R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: Kent Beal
Showing results 1 to 25 of 500
Search took 0.39 seconds.
02-16-2020, 04:34 PM
Replies: 4
Views: 245
Posted By Kent Beal

TTT

TTT
02-06-2020, 05:03 PM
Replies: 4
Views: 245
Posted By Kent Beal

Make a crazy offer, might just accept it.

Make a crazy offer, might just accept it.
02-01-2020, 11:42 AM
Replies: 4
Views: 245
Posted By Kent Beal

To the top

To the top
01-27-2020, 05:20 PM
Replies: 4
Views: 245
Posted By Kent Beal

TTT

TTT
01-25-2020, 09:39 PM
Replies: 4
Views: 245
Posted By Kent Beal

Buggy tires for 22 1.0/2.0

7 sets of fronts and 5 sets of rears.. $60.00 shipped or make offer.
Other than the ribbed tires the rest have very little use....
01-25-2020, 09:35 PM
Replies: 1
Views: 396
Posted By Kent Beal

Forum: Rookie Zone
01-02-2020, 07:13 PM
Replies: 9
Views: 711
Posted By Kent Beal

I suggest going to all straight hex sizes, less...

I suggest going to all straight hex sizes, less chance of stripping and screw. Like Speed Freak said having a ball end 2.5 does come in handy for removing motors.
Forum: Rookie Zone
11-30-2019, 08:32 PM
Replies: 2
Views: 574
Posted By Kent Beal

It's hard to say without seeing them(what...

It's hard to say without seeing them(what electronics they have and upgrades) but a good rule is 1/2 of what they cost new to start.
11-28-2019, 10:41 AM
Replies: 13
Views: 496
Posted By Kent Beal

Are you using a sensor wire between the esc and...

Are you using a sensor wire between the esc and motor? Orion 1/10 motors are meant to be sensor and running without it can make them act weird.
11-28-2019, 10:38 AM
Replies: 9
Views: 280
Posted By Kent Beal

Heli servos will not survive in a surface car...

Heli servos will not survive in a surface car over long term use. The electronics in heli servos have a different tolerance built in to make them very good at centering and the abuse of an buggy...
10-12-2019, 11:29 AM
Replies: 5
Views: 633
Posted By Kent Beal

Some combination of florescent yellow, florescent...

Some combination of florescent yellow, florescent orange, florescent green and white will show up very well in almost any light conditions. Here is a picture of some cars I ran a long time ago and I...
Forum: Rookie Zone
10-11-2019, 09:45 AM
Replies: 1
Views: 271
Posted By Kent Beal

The closest place I can think is Hot Rod Hobbies...

The closest place I can think is Hot Rod Hobbies in Saugus(near Magic Mountain) Hot Rod Hobbies (http://www.hotrodhobbies.com)
Beyond that check the track directory on www.dirtoval.com...
Forum: RC Flight
09-26-2019, 02:15 PM
Replies: 4
Views: 630
Posted By Kent Beal

Also I forgot is the radio in sailplane mode? If...

Also I forgot is the radio in sailplane mode? If so that is the issue, in this mode the radio puts throttle on a switch instead of the stick.
change radio to airplane mode and skip doing my previous...
Forum: RC Flight
09-25-2019, 05:28 PM
Replies: 4
Views: 630
Posted By Kent Beal

Hi, I'm not sure what the issue is but try this...

Hi,
I'm not sure what the issue is but try this and should get it working.

1. Do a model reset on the radio and this will restore to default settings. Function list> system setup>Model...
03-09-2019, 10:03 PM
Replies: 8
Views: 739
Posted By Kent Beal

Hi, I used to work for Horizon Hobby and when...

Hi,
I used to work for Horizon Hobby and when this happens rarely are they bad so I have a couple questions.
1.What exactly did you do to reset the end points? This matters a lot with these AVC...
02-24-2019, 11:45 PM
Replies: 2
Views: 486
Posted By Kent Beal

Unfortunately it may not be compatible, the first...

Unfortunately it may not be compatible, the first run of DX3S radio were DSM only and will not work with any DSM2 receivers. On the back side of the radio is there a boat emblem? If yes, then it is...
10-21-2018, 10:18 PM
Replies: 12
Views: 455
Posted By Kent Beal

I have 22b if you're interested, 160.00 shipped ...

I have 22b if you're interested, 160.00 shipped
Its the original converted to a 2.0 in rear motor config but have all the parts to make it mid-motor. It has the milled out light weight chassis that...
05-13-2018, 03:58 PM
Replies: 7
Views: 1,216
Posted By Kent Beal

Futaba Tech and Service Support.

With the bankruptcy of Hobbico, Futaba is setting up their own Service Center. Here is a link to their webpage: https://futabausa.com/
Forum: Crawler Room
02-08-2018, 08:22 PM
Replies: 359
Views: 121,529
Posted By Kent Beal

1459979https://cimg6.ibsrv.net/gimg/www.rctech.net...

1459979https://cimg6.ibsrv.net/gimg/www.rctech.net-vbulletin/1600x1200/80-img_4298_f2d4c9443cc4e78f22f69216bf140e288689d8bf.jpg
My Ascender.
01-18-2018, 06:41 PM
Replies: 6
Views: 820
Posted By Kent Beal

Bump

Bump
12-17-2017, 06:00 PM
Replies: 7
Views: 614
Posted By Kent Beal

Bump

Bump
12-17-2017, 05:59 PM
Replies: 6
Views: 272
Posted By Kent Beal

Bump

Bump
12-15-2017, 06:13 PM
Replies: 6
Views: 441
Posted By Kent Beal

bump

bump
12-15-2017, 06:13 PM
Replies: 7
Views: 614
Posted By Kent Beal

bump

bump
11-22-2017, 10:11 PM
Replies: 7
Views: 614
Posted By Kent Beal

Lowered to 240.00

Lowered to 240.00
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.