R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: John_S
Showing results 1 to 25 of 500
Search took 0.03 seconds.
Forum: Electric On-Road
10-15-2014, 12:48 PM
Replies: 237
Views: 75,000
Posted By John_S

There is a little "shelf" infront of the back...

There is a little "shelf" infront of the back wheel on the opposite side to the spur for the weight to screw on. It says on the website the cars will be released near the end of the month.
Forum: Electric On-Road
03-16-2013, 08:12 AM
Replies: 5,637
Views: 1,047,962
Posted By John_S

Do you have ecs driveshafts installed in your...

Do you have ecs driveshafts installed in your car? I find these drastically increase the corner speed of the car. Also try the 1 hole rear hubs, these tend to suit large open tracks very well.
Forum: Radio and Electronics
05-21-2012, 02:06 PM
Replies: 12,554
Views: 1,873,404
Posted By John_S

What motor where you using Millbank? Also what...

What motor where you using Millbank? Also what ratio where you using? I was using a v3 speedo and reedy motor at the weekend. Brakes where awesome.
Forum: Electric On-Road
04-28-2012, 12:31 PM
Replies: 9
Views: 1,017
Posted By John_S

check the layshaft bearings for smootheness

check the layshaft bearings for smootheness
Forum: Electric On-Road
09-12-2011, 01:02 PM
Replies: 2,947
Views: 425,272
Posted By John_S

You need to enter the mode select. Then press and...

You need to enter the mode select. Then press and hold the set button untill it beeps again
Forum: Electric On-Road
07-13-2011, 10:47 AM
Replies: 2,947
Views: 425,272
Posted By John_S

hold the brakes on slightly and turn the motor....

hold the brakes on slightly and turn the motor. Tthe lights on the speedo will change to show you the sensors
Forum: Electric On-Road
06-17-2011, 01:47 AM
Replies: 4,188
Views: 698,163
Posted By John_S

The setup sheet is a little sketchy as far as...

The setup sheet is a little sketchy as far as shock shims go. I run 1mm on the wishbone on the frot and 1mm on the shock tower on the rear just to bring he shocks back to the same angle as kit. This...
Forum: Electric On-Road
06-16-2011, 04:54 AM
Replies: 4,188
Views: 698,163
Posted By John_S

Alright m8 my setup on the Xray website from brca...

Alright m8 my setup on the Xray website from brca rd2 is what I use when I go to a new track. The main changes would be ride height, bodyshell and some other small things. My name on the Xray website...
Forum: Electric On-Road
06-05-2011, 01:22 PM
Replies: 4,188
Views: 698,163
Posted By John_S

I agree with chris that a car with some...

I agree with chris that a car with some understeer will wear the tyres out extremely quickly. Post you setup so we can have a look and try and diagnose the issue :)
Forum: Electric On-Road
06-04-2011, 01:56 PM
Replies: 13,431
Views: 1,990,721
Posted By John_S

does anybody know where 0 degree timing is on a...

does anybody know where 0 degree timing is on a v2 mod motor? :) thanks
Forum: Electric On-Road
06-01-2011, 08:49 AM
Replies: 2,947
Views: 425,272
Posted By John_S

reselecting the mode/ doing transmitter setup...

reselecting the mode/ doing transmitter setup wont change any speedo settings. Only if you do a factory reset will it alter the settings
Forum: Electric On-Road
05-29-2011, 12:45 PM
Replies: 2,947
Views: 425,272
Posted By John_S

its called autobrake on the brakes setting page

its called autobrake on the brakes setting page
Forum: Electric On-Road
05-28-2011, 03:11 AM
Replies: 4,188
Views: 698,163
Posted By John_S

i think much more shock oil is the most widely...

i think much more shock oil is the most widely used brand and offers good consistency.
Forum: Electric On-Road
05-07-2011, 09:57 AM
Replies: 4,188
Views: 698,163
Posted By John_S

What is the advantage of going to 50mm...

What is the advantage of going to 50mm driveshafts in the front?
Forum: Electric On-Road
04-21-2011, 11:46 AM
Replies: 2,947
Views: 425,272
Posted By John_S

hello this is just my opinion from what i have...

hello this is just my opinion from what i have found through my testing. There is 2 ways to gear the car, one is with a low fdr (4.6 or so) and the other is with a high fdr (6.0 or so). Both of...
Forum: Electric On-Road
03-17-2011, 10:28 AM
Replies: 2,947
Views: 425,272
Posted By John_S

.

.
Forum: Electric On-Road
03-16-2011, 04:00 PM
Replies: 2,947
Views: 425,272
Posted By John_S

Number 2 is for switching point :)

Number 2 is for switching point :)
Forum: Electric On-Road
03-16-2011, 01:54 PM
Replies: 2,947
Views: 425,272
Posted By John_S

hope this helps

hope this helps
Forum: Electric On-Road
03-16-2011, 09:55 AM
Replies: 2,761
Views: 426,862
Posted By John_S

hey paul i was just wondering what you thaught...

hey paul i was just wondering what you thaught the 1 deg rear hubs done to the car over the kit version. Keeping the same overall rear toe ofcource. I no this would change the wheelbase and possibly...
Forum: Electric On-Road
03-16-2011, 09:45 AM
Replies: 2,947
Views: 425,272
Posted By John_S

the value in the box i have marked should be...

the value in the box i have marked should be either 7 for max brakes and a switching point, or 5 for max brakes and no switching point. Value 3 in reserved 4 is to be ticked for max braking effect....
Forum: Electric On-Road
03-14-2011, 01:04 PM
Replies: 2,947
Views: 425,272
Posted By John_S

For the advanced braking of the v13 firmware to...

For the advanced braking of the v13 firmware to take effect at its strongest form, you need to make sure value 3 in reserved 4 is ticked or you will not see the brake advantages that v13 firmware...
Forum: Electric On-Road
03-13-2011, 02:09 PM
Replies: 2,947
Views: 425,272
Posted By John_S

Hello can i please ask what your reserved 4 is...

Hello can i please ask what your reserved 4 is set to on the telemetery page. Thanks
Forum: Electric On-Road
03-07-2011, 08:39 AM
Replies: 4,188
Views: 698,163
Posted By John_S

The current range of ko propor servos are rather...

The current range of ko propor servos are rather good (rsx range) along with the sanwa 801. I think low profile or standard doesnt matter you just have to make sure the car is good when you balance...
Forum: Electric On-Road
03-06-2011, 12:42 PM
Replies: 2,947
Views: 425,272
Posted By John_S

If you are having problems like this then you are...

If you are having problems like this then you are settings somethng incorrectly, as the gm is far more efficient at adding timing than the tekin is. Brakes are also a non issue as I, like others have...
Forum: Electric On-Road
03-01-2011, 10:31 AM
Replies: 11
Views: 999
Posted By John_S

This is not a rule in the uk so you can do what...

This is not a rule in the uk so you can do what you like in the last leg of a 3 leg meeting.
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.