R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 10
1
2
3
Last »
Search: Posts Made By: gtrmx
Showing results 1 to 25 of 230
Search took 0.01 seconds.
Forum: Electric On-Road
06-01-2018, 09:51 AM
Replies: 1,563
Views: 393,027
Posted By gtrmx

I think you can use this part. SAK-U421/V2...

I think you can use this part.

SAK-U421/V2 Center Pulley 20T

But I am not sure about side to side spacing.If you use the thin panaracer spurs you may make it...
Forum: Electric On-Road
03-22-2018, 01:06 PM
Replies: 2,291
Views: 634,307
Posted By gtrmx

Panaracer spurs fit for sure!!

Panaracer spurs fit for sure!!
Forum: Electric On-Road
12-06-2016, 08:16 AM
Replies: 1,731
Views: 538,492
Posted By gtrmx

We also use foam tires in our clubs. Foam tires...

We also use foam tires in our clubs. Foam tires generate a lot of side bite, which causes suspensions to travel deeper when compared to using rubber. Parting from base setup, Go up one or two springs...
Forum: Electric On-Road
11-30-2016, 11:37 PM
Replies: 1,005
Views: 284,366
Posted By gtrmx

Anyone experienced any oil leakage from the heave...

Anyone experienced any oil leakage from the heave dampers? I am guessing the orings do not totally seal as I tend to loose oil after a few runs. I have other brands of orings ready to be tested, but...
Forum: Electric On-Road
08-30-2016, 12:01 AM
Replies: 131
Views: 28,241
Posted By gtrmx

I already tried one-tooth longer belts, front and...

I already tried one-tooth longer belts, front and rear, but the cams cannot compensate for the extra length, so you end up with too loose belts. It is as if Team Durango did not want to fit the...
Forum: Electric On-Road
08-24-2016, 08:36 PM
Replies: 131
Views: 28,241
Posted By gtrmx

I used to source my spare parts from Tower...

I used to source my spare parts from Tower Hobbies but they are really slow to restock.

Any other online shop where I can buy some parts for my DETCV2??

Thanks!
Forum: Electric On-Road
08-24-2016, 08:34 PM
Replies: 131
Views: 28,241
Posted By gtrmx

I cannot remember the position I am using for my...

I cannot remember the position I am using for my belt tensioners, but let me suggest you swap out the original belts and use Tetsujin ones instead.

They are a lot more flexible and will sure...
Forum: Electric On-Road
09-19-2014, 07:45 AM
Replies: 3,615
Views: 343,422
Posted By gtrmx

Thank you Juan!!!

Thank you Juan!!!
Forum: Electric On-Road
09-18-2014, 11:36 AM
Replies: 3,615
Views: 343,422
Posted By gtrmx

TRF414MII swing shaft length

Does anybody know then length of the swing shafts for the TRF414MII??

39mm??
42mm??

I lost one and it is the only part I am missing to complete this car...

Thanks!!
Forum: Nitro On-Road
06-14-2010, 02:55 AM
Replies: 7,604
Views: 1,287,884
Posted By gtrmx

Use a spool. You will be surprised how nice and...

Use a spool. You will be surprised how nice and predictable the car will drive.

Do not worry about steering. This car has plenty of it.
Forum: Onroad Nitro Engine Zone
06-14-2010, 02:52 AM
Replies: 1,533
Views: 209,205
Posted By gtrmx

use the white one... I've had TM cars for...

use the white one...

I've had TM cars for years now and I even used the KFactory clutch in my RRR and loved it!!
Forum: Nitro On-Road
05-09-2010, 07:19 PM
Replies: 2,059
Views: 526,909
Posted By gtrmx

Composite diff gears

I have been browsing for the composite diff gears. I would like to find a store in the US that stocks them.

Could not find them at the TQ Hobbies site...

Thanks!!
Forum: Nitro On-Road
09-08-2009, 10:16 PM
Replies: 1,725
Views: 242,180
Posted By gtrmx

That size will prove difficult to get to here... ...

That size will prove difficult to get to here... let me check with the store and see what they can do...

:(
Forum: Nitro On-Road
09-08-2009, 06:45 PM
Replies: 1,725
Views: 242,180
Posted By gtrmx

I think I see what you are saying... I bet you...

I think I see what you are saying... I bet you probably use only about half way the total steering wheel travel also... right?

So not only would that make for a smooth driving style, but also,...
Forum: Nitro On-Road
09-08-2009, 01:11 PM
Replies: 1,725
Views: 242,180
Posted By gtrmx

Congratulations again, Bob!! I was taking a...

Congratulations again, Bob!!

I was taking a look at your setup.

You used 2.5° of toe-out in the front of the car. That seems like too much to me.

There is something there that I am not...
Forum: Nitro On-Road
09-08-2009, 12:31 AM
Replies: 1,725
Views: 242,180
Posted By gtrmx

There are several things that can cause your...

There are several things that can cause your tires to cone.

If you combine too much toe in with little camber then your tires will cone out. If you reduce toe you can reduce coning, but very...
Forum: Nitro On-Road
09-07-2009, 05:14 PM
Replies: 1,725
Views: 242,180
Posted By gtrmx

As for your diff feeling the same with the older...

As for your diff feeling the same with the older car, I am guessing your diff in the RS 08 was not really packed with oil, because I am certain it should have felt a lot stiffer. You need to leave...
Forum: Nitro On-Road
09-07-2009, 04:43 PM
Replies: 1,725
Views: 242,180
Posted By gtrmx

Nothing better than a happy driver after a race...

Nothing better than a happy driver after a race weekend!!

Great to hear you enjoyed it! Thanks for posting your setup and congratulations!!
Forum: Nitro On-Road
09-07-2009, 01:04 PM
Replies: 1,725
Views: 242,180
Posted By gtrmx

I do not think TM 50K oil is any thinner than...

I do not think TM 50K oil is any thinner than most brands. It just feels softer once inside the diff because the amount of oil that goes into G4RS 09 diffs is much less than that of Kyosho or Mugen. ...
Forum: Nitro On-Road
09-06-2009, 02:23 AM
Replies: 1,725
Views: 242,180
Posted By gtrmx

I think oils are just fine. That is what I use in...

I think oils are just fine. That is what I use in those conditions.

You may want to look at your shock spring-oil combo. Try lighter damper oil and stiffer springs, assuming you are parting from...
Forum: Nitro On-Road
09-05-2009, 09:11 AM
Replies: 1,725
Views: 242,180
Posted By gtrmx

I do not want to make promises that I cannot...

I do not want to make promises that I cannot keep, I still owe Randy. :blush:
I tend be short on time always.

But, yeah, let's take a look at it!

Anna, I saw your email. I will let you know...
Forum: Nitro On-Road
09-04-2009, 10:53 AM
Replies: 1,725
Views: 242,180
Posted By gtrmx

podium pic and race results... ...

podium pic and race results...

http://img266.imageshack.us/img266/2989/podium2.jpg (http://img266.imageshack.us/i/podium2.jpg/)
By gtrmx (http://profile.imageshack.us/user/gtrmx)
...
Forum: Nitro On-Road
09-03-2009, 11:26 PM
Replies: 1,725
Views: 242,180
Posted By gtrmx

Wow, very good job!! Great attendance!!

Wow, very good job!! Great attendance!!
Forum: Nitro On-Road
09-03-2009, 04:38 PM
Replies: 1,725
Views: 242,180
Posted By gtrmx

The best of luck for you!!:D

The best of luck for you!!:D
Forum: Nitro On-Road
09-02-2009, 10:56 PM
Replies: 1,725
Views: 242,180
Posted By gtrmx

Thanks for sharing! I noticed the -4 rear...

Thanks for sharing!

I noticed the -4 rear toe. How did the car go for him?
Showing results 1 to 25 of 230
 
Page 1 of 10
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.