Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: Teufel Racing
Showing results 1 to 25 of 500
Search took 1.84 seconds.
07-05-2019, 09:27 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

I have the 5.5 ones on both cars, but I think the...

I have the 5.5 ones on both cars, but I think the hit the arm took was enough that the arm split apart at the end, not sure the 6mm stopper would have helped. Lucky shot I'm guessing.
07-02-2019, 04:54 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

I sheared off a front arm over the weekend front...

I sheared off a front arm over the weekend front tagging the wall and slightly tweaked the new v2 caster block in the process, along with killing the steering link mount onnthe knucle. Not a lot of...
07-02-2019, 04:47 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

If Mugen does decide to go the mid motor route, ...

If Mugen does decide to go the mid motor route,
new belts front and rear, new chassis, and new top deck are the minimum needed things to do it, possibly a new motor mount maybe required. As it...
06-06-2019, 09:41 AM
Replies: 18
Views: 4,019
Posted By Teufel Racing

Probably, But I almost TQ'd signups and for...

Probably,
But I almost TQ'd signups and for sure got a podium on signups, so it seems you got some catching up to do too..������
06-05-2019, 11:01 PM
Replies: 18
Views: 4,019
Posted By Teufel Racing

I'm in, Should be good times

I'm in,
Should be good times
06-03-2019, 12:11 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

the blades go with the alum outdrives on the car....

the blades go with the alum outdrives on the car. Stock in the rear, option part for the front. There is a steel front outdrives option, but I don't know if it works with the blades. As for other...
06-02-2019, 02:49 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

what calass your running? Mod TC, the spur gear...

what calass your running? Mod TC, the spur gear seems to be 110-114 I think, 17.5, likely 102-108 maybe, and 21.5/USGT 102-104. At least those are the general ranges I have or have run. All in 64p.
06-02-2019, 02:46 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

i know there's a few that fit. Axon TC spurs is...

i know there's a few that fit. Axon TC spurs is wat I use and I think what a lot of racers use at the local on-road track.

There's a number of places on line that carries them. Amain and Ulti...
05-29-2019, 10:53 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

Hard to say for sure, as it can be track...

Hard to say for sure, as it can be track dependent or grip dependent, and class dependent
Xray:
2.6, 2.7, 2.8, and 2.9 would be good to have on hand. If you want the progressive ones, the 2.3-2.6...
05-28-2019, 03:05 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

belt tensioner part no. A2223 ...

belt tensioner
part no. A2223

https://cimg8.ibsrv.net/gimg/www.rctech.net-vbulletin/2000x1504/img_0917_f1474edc8fbbd0a7fa61a301fe2d369a0ef8aad1.png
05-28-2019, 02:56 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

Correct, With TC's currently it's the...

Correct,
With TC's currently it's the opposite. There a few brands of springs most seem to use for TC regardless of chassis. Xray, SMJ, and Axon are the few I've seen ran with xray being the most...
05-27-2019, 09:48 AM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

smaller the number of the shock springs, the...

smaller the number of the shock springs, the softer the spring rate.
05-27-2019, 09:45 AM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

if I understand your question correctly, no...

if I understand your question correctly,
no you can't use 64 pitch with a 48 pitch gears. Have to be the same pitch for both the spur gear and pinion. I think most everyone uses 64 pitch in...
05-27-2019, 09:42 AM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

general spares for the car are the usual stuff to...

general spares for the car are the usual stuff to have,
arms and steering knuckles, extra sway bars (at least the 1.3 rear), maybe a set of belts just in case.

not sure anything on the car is...
05-23-2019, 04:29 PM
Replies: 4
Views: 959
Posted By Teufel Racing

You can either use blocks and then a drop gauge...

You can either use blocks and then a drop gauge to measure droop or just place the chassis flat on the setup board and use a ride height gauge to measure droop. Using the blocks gets the chassis up...
05-15-2019, 10:45 AM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

the one one piece top deck is almost a must, if...

the one one piece top deck is almost a must,
if you want the newer top deck with the pitch rod setup on it you can go that route for sure and can use it with the old front end with a slight mod to...
04-25-2019, 02:35 PM
Replies: 1,583
Views: 379,538
Posted By Teufel Racing

i just got in a couple A2002 performance kits in,...

i just got in a couple A2002 performance kits in, as they'd been backordered at Mugen USA for a bit and both my kits did come with the updated blocks. So if ordered from there, I think it's safe to...
01-25-2019, 10:31 AM
Replies: 759
Views: 167,738
Posted By Teufel Racing

yes sir, but many don't care for the smell these...

yes sir, but many don't care for the smell these days and I don't fully blame them. Between that paragon and the old Buggy grip, I've sure had my fill. Lol
01-24-2019, 08:32 PM
Replies: 759
Views: 167,738
Posted By Teufel Racing

some of the old school sauce stash I got. Lol

some of the old school sauce stash I got. Lol
01-24-2019, 12:57 PM
Replies: 759
Views: 167,738
Posted By Teufel Racing

https://cimg0.ibsrv.net/gimg/www.rctech.net-vbulle...

https://cimg0.ibsrv.net/gimg/www.rctech.net-vbulletin/1500x2000/2c395d22_7ea9_492d_8ba0_9dcf06e48f6a_abfeca1e18de5e6317e2ac21e9b4825c780f9a5b.jpeg
JP8 HR almost ready to get beat up.
Forum: Racing Forum
01-21-2019, 03:13 PM
Replies: 617
Views: 94,144
Posted By Teufel Racing

Had a good time, Was a bit discouraged at the...

Had a good time,
Was a bit discouraged at the start not knowing what things I needed to do but with a lot of help and suggestions from some racers more versed in mod and/or black carpet, cars got...
Forum: Racing Forum
12-30-2018, 09:47 AM
Replies: 617
Views: 94,144
Posted By Teufel Racing

Getting there as far as being ready, Still a...

Getting there as far as being ready,
Still a bit more to do when I have a bit of time, but should be ready enough in time to get a good beating. Lol
Round 1, signed up, paid up, room booked. Can't...
12-25-2018, 02:34 PM
Replies: 9
Views: 993
Posted By Teufel Racing

Got 4 of their precut/pretrimmed bodies and they...

Got 4 of their precut/pretrimmed bodies and they sure do make things much easier. Picked up a couple JP8's that I now have to mount manually (they announced the precut/pretrimmed JP8's after I...
12-19-2018, 10:04 PM
Replies: 759
Views: 167,738
Posted By Teufel Racing

https://cimg2.ibsrv.net/gimg/www.rctech.net-vbulle...

https://cimg2.ibsrv.net/gimg/www.rctech.net-vbulletin/960x2000/e8c5b609_4681_47a0_89f4_03a5461edad2_03fea2ca85a75d2c4492fefb918ce46ccc08081a.jpeg...
Forum: Racing Forum
12-18-2018, 10:47 AM
Replies: 617
Views: 94,144
Posted By Teufel Racing

nice, should be a good time

nice,
should be a good time
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service