R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: Tsquare
Showing results 1 to 25 of 500
Search took 0.14 seconds.
03-14-2012, 02:31 PM
Replies: 2,610
Views: 685,576
Posted By Tsquare

Thanks for the reply, In the past when Tamiya...

Thanks for the reply, In the past when Tamiya released a newer version of an existing chassis, the thread would get filled with evaluations and comparisions vs the older version - I haven't seen...
03-13-2012, 06:46 PM
Replies: 2,610
Views: 685,576
Posted By Tsquare

Is this car better for 17.5 vs TA05 VII

Need some help.

After reading through most of this thread over the months - I am not feeling the love for this chassis as the previous TA0 series chassis's - What am I missing? Is it just not an...
09-12-2011, 10:07 PM
Replies: 13
Views: 2,549
Posted By Tsquare

Thanks for the reply. My packs roll about 1\16...

Thanks for the reply. My packs roll about 1\16 of an inch to each side when on the bottom of the case.

I like both Associated and Orion products and have no problems with the companies. I have...
09-12-2011, 09:03 PM
Replies: 13
Views: 2,549
Posted By Tsquare

Good information. :nod: My question is, I...

Good information. :nod:

My question is, I recently had two of my best Lipo hard packs look to have slightly puffed
in the middle of the hard pack casing, the cases have not separated but feel /...
09-08-2011, 09:08 AM
Replies: 6
Views: 2,223
Posted By Tsquare

The first two do not apply, the third does apply...

The first two do not apply, the third does apply - I have stored these batteries with a full charge, but I have done the same with my other lipo batteries in the past and no puffy problems.

I did...
09-07-2011, 09:45 PM
Replies: 2,946
Views: 501,116
Posted By Tsquare

These batteries do fit without grinding the...

These batteries do fit without grinding the chassis, all you need to do is put the battery in at a slight angle (the inside edge of the battery next to the belt drive will be slightly lower then the...
09-06-2011, 08:25 PM
Replies: 6
Views: 2,223
Posted By Tsquare

Sometimes full, sometimes partial. I treated...

Sometimes full, sometimes partial. I treated these batteries same as my others.
09-06-2011, 05:41 PM
Replies: 6
Views: 2,223
Posted By Tsquare

Common Lipo Battery Problem?

I recently had two of my best Lipo hard packs look to have expanded already. I have an Associated 5000/40C and a Orion 5000/45C hard packs, both are just 1 yr old. I do not abuse these packs,...
Forum: Racing Forum
06-22-2011, 02:10 PM
Replies: 22,400
Views: 1,917,414
Posted By Tsquare

How about Lrp TC Comp Sphere, LRP SXX Stock Comp,...

How about Lrp TC Comp Sphere, LRP SXX Stock Comp, or Tekin RS with Boost turned off?



+1
06-22-2011, 02:01 PM
Replies: 13
Views: 2,895
Posted By Tsquare

Tamiya is not the end of the world, they are just...

Tamiya is not the end of the world, they are just soft. As you tighten down the hex screws repeatedly, the hex's in the screws will deform and eventually have a tendency to strip.

Just be...
06-22-2011, 01:48 PM
Replies: 3,320
Views: 1,003,850
Posted By Tsquare

I believe it is 80 spur, 54 pinion:nod:

I believe it is 80 spur, 54 pinion:nod:
06-21-2011, 07:01 PM
Replies: 13
Views: 2,895
Posted By Tsquare

I am a big Tamiya RC fan, except when it comes to...

I am a big Tamiya RC fan, except when it comes to their titanium screws, too soft, the hex heads strip easily. :(
06-16-2011, 01:47 PM
Replies: 2,946
Views: 501,116
Posted By Tsquare

Tamiya yellow all around.

Tamiya yellow all around.
06-15-2011, 12:11 PM
Replies: 8
Views: 761
Posted By Tsquare

Thanks for the reply. I am glad to hear most cut...

Thanks for the reply. I am glad to hear most cut and change, that's what I would do. Wanted to be certain I was not opening a can of worms with cutting them off.

Thanks for the voltage check...
06-15-2011, 11:53 AM
Replies: 8
Views: 2,473
Posted By Tsquare

I do notice that charging action you describe...

I do notice that charging action you describe above as I balance my packs that have the most problems. I will continue to balance the packs see if they balance quicker, or if it turns out the packs...
06-14-2011, 10:09 PM
Replies: 8
Views: 2,473
Posted By Tsquare

If I see the charger sitting on .01 charge rate...

If I see the charger sitting on .01 charge rate for too long I stop the charge and check it with my stand alone balancer, the balance has been good each time I have done this.



I haven't taken...
06-14-2011, 04:19 PM
Replies: 8
Views: 2,473
Posted By Tsquare

Most of my packs are older (2 yrs plus) haven't...

Most of my packs are older (2 yrs plus) haven't repeated enough to notice of it is the same pack.



It does seem to me that the charger is going between trickle and balancing, maybe the older...
06-14-2011, 02:07 PM
Replies: 8
Views: 2,473
Posted By Tsquare

Is There something wrong with my Lipo Balancer?

I have a Hobbyking Quattro 4x6s Charger. I have had this charger for over two years, just started using it to balance my Lipo packs (before that I used a separate balancer)

Sometimes when I...
06-14-2011, 01:21 PM
Replies: 8
Views: 761
Posted By Tsquare

What are those connectors on the Hobbyking packs,...

What are those connectors on the Hobbyking packs, is there an adaptor if you use deans or do you just solder on new ones?
06-13-2011, 03:35 PM
Replies: 4,891
Views: 758,715
Posted By Tsquare

What motor / speed control pair are you running?

Going to build my TRF201X this week. Looking to run Mod, but have never run any 2wd buggy class (on-road and 2wd stock SC).

What is a good brushless motor and ESC combo for these buggies. Will...
Forum: Racing Forum
01-17-2011, 11:25 AM
Replies: 22,400
Views: 1,917,414
Posted By Tsquare

Another great day of Racing at Tamiya!!:nod: ...

Another great day of Racing at Tamiya!!:nod:

Thanks to all the hard work from the Tamiya people - my crew had a great time. Only wish we could do it more often :( :cry:

I give the spec tires...
12-09-2010, 03:38 PM
Replies: 6
Views: 2,980
Posted By Tsquare

Masa, What is price and availability for...

Masa,

What is price and availability for Tamiya Motor Systems, 45049, 45048 and 54274?

Thank you
Forum: Racing Forum
11-02-2010, 08:15 PM
Replies: 22,400
Views: 1,917,414
Posted By Tsquare

If you want to limit costs, allow 2 sets of tires...

If you want to limit costs, allow 2 sets of tires for quals and first main, for triple mains allow one more set.

As far as new motor rules, Tamiya brushless motor set $200.00. I spent more than...
Forum: Racing Forum
11-01-2010, 04:50 PM
Replies: 22,400
Views: 1,917,414
Posted By Tsquare

The more spec the better, even if it costs a bit...

The more spec the better, even if it costs a bit more it is worth it. IMHO, 1 - brand brushless, 1 - premounted spec tire and leave the rules for body, chassis and hop-ups alone for the two year...
10-08-2010, 07:06 PM
Replies: 16
Views: 1,988
Posted By Tsquare

Just a FYI - Just purchased the standard...

Just a FYI - Just purchased the standard Associated SC10 Kit at Tower Hobbies for $138.00 less $20.00 coupon for a total cost of 118.00. It's not the FT SC10, but at that price it is easy to make the...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.