R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: PorTX
Showing results 1 to 25 of 500
Search took 0.32 seconds.
07-04-2020, 09:21 AM
Replies: 2
Views: 213
Posted By PorTX

Most 1/8 scale tracks are 10 foot lane minimum...

Most 1/8 scale tracks are 10 foot lane minimum width. That is just over 3 meters.
07-02-2020, 10:06 PM
Replies: 1,110
Views: 213,832
Posted By PorTX

Grey rod ends, carbon front arm inserts, front...

Grey rod ends, carbon front arm inserts, front universals, longer rear center driveshaft, 10mm wing shim and a spring assortment.
06-17-2020, 08:33 PM
Replies: 22
Views: 1,092
Posted By PorTX

Likely pinned the throttle while upside down or...

Likely pinned the throttle while upside down or on it side when all the power went to one wheel....or an air hose....
06-15-2020, 05:21 PM
Replies: 675
Views: 130,629
Posted By PorTX

Thanks. I may give it a try. I am on the fence...

Thanks. I may give it a try. I am on the fence about it since I have my steering turned down with the stock chassis.
06-15-2020, 01:19 PM
Replies: 675
Views: 130,629
Posted By PorTX

For those that have switched to the -3mm chassis....

For those that have switched to the -3mm chassis. Is it better for high grip or low grip tracks? Seems that a shorter wheelbase would help mainly on tight tracks more than large outdoor tracks? ...
01-07-2020, 05:41 PM
Replies: 675
Views: 130,629
Posted By PorTX

I would pull the housing back apart and check to...

I would pull the housing back apart and check to make sure the ring gear is seated evenly on the diff case itself. Make sure all the 2.0mm screws are equally tight through the ring gear and into the...
01-07-2020, 05:26 PM
Replies: 675
Views: 130,629
Posted By PorTX

How is the mesh? Hold the outdrive (you were...

How is the mesh? Hold the outdrive (you were spinning) and rock the ring gear back and forth. There should be very little play there.
01-04-2020, 09:29 PM
Replies: 675
Views: 130,629
Posted By PorTX

Looks like April of 2020 Team Losi Racing...

Looks like April of 2020

Team Losi Racing (http://www.tlracing.com/Products/Default.aspx?ProdID=TLR242035)
01-04-2020, 05:48 PM
Replies: 675
Views: 130,629
Posted By PorTX

I am waiting to see the “deep yoke” driveshafts...

I am waiting to see the “deep yoke” driveshafts first, before I buy the aluminum rear hubs. If the axle is better supported by a bearing in the hub, yes. Both the hubs and deep yoke driveshafts will...
01-03-2020, 02:38 AM
Replies: 675
Views: 130,629
Posted By PorTX

You want the rear arms to flex a bit more to...

You want the rear arms to flex a bit more to generate more grip. The front aluminum brace was to help gain steering but the XE has plenty. I recently bought the aluminum steering brace but haven’t...
01-02-2020, 09:12 PM
Replies: 675
Views: 130,629
Posted By PorTX

Carbon front arm inserts, front universals and a...

Carbon front arm inserts, front universals and a spring assortment!
12-29-2019, 08:18 PM
Replies: 3,699
Views: 734,718
Posted By PorTX

PM sent....really appreciate the offer for help!

PM sent....really appreciate the offer for help!
12-29-2019, 05:30 PM
Replies: 3,699
Views: 734,718
Posted By PorTX

Never broke a front axle. You really donít have...

Never broke a front axle. You really donít have to crank down on the fronts of a 2wd car. 4wd on high grip you definitely want to use a serrated nut and/or lock tight if you run a lot of brake.
12-29-2019, 04:49 PM
Replies: 3,699
Views: 734,718
Posted By PorTX

I was planning to get some AKA scribbles before...

I was planning to get some AKA scribbles before this race. However they never became available to the average guy. I did get some positrons and octagons so we will see how those do this time...
12-29-2019, 11:59 AM
Replies: 3,699
Views: 734,718
Posted By PorTX

I noticed while changing pistons, which I ended...

I noticed while changing pistons, which I ended up having 2x1.8ís in the front. Anyway, I noticed on the clay setup sheets most were running long eyelets on all the shocks. I had shorts on the...
12-29-2019, 09:14 AM
Replies: 3,699
Views: 734,718
Posted By PorTX

Same basic spring and piston setup for stock...

Same basic spring and piston setup for stock buggy as well? On carpet we ran stiffer springs and thicker oil on mod buggy (which is the car I was asking about above). I run stock (and 4wd mod) as...
12-29-2019, 08:47 AM
Replies: 3,699
Views: 734,718
Posted By PorTX

So leave the 1.7 in the rears? I also...

So leave the 1.7 in the rears?

I also noticed that most are running the full size batteries with weights under the battery. I am running the small shorty pack with no added weights. I still have...
12-29-2019, 08:18 AM
Replies: 3,699
Views: 734,718
Posted By PorTX

Thanks for that info. Hard to gather that...

Thanks for that info. Hard to gather that racing, once in October and once in January every year. This will be my 4th time to the track. Anyway here is a pic of the last trip up there. It is high...
12-29-2019, 04:21 AM
Replies: 3,699
Views: 734,718
Posted By PorTX

Trying to fix a handling issue. Running my b6.1...

Trying to fix a handling issue. Running my b6.1 on clay. The car works relatively well considering we only get to run on dirt twice a year. But I am trying to figure out what I need to do to keep the...
12-26-2019, 10:06 PM
Replies: 342
Views: 60,405
Posted By PorTX

Torque control (current limiter) vs expo (via...

Torque control (current limiter) vs expo (via radio). Just curious if anyone has experience with using ESC torque control vs adding expo in radio. We race on a loose outdoor surface that marbles...
12-20-2019, 07:15 PM
Replies: 5,507
Views: 981,300
Posted By PorTX

Swapped over to the emulsion caps. I think who...

Swapped over to the emulsion caps. I think who ever designed the o ring for the TKR8207 emulsion caps, should be kicked in the nuts! Those things are a pain to install in the caps. Almost like...
12-14-2019, 09:12 PM
Replies: 19
Views: 1,986
Posted By PorTX

Reading the new Hb thread. Hard to believe they...

Reading the new Hb thread. Hard to believe they marketed the new car to have some features/updates that did not make it on the new car. Hard to believe any company would ship cars that don’t have the...
12-13-2019, 08:40 PM
Replies: 19
Views: 1,986
Posted By PorTX

HB.....support......well they will sponsor anyone...

HB.....support......well they will sponsor anyone so I guess support could be considered okay?
12-13-2019, 05:44 AM
Replies: 34
Views: 3,970
Posted By PorTX

I was in hopes the AKA scribbles would be out by...

I was in hopes the AKA scribbles would be out by now. But they probably won’t be available before the race I will be attending. Anyone tried the Raw Speed rip tides?
12-12-2019, 08:13 PM
Replies: 34
Views: 3,970
Posted By PorTX

I ran space bars last time I went to an indoor...

I ran space bars last time I went to an indoor clay track. Several locals said they had no side bite compared to newer designs. So I will be following this thread! Got another indoor clay race coming...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.