Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: rcbuggy88
Showing results 1 to 25 of 476
Search took 0.05 seconds.
11-28-2018, 01:46 PM
Replies: 9
Views: 668
Posted By rcbuggy88

Team Powers is amazing, the IRs are really low....

Team Powers is amazing, the IRs are really low. It looks cool and is really fast. I would definitely consider it.
11-28-2018, 01:44 PM
Replies: 13
Views: 432
Posted By rcbuggy88

do you need to clean the bullets? I've never...

do you need to clean the bullets? I've never cleaned the bullet sockets in a battery.
11-28-2018, 01:43 PM
Replies: 11
Views: 751
Posted By rcbuggy88

It's called puking the fan. It's when you slap...

It's called puking the fan. It's when you slap the car hard after a jump or a crash, the momentum just cracks the skinny plastic braces. Aluminum should help, and I found that the yokomo fan holder...
11-28-2018, 01:38 PM
Replies: 34
Views: 3,065
Posted By rcbuggy88

By hand. Make separate trips and carry carefully.

By hand. Make separate trips and carry carefully.
10-18-2018, 09:21 AM
Replies: 4
Views: 273
Posted By rcbuggy88

I have a team powers actinium v2. I bought the...

I have a team powers actinium v2. I bought the motor for 21.5 touring car, only used for summer season. PM if interested.
10-18-2018, 08:59 AM
Replies: 19
Views: 796
Posted By rcbuggy88

aka is the best (i think).

aka is the best (i think).
10-15-2018, 12:59 PM
Replies: 32
Views: 2,215
Posted By rcbuggy88

+1 most batteries are made by the same company...

+1 most batteries are made by the same company (don't know all them), but some companies have higher regulations to pass through inspection.
10-13-2018, 05:24 PM
Replies: 32
Views: 2,215
Posted By rcbuggy88

Team Powers, Orion, and Sunpadow are also good.

Team Powers, Orion, and Sunpadow are also good.
10-12-2018, 05:17 PM
Replies: 13
Views: 1,768
Posted By rcbuggy88

I would get any of the modern cars like the...

I would get any of the modern cars like the NB48.4, MBX8, XB8, TKI4 10th edition, etc... the aggressiveness and tameness can be adjusted with setup.
10-12-2018, 05:11 PM
Replies: 19
Views: 1,831
Posted By rcbuggy88

Not exactly quantifiable but when you have the...

Not exactly quantifiable but when you have the wing, the car is quite a bit more stable and get more rear grip. Also, you nosedive without one.
10-12-2018, 05:07 PM
Replies: 18
Views: 1,912
Posted By rcbuggy88

Stick it all in boxes. In a shed or garage is...

Stick it all in boxes. In a shed or garage is better.
10-12-2018, 05:05 PM
Replies: 9
Views: 545
Posted By rcbuggy88

sand down the epoxy

sand down the epoxy
10-12-2018, 09:38 AM
Replies: 13
Views: 813
Posted By rcbuggy88

reason for sale?

reason for sale?
Forum: Rookie Zone
10-12-2018, 09:33 AM
Replies: 10
Views: 687
Posted By rcbuggy88

those are droop blocks. Stick them under the car...

those are droop blocks. Stick them under the car and measure droop with a droop gauge.
10-12-2018, 09:02 AM
Replies: 35
Views: 1,539
Posted By rcbuggy88

For optimal battery IR, you take a new battery...

For optimal battery IR, you take a new battery and cycle it at 40 amps until the IR is as low as desired. Although, this will shorten the life of the battery. (Doesn't matter for racing)
10-12-2018, 08:59 AM
Replies: 22
Views: 2,388
Posted By rcbuggy88

There is so much grip on carpet, that you would...

There is so much grip on carpet, that you would just strip gears with one. Even with stock, I would run a slipper on carpet with a gear diff. No cut gears and steel driveshafts probably.
10-12-2018, 08:57 AM
Replies: 152
Views: 23,722
Posted By rcbuggy88

try the brass c block

try the brass c block
10-12-2018, 08:57 AM
Replies: 7
Views: 497
Posted By rcbuggy88

For use on indoor clay, use JC Gold or PL MC. Not...

For use on indoor clay, use JC Gold or PL MC. Not sure about AKA, but proline just clean and glue, and JC cut the foams and punch holes because the foams are really soft.
Forum: Rookie Zone
10-11-2018, 02:41 PM
Replies: 10
Views: 687
Posted By rcbuggy88

which spacer?

which spacer?
Forum: Rookie Zone
10-11-2018, 02:40 PM
Replies: 9
Views: 386
Posted By rcbuggy88

Depends on the condition. Amain had it for $180...

Depends on the condition. Amain had it for $180 new awhile back. The motor is worth $50-70 in good condition and the bodies depend on condition and color scheme.
Forum: Rookie Zone
10-11-2018, 02:37 PM
Replies: 10
Views: 413
Posted By rcbuggy88

Not necessary. This works pretty well for me, but...

Not necessary. This works pretty well for me, but I only break in treads and only wear the line in the middle.
https://www.amainhobbies.com/gravity-rc-off-road-tire-break-in-kit-grc279/p632567
Forum: Rookie Zone
10-11-2018, 02:34 PM
Replies: 15
Views: 694
Posted By rcbuggy88

Maybe you need to recalibrate the remote, or you...

Maybe you need to recalibrate the remote, or you might have it on training mode.
10-11-2018, 02:32 PM
Replies: 19
Views: 1,831
Posted By rcbuggy88

There is downforce. It does matter and does make...

There is downforce. It does matter and does make a difference.
10-11-2018, 02:30 PM
Replies: 5
Views: 804
Posted By rcbuggy88

The best in my opinion are either OS or Reds....

The best in my opinion are either OS or Reds. Also, a lot of the engines are OS based so...
Forum: Nitro On-Road
10-11-2018, 02:28 PM
Replies: 32
Views: 6,586
Posted By rcbuggy88

I am adding relevant links that have not yet been...

I am adding relevant links that have not yet been posted. I think this is adding to the wiki. :rolleyes:
Showing results 1 to 25 of 476
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service