Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: Racer56556
Showing results 1 to 25 of 129
Search took 0.07 seconds.
04-03-2019, 10:13 AM
Replies: 11
Views: 961
Posted By Racer56556

This has probably caused the rotor to become week...

This has probably caused the rotor to become week . I can feel some fade anything over 145 and try and keep it under that . 185 is defiantly too hot even more so if this was measured on the end bell...
03-28-2019, 12:38 PM
Replies: 2
Views: 342
Posted By Racer56556

I don't like these mounts for this reason and...

I don't like these mounts for this reason and also some mounts have the fan too close to the motor can cause the fan to "back up" and not flow as much air . If running a slipper eliminator just tape...
03-28-2019, 12:23 PM
Replies: 15
Views: 352
Posted By Racer56556

I would stick with the brushed motor for a few...

I would stick with the brushed motor for a few reasons . a lot of the "cheaper" brushless setups are very fast and waterproof systems tend to be expensive. second is the brushed motors don't really...
03-20-2019, 11:56 AM
Replies: 10
Views: 775
Posted By Racer56556

Probably a taller ride height gauge

Probably a taller ride height gauge
03-20-2019, 11:47 AM
Replies: 6
Views: 508
Posted By Racer56556

The v1 and v2 springs act differently from each...

The v1 and v2 springs act differently from each other so you need to take that into account when going back and forth from v1 and v2 springs . example the v2 white rear spring feels stiffer than a v1...
03-18-2019, 09:43 AM
Replies: 6
Views: 497
Posted By Racer56556

I have the transponder mounted both sideways and...

I have the transponder mounted both sideways and flat and have had no issues at any tracks . The race director should be able to tell if you have a weak signal but I am not positive on that but have...
03-18-2019, 09:31 AM
Replies: 14
Views: 801
Posted By Racer56556

I would go with a icharger 406 this is what I...

I would go with a icharger 406 this is what I have , It is expensive but it is defiantly worth the price and you wont need to upgrade down the road . Have herd good things about the icharger x6 witch...
03-15-2019, 10:47 AM
Replies: 0
Views: 248
Posted By Racer56556

Losi 4.0 ARTR setup for stock

https://cimg7.ibsrv.net/gimg/www.rctech.net-vbulletin/480x640/a249bfcf_4b9c_43a0_a95e_9e9e153efd52_1985abb5e55a3d401a1e5144ed90df0e97107291.jpeg...
03-11-2019, 01:14 PM
Replies: 393
Views: 27,680
Posted By Racer56556

Just curious where is this track located . I...

Just curious where is this track located . I couldn't see a indoor track surviving on track fees alone in my area . I do agree 8th scale and 4wd SCT are for outdoor and honestly dangerous at a most...
03-06-2019, 10:23 AM
Replies: 27
Views: 1,500
Posted By Racer56556

Being a losi fan go with a tlr5.0sr (stock racer)...

Being a losi fan go with a tlr5.0sr (stock racer) . If on a budget go with hobbywing justock esc but the xr10 pro stock is what i would suggest and what I run . for a motor just make sure its one of...
03-06-2019, 08:59 AM
Replies: 25
Views: 754
Posted By Racer56556

A few things you could do . 1 put some spacers...

A few things you could do . 1 put some spacers under the tower to raise it up . I saw this done a while back on a losi team drivers setup . basically making the tower taller lowering the ride height...
03-05-2019, 12:13 PM
Replies: 25
Views: 754
Posted By Racer56556

I don't suggest cutting springs because it...

I don't suggest cutting springs because it changes the rate . Are you running the lowest spring cups already ? what car is this on ?
03-05-2019, 12:08 PM
Replies: 22
Views: 1,879
Posted By Racer56556

I would suggest using steel bones they wont brake...

I would suggest using steel bones they wont brake and doubt you will notice the difference . I tried the exotek pins before on clay and they lasted 2 runs but maybe they have changed the material ?...
02-04-2019, 12:45 PM
Replies: 9
Views: 996
Posted By Racer56556

comparing a B4 to a B6.1 is a little to far apart...

comparing a B4 to a B6.1 is a little to far apart . A B4.2 or a B5 would be a more equal comparison . All these have 12mm shocks witch was a big improvement over the small bodied shocks on the b4 ....
01-29-2019, 04:26 PM
Replies: 4
Views: 419
Posted By Racer56556

The guys at SDRC are super cool and suggest going...

The guys at SDRC are super cool and suggest going to them for whatever you need . For budget I would suggest a hobbywing justock esc and the reedy s+,r1 v21,tekin spec-R all good motors . SDRC has...
01-29-2019, 04:11 PM
Replies: 3
Views: 450
Posted By Racer56556

Almost everyone seems to use the plano lackjaw...

Almost everyone seems to use the plano lackjaw case as a toolbox .
01-29-2019, 04:06 PM
Replies: 24
Views: 1,078
Posted By Racer56556

That was awesome didn't skip a beat .

That was awesome didn't skip a beat .
01-29-2019, 02:35 PM
Replies: 41
Views: 3,240
Posted By Racer56556

This is interesting I have had the best luck with...

This is interesting I have had the best luck with protek batterys . They seem to stay at a lower Ir for more cycles than others i have tried . I have used gen ace,reedy,smc, orion and a few others...
01-29-2019, 01:25 PM
Replies: 24
Views: 1,078
Posted By Racer56556

Passing points would make scoring to complicated...

Passing points would make scoring to complicated in my opinion . Im not sure how they sort the field but something like a inversion would be a little better than a re-sort . maybe win one round start...
01-29-2019, 01:03 PM
Replies: 26
Views: 1,675
Posted By Racer56556

I run on med to high bite clay and the single...

I run on med to high bite clay and the single best thing I did that i instantly felt is was using +2 avid steering plates . really calmed down the steering i also have 1mm under the ball stud on the...
01-25-2019, 12:16 PM
Replies: 7
Views: 598
Posted By Racer56556

For homemade sauce liquid wrench yellow or pb...

For homemade sauce liquid wrench yellow or pb blaster both work pretty good but if not careful can balloon the tires . I use Trackstar Gold and Black and they work great . use gold to brake in tires...
01-23-2019, 10:46 AM
Replies: 32
Views: 3,734
Posted By Racer56556

Get a setup off of petit or team associated and...

Get a setup off of petit or team associated and start there first start there the pros are "pros" for a reason and is always a good place to start , Or talk to a local fast guy running a associated...
01-23-2019, 10:07 AM
Replies: 13
Views: 752
Posted By Racer56556

A friend of mine just picked up the sky rc scales...

A friend of mine just picked up the sky rc scales . we got the left to right even at 50/50 even tho they were not to far off to begin with (49/51) . The most interesting thing is adding weight we...
01-16-2019, 10:58 AM
Replies: 9
Views: 619
Posted By Racer56556

Go to the track and see what cars they support...

Go to the track and see what cars they support and whats popular first and then look here in the marketplace for deals . That is probably going to be the cheapest way to get back into the sport . I...
01-09-2019, 02:56 PM
Replies: 21
Views: 1,392
Posted By Racer56556

Simple Green to clean with and spray it with...

Simple Green to clean with and spray it with Maxima SC1 . SC1 = New car in a can lol . plus it helps the dirt release when it gets dirty
Showing results 1 to 25 of 129
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service