like the BEC, personal transponder, glitch buster capacitor, rx battery, etc can be...
05-02-2011, 09:09 PM
Replies: 3,283
Views: 452,004
Posted By glassdoctor

Absolutely. I run one w/out the fan in my B4. But...

Absolutely. I run one w/out the fan in my B4. But note that the newest ones don't have the removable fan case, so you will have to "dremel" the fan off. The nice thing though, is that the new design...
05-02-2011, 09:02 AM
Replies: 3,283
Views: 452,004
Posted By glassdoctor

CHEAT only works in "sensor only" mode. If you...

CHEAT only works in "sensor only" mode. If you dial in 10-25* on a 7.5 you would definitely know it's working. :lol: Set it to sensor only mode and 25* @5000rpm and report back to us if you can see a...
05-01-2011, 11:13 AM
Replies: 3,283
Views: 452,004
Posted By glassdoctor

The newer MMP also has a slightly lower profile....

The newer MMP also has a slightly lower profile. The case at the caps, and the heatsink... are maybe 1/8" shorter. And the fan/case is one piece now, so it's not removable without dremel surgery....
04-30-2011, 11:45 AM
Replies: 3
Views: 575
Posted By glassdoctor

I don't have the 2.1, but I believe it's capable...

I don't have the 2.1, but I believe it's capable of running sensorless. My GT2.0 acts a bit different without a sensor wire, but it does work. In fact, a couple years ago I once ran without the wire...
04-30-2011, 11:41 AM
Replies: 10
Views: 1,049
Posted By glassdoctor

Those are 3 pc wheels... should be able to easily...

Those are 3 pc wheels... should be able to easily remove and replace the tires.
04-26-2011, 06:20 AM
Replies: 18
Views: 2,068
Posted By glassdoctor

sure... but most don't race in the kitchen. :lol:

sure... but most don't race in the kitchen. :lol:
04-25-2011, 08:07 PM
Replies: 21
Views: 3,177
Posted By glassdoctor

Apparently the motor was smoked. It's too late...

Apparently the motor was smoked. It's too late now, no matter how you gear it. So you can get mad and throw a fit, but you are expecting a damaged motor to work correctly... not possible. It's like...
04-25-2011, 03:13 PM
Replies: 9
Views: 4,375
Posted By glassdoctor

Goosebumps come with good soft foams. No need to...

Goosebumps come with good soft foams. No need to change to something else. I ran a set all last summer outside on a black dirt track w/out issue.
04-25-2011, 03:09 PM
Replies: 21
Views: 3,177
Posted By glassdoctor

If you overheated the motor due to incorrect...

If you overheated the motor due to incorrect gearing, it's now toast and it's too late. Once the magnets have been weakened, it will run hot no matter what.

Pick up a new rotor, and find out what...
04-25-2011, 11:53 AM
Replies: 3,283
Views: 452,004
Posted By glassdoctor

Should be fine unless you abuse it running in...

Should be fine unless you abuse it running in grass, etc. What brand motor? That makes a difference... they aren't all the same.
04-24-2011, 05:23 PM
Replies: 3
Views: 1,883
Posted By glassdoctor

If all the esc settings are exactly the same,...

If all the esc settings are exactly the same, there should be little if any difference in performance or motor temp. Punch control, timing, etc... something may not be the same. Or it can simply be...
04-23-2011, 08:56 PM
Replies: 13
Views: 11,045
Posted By glassdoctor

Make sure the radio has the throttle end points...

Make sure the radio has the throttle end points set all the way up, and center the throttle trim, etc. Hold full throttle while turning on the esc... if it doesn't go into calibration mode then...
04-23-2011, 08:26 PM
Replies: 20
Views: 1,411
Posted By glassdoctor

You won't find it at a retail type store... have...

You won't find it at a retail type store... have to find a commercial supplier. I can't help you find one, but for our track in Des Moines, we had to go about 2 hours north to another town to find it.
04-23-2011, 08:21 PM
Replies: 13
Views: 11,045
Posted By glassdoctor

If the motor never over heated, and it's gotten...

If the motor never over heated, and it's gotten slower? I would check the battery first. Brushless motors are normally either good or bad and no in between. And same with a speed control... don't...
04-22-2011, 05:04 PM
Replies: 12,070
Views: 1,203,561
Posted By glassdoctor

Amain is a great online shop... which is why they...

Amain is a great online shop... which is why they became THE shop for rc racers. Amain is the Amazon.com of r/c. Having said that, I also happen to know the guys at bluegroovehobbies and they are...
04-19-2011, 02:28 PM
Replies: 10,567
Views: 1,405,082
Posted By glassdoctor

Very nice. BK and Masami = greatest drivers of...

Very nice. BK and Masami = greatest drivers of all time. :nod:
04-19-2011, 10:21 AM
Replies: 5
Views: 841
Posted By glassdoctor

Then bump up to the 8xl... should be good.

Then bump up to the 8xl... should be good.
04-19-2011, 09:27 AM
Replies: 5
Views: 841
Posted By glassdoctor

9xl if you are running 4s

9xl if you are running 4s
04-18-2011, 10:30 PM
Replies: 7
Views: 1,430
Posted By glassdoctor

The only way I see to make a 2-in-1 car is to...

The only way I see to make a 2-in-1 car is to take a car like the Losi 22 and run a belt to the front like was done in the 80's with the RC10 conversions. Keep the suspension geometry untouched while...
04-18-2011, 10:07 PM
Replies: 6
Views: 840
Posted By glassdoctor

What I mean is... do you have excessive top end?...

What I mean is... do you have excessive top end? If you can afford to drop a tooth or two, it will not only tame the top end, but contrary to popular opinion... it should also make the whole...
04-18-2011, 06:57 PM
Replies: 6
Views: 840
Posted By glassdoctor

How is the top end? If possible, gear it down and...

How is the top end? If possible, gear it down and see how you like it. The taller you gear them the more violent they are. :sneaky: Too much power overall... will make it more difficult to control.
...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.