Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: CClay1282
Showing results 1 to 25 of 432
Search took 0.12 seconds.
10-21-2009, 02:51 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

These were brand new bladders. I had just put...

These were brand new bladders. I had just put the shocks together. Had about 1/4 in rebound on the shocks, so it was excess pressure. I had drilled small holes in the caps to releive the air side...
10-20-2009, 07:50 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

Tried that a couple times and kept blowing...

Tried that a couple times and kept blowing bladders. :(

Maybe it was just me! lol
10-08-2009, 04:50 AM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

I run a fantom 10.5 in my buggy and use around...

I run a fantom 10.5 in my buggy and use around 1300-1500. 10.5 in my t4 about 2100-2300.
10-02-2009, 07:25 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

I run a novak 7.5 in mine, and i run a 18-19 with...

I run a novak 7.5 in mine, and i run a 18-19 with 84-87 spur. Thats with a t4, not sure what you have.
09-29-2009, 02:53 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

+1 and also sand the diff rings with some 360 in...

+1 and also sand the diff rings with some 360 in a circular motion.
09-28-2009, 07:17 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

I think they work pretty darn good!

I think they work pretty darn good!
09-28-2009, 07:13 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

The graphite chassis will conduct electricity. ...

The graphite chassis will conduct electricity. Take an ohm meter to the chassis and if it shows 0 then its a plastic chassis. If it shows conductivity, its graphite.



They switched to the...
09-28-2009, 05:57 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

23

23
09-28-2009, 02:58 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

The dubro trapped ones that dont have the screw...

The dubro trapped ones that dont have the screw for slop adjustment are fragile and slop out quick.

They arent captured, but the jconcepts ones are good for the rear.
09-27-2009, 07:10 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

You can try moving your rear hubs forward and/or...

You can try moving your rear hubs forward and/or using a larger spur to move your motor back.
09-24-2009, 10:05 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

With the 13.5 i would run a 78/24-28 depending on...

With the 13.5 i would run a 78/24-28 depending on speedo. The 8.5 maybe a 84/21 ???.
09-20-2009, 05:17 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

First thing you need to do is find out what...

First thing you need to do is find out what people at your racetrack run. Then go by that. If stock then a 17.5. If Superstock then a 13.5. If mod, i suggest a 10.5 or 8.5. Novak motors are...
09-18-2009, 02:16 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

The previous owner either drilled the stock caps...

The previous owner either drilled the stock caps (prolly hard to do), or put yokomo bleeder caps on them.
09-17-2009, 07:45 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

Its really only somewhat required with 17.5. I...

Its really only somewhat required with 17.5. I have never run them. only used down to a 78. Now, with the smaller spurs you can use those to move your motor forward more for less rear traction.
09-16-2009, 07:50 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

when i ran a 17.5 in my t4, i ran 78/28-30. That...

when i ran a 17.5 in my t4, i ran 78/28-30. That was with a novak motor.
09-16-2009, 05:44 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

If you have a gap between the trans case halves,...

If you have a gap between the trans case halves, you better pull it apart and check everything. There shouldnt be a gap.
09-16-2009, 11:38 AM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

+1, thats how i do it.

+1, thats how i do it.
09-15-2009, 09:56 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

When the diff gets "gritty" it needs rebuilt. ...

When the diff gets "gritty" it needs rebuilt. Pretty much what i do is clean everything with motor spray and sand the diff rings with 360 sandpaper. Put it back together with the clear stealth diff...
09-14-2009, 09:21 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

I glue mine. lol. Keeps them from slipping! ...

I glue mine. lol. Keeps them from slipping!

I did notice when i built both my b4 and t4 diff just a month or two ago, that it did seem like they have tight spots in them. Not notchy, just tight....
09-14-2009, 02:59 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

I would have to give a big thumbs up for this...

I would have to give a big thumbs up for this one. The higher the "TRUE" c rating is, the higher average voltage you will have. More voltage gives you more power.
09-14-2009, 02:58 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

I dont know about every race day. I guess if you...

I dont know about every race day. I guess if you raced every other weekend. I would say at least every two race days. No matter when i last replaced them, i always replace them before a big...
09-11-2009, 03:12 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

Although some of you had said your shocks feel...

Although some of you had said your shocks feel the same after extended period of time, i am willing to be they dont. They may not leak, as mine dont leak. But the orings will swell from the fluid. ...
09-10-2009, 08:50 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

Internal limiters have nothing to do with...

Internal limiters have nothing to do with uptravel. They are for downtravel. Limiters on the shock shafts outside the shock body would limit uptravel.
09-10-2009, 04:26 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

I havent completely given up on the whole shock...

I havent completely given up on the whole shock bladder thing, but i ran them for a while trying different things, and just couldnt get them to feel like the stock setup. May try again sometime...
09-09-2009, 08:43 PM
Replies: 14,426
Views: 1,258,205
Posted By CClay1282

When i run a 13.5 i run 78/24. That is with a...

When i run a 13.5 i run 78/24. That is with a LRP TC Spec using profile 5-8.
Showing results 1 to 25 of 432
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.