R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: Eivind E
Showing results 1 to 25 of 500
Search took 0.09 seconds.
Forum: Rookie Zone
11-12-2023, 12:33 AM
Replies: 53
Views: 6,333
Posted By Eivind E

it requires throttle control, which will increase...

it requires throttle control, which will increase your skill level massively
Forum: Rookie Zone
11-12-2023, 12:26 AM
Replies: 53
Views: 6,333
Posted By Eivind E

where is this? I’d love to go there, for fun

where is this? I’d love to go there, for fun
Forum: Rookie Zone
11-12-2023, 12:22 AM
Replies: 53
Views: 6,333
Posted By Eivind E

Those lots look perfect for pancar, I agree. We...

Those lots look perfect for pancar, I agree. We used to run in parking lots in 1990-91, and we never had any trouble at all, we never even swept the lot with brooms or anything. I don’t know where...
01-04-2021, 12:17 PM
Replies: 1,083
Views: 86,981
Posted By Eivind E

RC cars, and perhaps particularly 1/12 cars have...

RC cars, and perhaps particularly 1/12 cars have gotten so fast and specialized that most people lose interest, and perhaps can't participate even.

8000mah batteries, compare that to 1200mah or...
07-30-2018, 01:20 PM
Replies: 1,935
Views: 323,079
Posted By Eivind E

Adrien Bertin silicones the engines. He siliconed...

Adrien Bertin silicones the engines. He siliconed the one he rebuilt me at the EFRA Euros 2017. This engine has since had the best idle of any Orion I ever had, hence I recommend this practice to...
07-28-2018, 03:52 PM
Replies: 1,935
Views: 323,079
Posted By Eivind E

You have an air leak, this is not so unusual. The...

You have an air leak, this is not so unusual. The cure for these Orions is high temperature resistant silicone around the carb neck to crankcase, and where the carburettor boot attaches onto the carb...
07-05-2018, 12:31 PM
Replies: 716
Views: 289,459
Posted By Eivind E

They don’t push the pin far enough in at the...

They don’t push the pin far enough in at the factory.
For the last few years I’ve been using a vice to push pins further in.

Not being pushed in enough risks them falling out during use.
12-03-2016, 12:24 PM
Replies: 2,823
Views: 605,777
Posted By Eivind E

Protek Losi LRP

Protek Losi
LRP
11-26-2016, 08:38 AM
Replies: 10
Views: 1,207
Posted By Eivind E

It was a gimmick

It was a gimmick
11-25-2016, 02:40 PM
Replies: 280
Views: 120,962
Posted By Eivind E

It wouldn't have any overheating issues as it's...

It wouldn't have any overheating issues as it's probably very cold at Padova right now.
11-24-2016, 09:19 PM
Replies: 3
Views: 2,478
Posted By Eivind E

I have a theory on why this is going on. A...

I have a theory on why this is going on.

A guy at my local club had this.
Basicly if you set the initial servo horn setting wrong, so that the horn is in fact not straight, then that has a knock...
11-21-2016, 11:47 AM
Replies: 2,823
Views: 605,777
Posted By Eivind E

It hasn't changed since the 812 version. But they...

It hasn't changed since the 812 version. But they also make it for other brand cars, I think..
11-21-2016, 07:00 AM
Replies: 2,823
Views: 605,777
Posted By Eivind E

I like the Jconcepts body, it's nice. Especially...

I like the Jconcepts body, it's nice. Especially for the +4 chassis. The type R, because of the slope on the rear, sits lower on the back with the +4.
The Jconcepts body sits better with the longer...
11-16-2016, 02:59 PM
Replies: 955
Views: 298,517
Posted By Eivind E

Modelcars Reading Answer RC

Modelcars Reading
Answer RC
11-11-2016, 06:35 AM
Replies: 14
Views: 3,887
Posted By Eivind E

well, if you are serious about that, then you...

well, if you are serious about that, then you probably already know that the best drivers in Denmark, like Culmsee, Fischer, they all drive HB D815.
11-10-2016, 08:33 AM
Replies: 2,823
Views: 605,777
Posted By Eivind E

That would do it! if you omit the spacer, things...

That would do it! if you omit the spacer, things will go badly
11-10-2016, 07:20 AM
Replies: 2,823
Views: 605,777
Posted By Eivind E

"everybody" runs it, and we aren't breaking any...

"everybody" runs it, and we aren't breaking any spur gears.

The guy just said his spur gear was rubbing on the sides of the chassis, I don't even know what that means, but I tried to ask for...
11-08-2016, 07:37 AM
Replies: 2,823
Views: 605,777
Posted By Eivind E

why don't you take a few pictures of your centre...

why don't you take a few pictures of your centre diff mount, chassis, spur gear, how the engine sits in there, etc.
11-08-2016, 07:13 AM
Replies: 2,823
Views: 605,777
Posted By Eivind E

No. Most likely something else is causing your...

No. Most likely something else is causing your issue. Probably something like not setting gear mesh right, or clutch bell bearings.
11-07-2016, 12:37 PM
Replies: 8
Views: 3,343
Posted By Eivind E

The number one thing is run a good fuel. If you...

The number one thing is run a good fuel. If you run Byrons it leaves a healthy ammount of oil.

Some other fuels don't have enough castor oil, and have only synthetic oil. Those fuels will not...
11-06-2016, 02:00 AM
Replies: 683
Views: 88,581
Posted By Eivind E

OK soooo.. I just read a post on the facebook...

OK soooo.. I just read a post on the facebook about the recent EFRA AGM
And apparently it says "modified" for 1/12 is now 6.5T motor and blinky..
And according to them, 1/12 in the rest of the...
11-01-2016, 05:03 PM
Replies: 1
Views: 229
Posted By Eivind E

want: Turbomatcher, Competition Electronics

looking for an old CE Turbomatcher, any version
10-26-2016, 06:35 PM
Replies: 37
Views: 14,640
Posted By Eivind E

Does it only count when OS wins the championship?...

Does it only count when OS wins the championship?
Team Orion won this championship. Fair and square. Orion are world champion.
10-26-2016, 04:43 PM
Replies: 12
Views: 3,824
Posted By Eivind E

The Ronnefalk engine is different, it has an...

The Ronnefalk engine is different, it has an improved crankcase.
The other one is the previous model, which I have run and I was happy running that one too. For me the newer crank case tunes better....
10-26-2016, 03:31 PM
Replies: 37
Views: 14,640
Posted By Eivind E

2016 world champion engine is Team Orion.

2016 world champion engine is Team Orion.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.