Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: Ramyuras
Showing results 1 to 25 of 468
Search took 0.12 seconds.
Forum: Racing Forum
08-28-2012, 06:08 AM
Replies: 1,309
Views: 71,334
Posted By Ramyuras

what are the rules for VTA? what motors and tires...

what are the rules for VTA? what motors and tires will the track be using?
07-29-2012, 08:08 AM
Replies: 4,239
Views: 652,640
Posted By Ramyuras

Yea sound more than bad luck, the fact is that...

Yea sound more than bad luck, the fact is that the car is as good as the others, I think the drivers are not of the caliber as the other teams.
03-02-2010, 09:26 AM
Replies: 126
Views: 20,022
Posted By Ramyuras

Thanks guys.

Thanks guys.
03-02-2010, 06:08 AM
Replies: 126
Views: 20,022
Posted By Ramyuras

Had my first run with the link car and was...

Had my first run with the link car and was disappointed did eveything that was suggested and the car was twitchy tried different tires but the car just didn't feel the same as my Tbar car. I will...
02-18-2010, 09:17 AM
Replies: 126
Views: 20,022
Posted By Ramyuras

I did the front spring and it was too long the...

I did the front spring and it was too long the shaft would hit the wheel and if you shim it up the tension would be too much. I would like to see what EA did with his setup.
02-18-2010, 06:11 AM
Replies: 23,359
Views: 2,444,780
Posted By Ramyuras

I was going over the setup on the Tekin site and...

I was going over the setup on the Tekin site and notice the touring starting and ending rev's are higher than the 1/12 cars, I would like to know what would be a good starting point with 1 cell lipo...
02-17-2010, 10:06 AM
Replies: 23,359
Views: 2,444,780
Posted By Ramyuras

Thank guys.

Thank guys.
02-17-2010, 09:13 AM
Replies: 23,359
Views: 2,444,780
Posted By Ramyuras

Thank you, so for 1 cell should I set it a 1.0?

Thank you, so for 1 cell should I set it a 1.0?
02-17-2010, 07:59 AM
Replies: 23,359
Views: 2,444,780
Posted By Ramyuras

How do you set the voltage cutoff for 1 cell? I...

How do you set the voltage cutoff for 1 cell? I tried and with not success.
02-09-2010, 05:40 PM
Replies: 3,480
Views: 513,396
Posted By Ramyuras

I notice my car is a little lazy with the -0.75,...

I notice my car is a little lazy with the -0.75, I was thinking to use the +0.75 and see how that would feel. I will try your suggestion.
02-09-2010, 02:59 PM
Replies: 7,740
Views: 534,452
Posted By Ramyuras

Eric, can you give your setup with the XRay Link...

Eric, can you give your setup with the XRay Link 11/2.
02-09-2010, 04:00 AM
Replies: 3,480
Views: 513,396
Posted By Ramyuras

My push is low to med speed, using 17.5 I will...

My push is low to med speed, using 17.5 I will try less camber gain, the car is 1420 and 25 grams rear right side and 25 grams left front. The car is balance side to side and front to rear. TY
02-08-2010, 09:01 AM
Replies: 3,480
Views: 513,396
Posted By Ramyuras

None.

None.
02-08-2010, 06:50 AM
Replies: 3,480
Views: 513,396
Posted By Ramyuras

Need a little help here with my T3 the setup I...

Need a little help here with my T3 the setup I have is the base rubber that comes with the manual, I am using rubber on carpet the car is ok in the rear but the car push a little on entry in the...
01-07-2010, 06:36 PM
Replies: 3,480
Views: 513,396
Posted By Ramyuras

I am not sure what to get the t2 009 or t3 most...

I am not sure what to get the t2 009 or t3 most of the guys that went from the 009 to the t3 are doing worst when using rubber on carpet are most of you t3 guys seeing the same result? I know the t3...
12-17-2009, 06:31 AM
Replies: 19,762
Views: 1,783,319
Posted By Ramyuras

Is there a setup for Barry 13.5 car? if yes...

Is there a setup for Barry 13.5 car? if yes please post.
12-16-2009, 09:25 AM
Replies: 19,762
Views: 1,783,319
Posted By Ramyuras

The difference is the 13.5 is faster on the...

The difference is the 13.5 is faster on the straight, but I have seen 17.5 do less lap time than 13.5 in the right hands.
12-16-2009, 09:10 AM
Replies: 19,762
Views: 1,783,319
Posted By Ramyuras

Thank you. This setup is for mod is it ok for...

Thank you. This setup is for mod is it ok for 17.5?
12-16-2009, 05:18 AM
Replies: 19,762
Views: 1,783,319
Posted By Ramyuras

I am using Andy's 2008 setup, where can I fine...

I am using Andy's 2008 setup, where can I fine the 2009 setup?
12-15-2009, 08:40 PM
Replies: 19,762
Views: 1,783,319
Posted By Ramyuras

Need a good setup for carpet rubber 17.5/13.5....

Need a good setup for carpet rubber 17.5/13.5. The setup I am using is not working out for me my rear keep spinning out in tight corners.
12-08-2009, 05:59 AM
Replies: 3,480
Views: 513,396
Posted By Ramyuras

Just want opinion on the T3 compare to the 009...

Just want opinion on the T3 compare to the 009 using rubber on carpet, is it faster or easer to drive?
11-16-2009, 07:51 AM
Replies: 13,519
Views: 1,361,682
Posted By Ramyuras

I need a little help with my gearing I am using a...

I need a little help with my gearing I am using a 5.5 motor what gearing should I start with using the stock spur?
11-02-2009, 11:59 AM
Replies: 10,622
Views: 1,361,133
Posted By Ramyuras

Thank you for helping.

Thank you for helping.
11-02-2009, 06:11 AM
Replies: 10,622
Views: 1,361,133
Posted By Ramyuras

I am looking for more steering entering tight...

I am looking for more steering entering tight corner using rubber tire on carpet
the car works good but just a tad more steering will be nice, any suggestion.

Thanks.
11-01-2009, 08:06 PM
Replies: 1,996
Views: 504,740
Posted By Ramyuras

I have my car working good the only problem I am...

I have my car working good the only problem I am having is I need more steering entering tight corners, running rubber on carpet any suggestion.
Showing results 1 to 25 of 468
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.