Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: ThunderPowerRC
Showing results 1 to 25 of 100
Search took 0.09 seconds.
07-28-2013, 04:51 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

Try this with a blue rotor: Boost Timing: 40...

Try this with a blue rotor:

Boost Timing: 40
BT Start RPM: 6000
BT End RPM: 19500
BT Slope: Linear
BT by TH: NO
Turbo Timing: 24 Degrees
Turbo Activation: FULL THROTTLE
Full Throttle Delay:...
07-28-2013, 04:39 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

No you want to be somewhere around 3.5-3.6 FDR...

No you want to be somewhere around 3.5-3.6 FDR with the red rotor @ 35* timing. If you go with the blue rotor then you can go 3.3 - 3.4.
07-27-2013, 11:01 AM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

Could be a slight magnetic unbalance in the...

Could be a slight magnetic unbalance in the stator or rotor. As long as it runs fine it should be no problem. Otherwise you can try another stator.
07-27-2013, 10:57 AM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

Because the Z3R uses a smaller rotor it needs to...

Because the Z3R uses a smaller rotor it needs to be gears lower than the other motors you mentioned. You can also change to the Blue tuning rotor.



There are a number of things in the works....
07-15-2013, 06:13 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

Because Kv numbers for slotted sensor motors are...

Because Kv numbers for slotted sensor motors are subjective. Stator design, rotor type and strength, motor timing all effect Kv. Most numbers are made up. This is why we donít publish numbers. ...
07-02-2013, 07:48 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

If you look at Viktor Wilck's results from ETS...

If you look at Viktor Wilck's results from ETS you can see he runs some of the fastest lap times.
02-24-2013, 04:44 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

Always start at 20deg. Never go below 15deg on...

Always start at 20deg. Never go below 15deg on the motor. If you are running no boost, set timing at 30deg and gear fro temp. If you are using boost, again start at 20deg and adjust timing in ESC.
12-15-2012, 10:44 AM
Replies: 2,761
Views: 399,049
Posted By ThunderPowerRC

It is most likely looking for a connection...

It is most likely looking for a connection through the balance port. Turn the balance off under settings mode. You can also make a balance wire that connects to your charge leads. This will give you...
11-05-2012, 06:45 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

You can swap any 10.5/13.5/17.5/21.5 stator into...

You can swap any 10.5/13.5/17.5/21.5 stator into any stock spec or modified can. You cannot put a mod stator 9.5t or less into a stock spec can because the stator length is longer for the modified...
09-18-2012, 07:11 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

OK, FYI all motors come set at 20*. This is true...

OK, FYI all motors come set at 20*. This is true timing as close as you can get.
07-20-2012, 03:26 AM
Replies: 460
Views: 59,794
Posted By ThunderPowerRC

Ok the events can begain, there was a Dirla...

Ok the events can begain, there was a Dirla sigting this morning in the hotel. Paul and I had breakfast, now paul is working on his beauty sleep. :p
06-23-2012, 10:29 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

The temps are within the range it should be. The...

The temps are within the range it should be. The only way to test the rotor is with a gauss meter. Same for the stator if you can check with a resistance meter. If one pole has gone bad you will see...
06-03-2012, 05:14 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

Let me try to explain, winds 7.5t to 21.5t have a...

Let me try to explain, winds 7.5t to 21.5t have a shorter stator than the modified 3.5 to 6.6t motors. There are two different cans for the motors. One for stock and one for mod. So the short answer...
05-29-2012, 06:35 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

what we call 0 winds are used where you dont need...

what we call 0 winds are used where you dont need to go a whole wind for power as they are 1/2 wind less.
05-29-2012, 06:21 PM
Replies: 358
Views: 49,072
Posted By ThunderPowerRC

I'mnot sure you knew where you were all weekend....

I'mnot sure you knew where you were all weekend. ;)
04-11-2012, 11:07 AM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

What we have found is the taller the gear the...

What we have found is the taller the gear the less timing you need to use. In non boost 35deg seams to be the magic number. I wouldn't go more that 38deg. As all it will do is cause heat. We also run...
04-10-2012, 02:39 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

We do not publish Kv numbers for our motors as...

We do not publish Kv numbers for our motors as there are too many variables in the readings with sensored motors. Temp, timing, rotor can all effect the output.

Regarding settings, 8.5t is not...
04-10-2012, 02:34 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

We use the Epic gauss meter here. We dont publish...

We use the Epic gauss meter here. We dont publish gauss numbers as there are differences in meters and rotors. You can not just go off gauss readings by themselfs as air gap also plays a big role....
04-04-2012, 10:12 AM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

They have an order in. We are currently waiting...

They have an order in. We are currently waiting on motors to arrive so we can ship orders. Hopefully real soon.
04-03-2012, 01:18 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

Schumacher Racing Products Ltd is the new...

Schumacher Racing Products Ltd is the new official UK dist for TPRC products.
03-31-2012, 10:19 AM
Replies: 2,761
Views: 399,049
Posted By ThunderPowerRC

[QUOTE=Cult Racing;10537708]Do you have any pics...

[QUOTE=Cult Racing;10537708]Do you have any pics of the new Thunder Power Z3R-550 motor?[/QUOTE

http://i257.photobucket.com/albums/hh205/vegasjim_racing/IMG_7620.jpg

...
03-29-2012, 10:00 AM
Replies: 1,090
Views: 112,400
Posted By ThunderPowerRC

Room booked (at home), full tank of gas, ready to...

Room booked (at home), full tank of gas, ready to make the 5 mile trip. Are we there yet.
03-28-2012, 12:58 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

All of the motors were submited to Paul Worsley...

All of the motors were submited to Paul Worsley at BRCA along with all of the tuning rotors. paul was waiting on the UK dist to notify him they had them in stock. They never ordered the rotors and no...
03-13-2012, 03:18 PM
Replies: 774
Views: 73,820
Posted By ThunderPowerRC

As EA posted this has been up on the facebook and...

As EA posted this has been up on the facebook and ROAR public discussion thread since Feb 22. It shouldn't be that big of deal.
03-13-2012, 12:53 PM
Replies: 670
Views: 162,892
Posted By ThunderPowerRC

17.5 Boosted TC 30 motor 50 boost 15...

17.5 Boosted TC

30 motor
50 boost
15 turbo
5000 -14000 rpm
.1 delay
10 min throttle
10 min brake
2 ramp
Showing results 1 to 25 of 100
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.