Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: VulvaS40T4
Showing results 1 to 25 of 51
Search took 0.05 seconds.
10-30-2019, 04:58 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Change universal joint axles front and rear and...

Change universal joint axles front and rear and use 75spring/70wt in front and 45spring/40wt rear. Then it wont bottom out on landing and you get even more steering and grip. :)
Also build shock...
09-14-2019, 02:29 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

This buggy is very sensitive to setup changes and...

This buggy is very sensitive to setup changes and when you get it right is super easy to drive and fast. I like lots of on-power steering and predictable off-power steering. I think if you have...
09-09-2019, 11:37 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Here is my final fine tuned base setup for d418...

Here is my final fine tuned base setup for d418 on various tracks and condition. From low grip bumpy astro to smooth low grip indoor tracks. Works like dream. :)
Took hole summer to finalize this...
09-08-2019, 03:14 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

yes those are annoying.I bought before build...

yes those are annoying.I bought before build those exotek ones.You should buy those 70/40 springs also because those stock 60/35 are too soft.
09-07-2019, 03:25 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

No need for washer on bleeder screws and you need...

No need for washer on bleeder screws and you need to buy shock oils your self.10/100/10 is good diff oil for higher grip. No need to take of spring rate stickers.Use 70 on front spring and 40 on rear...
09-07-2019, 01:29 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Cannot wait your review of this. :) When you...

Cannot wait your review of this. :)

When you build this i recommend to use this setup:

David Ronnefalk (http://www.davidronnefalk.com/setups/view/35)
06-27-2019, 07:18 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

I had exotex steering rad and bought also hb...

I had exotex steering rad and bought also hb aluminium rack. Only difference is that you dont need 1mm shim to get stock geometry and you can have on carpet much more accerman by reversing rack. So...
06-23-2019, 04:24 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

We have to move front carbon shock tower part 3mm...

We have to move front carbon shock tower part 3mm more towards front and drill new holes to that. It should be similar like my mod so front has more grip and softer feeling. :)
06-15-2019, 02:46 PM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

http://site.petitrc.com/setup/hotbodies/setupd418/...

http://site.petitrc.com/setup/hotbodies/setupd418/D418_DavidRonnefalk_OCRC2019012527/
06-13-2019, 10:52 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Its from my own d418.Yes shocks are attached to...

Its from my own d418.Yes shocks are attached to shock tower hole and 3mm spacer to line shocks on better angle.It has like 3mm more downtravel than normal inside shock position. :)
06-12-2019, 05:14 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

https://cimg7.ibsrv.net/gimg/www.rctech.net-vbulle...

https://cimg7.ibsrv.net/gimg/www.rctech.net-vbulletin/2000x1124/20190611_141613_e290035565b1612c332bbcbd901a5b6a7344772d.jpg

Custom front shock tower like ronnefalk uses. :) Much smoother steering...
04-27-2019, 05:34 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Like this. :) ...

Like this. :)
http://www.rctech.net/forum/attachments/electric-off-road/1122979d1381939069-hot-bodies-d413-1-10-4wd-buggy-droop-adjust.jpg
04-26-2019, 10:19 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Difference is roll center only but same kickup....

Difference is roll center only but same kickup. More dots lower rollcenter and less dots higher roll center.
04-23-2019, 04:13 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Heres my fine tuned astroturf setup for D418....

Heres my fine tuned astroturf setup for D418. Easy to drive and fast. ;)
...
04-09-2019, 09:46 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Had earlier Hobbywing G3 V10 6.5T motor in my...

Had earlier Hobbywing G3 V10 6.5T motor in my D418 and it even on slippery tracks required 10degree boost timing to go fast enough. Now new 5.5t orion ultimate mod goes better even without boost. :D...
03-17-2019, 05:33 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

I have raced many times in vaasa indoor track and...

I have raced many times in vaasa indoor track and next weekend we have big indoor race in there. :) Its only 120km from kokkola.
03-17-2019, 02:33 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

We drive indoor concrete or wooden floors which...

We drive indoor concrete or wooden floors which are like very slippery. :) Similar grip like outdoor clay so grip is very low. Tires are Schumacher Mini pin front and rear which is official tire on...
03-16-2019, 06:47 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

https://cimg6.ibsrv.net/gimg/www.rctech.net-vbulle...

https://cimg6.ibsrv.net/gimg/www.rctech.net-vbulletin/686x902/d4182019setup_9c9275cd5254471015d1182439a68eeed790a0f6.jpg
...
02-04-2019, 10:46 PM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Correct :)

Correct :)
02-04-2019, 10:51 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Its always x-ring on those packages even pictures...

Its always x-ring on those packages even pictures show o-rings. Its updatet like 2014 or something. Those are 3dollars pack :)
02-02-2019, 07:38 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Stock shocks have 2 yellow o-rings. Change those...

Stock shocks have 2 yellow o-rings. Change those to Traxxas x-rings. Much smoother and cheap also and does not leak. :)

https://www.amainhobbies.com/traxxas-shock-rebuild-kit-tra2362/p45156
01-20-2019, 10:01 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Now my D418 is dialed for low grip smooth indoor...

Now my D418 is dialed for low grip smooth indoor tracks here in Finland :) Setup pdf included.
12-29-2018, 10:26 AM
Replies: 3
Views: 493
Posted By VulvaS40T4

Same moto on my D418 hb and with stock settings...

Same moto on my D418 hb and with stock settings its has not enough power with 30degree belltiming. BUT after you but 10degree more timing via boost or turbo its rocket ship. :) So use you esc and but...
12-17-2018, 11:53 AM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Today installed hb slipper clutch and like it...

Today installed hb slipper clutch and like it very much compared to center diff. Its much more concistend to drive with mod 6.5t motor than center diff even with 500k fluid. This is on low grip...
12-16-2018, 10:09 PM
Replies: 545
Views: 105,891
Posted By VulvaS40T4

Yes :)

Yes :)
Showing results 1 to 25 of 51
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.