Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: Slotmachine
Showing results 1 to 25 of 500
Search took 2.82 seconds.
Yesterday, 05:48 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Sounds like when you calibrated it you started...

Sounds like when you calibrated it you started with full throttle setting and not neutral. Make sure you calibrate it in the right order....1=neutral
2=Full throttle
...
Yesterday, 05:44 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Did you calibrate the speedo to the radio...

Did you calibrate the speedo to the radio properly?
01-09-2019, 06:18 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

start the RMA process...

start the RMA process here>https://www.hobbywingdirect.com/pages/rma
01-02-2019, 01:44 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

No I dont think you can. They are put on at the...

No I dont think you can. They are put on at the manfacturing stage. When you try to take them off cut the wires close to the speedo and they will come off easier.
12-31-2018, 03:39 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

If you have access to a computer try a factory...

If you have access to a computer try a factory reset.
12-27-2018, 07:56 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Screws

I believe you are correct.....2.5mm
12-03-2018, 07:27 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Try turning off all the heat protection

Try turning off all the heat protection
12-01-2018, 06:13 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

First of all did you calibrate the speedo to your...

First of all did you calibrate the speedo to your radio like the directions say?
11-30-2018, 05:05 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

i run on a 90' straight with a heavy eb410....

i run on a 90' straight with a heavy eb410. @42°of timing I run a 7.23 final ratio 81x28 2.5 transmition ratio my motor with a fan over the top of it run cool enough to hold tight after an 8 minute...
11-29-2018, 07:52 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

I run the G3 13.5 in 4wd buggy and it flies! I...

I run the G3 13.5 in 4wd buggy and it flies! I would say it is definately one of tge fastest race motors out and ut runs cool
11-12-2018, 01:46 PM
Replies: 442
Views: 117,892
Posted By Slotmachine

I run a Tekno eb410 on a track with a 90'...

I run a Tekno eb410 on a track with a 90' straight, my gear is 81x28 with 42° of endbell timing. You MUST use a fan blowwing on the whole motor can!
I am running blinky........
11-12-2018, 01:35 PM
Replies: 442
Views: 117,892
Posted By Slotmachine

As far as spinning tires,try setting the drive...

As far as spinning tires,try setting the drive freq. To the highest value the softening range all the way up and the value all the way up. This set up should make the cars throttle very soft. If...
10-29-2018, 07:03 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Ive done some playing around with the timing and...

Ive done some playing around with the timing and gearing on the G3 13.5 motor in 4wd buggy. You can choose to set the timing at 50° and gear high (9.20) on a 90 ' straight or timeing set to 35° and a...
10-29-2018, 06:56 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Boost adds timing throughout the throttle range,...

Boost adds timing throughout the throttle range, unless you set the rpm parameters. Boost can really screw up your drivability on lower wind motors so I tend to stay away from it and use Turbo on i...
10-02-2018, 05:03 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

I think they could help keep temps down , they...

I think they could help keep temps down , they will definately help in smoothung the throttle.
09-20-2018, 01:03 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Check the plug with a volt meter to make sureits...

Check the plug with a volt meter to make sureits not a receiver issue.
09-10-2018, 10:00 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Hi....are you powering up the speedo with a...

Hi....are you powering up the speedo with a battery?and make sure your usb is hooked into the box nice and snug
08-31-2018, 10:17 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Make sure that all the timing and boost features...

Make sure that all the timing and boost features are turned off and then save it before closing the program. Did you know that you can make any one of those modes blinky just by doing these settings.
08-23-2018, 07:08 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

If you plug into your P.C and open the Hobbywing...

If you plug into your P.C and open the Hobbywing program you might try a factory reset before sending the unit in. The troubleshoot page says that sometimes it could be caused by a bad motor.
08-22-2018, 08:51 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

You can run it with no sensor wire, it will...

You can run it with no sensor wire, it will actually feel softer on t by e bottom end and should require more throttla input. Is the 3250 you have one ofvtge new series or an old one? The new ones...
07-31-2018, 03:43 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

It sounds like you may need to start a Repair...

It sounds like you may need to start a Repair Authorization or R.A form with Hobbywing USA. Go to their site to start the process. Im sorry to hear that you are havi g an issue.
07-29-2018, 11:04 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

You're most likely going to need the 1/8 set up,...

You're most likely going to need the 1/8 set up, maybe the https://www.hobbywingdirect.com/products/xr8-esc-combo?variant=11823665092
07-29-2018, 11:01 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

make sure its not plugged in the wrong way. What...

make sure its not plugged in the wrong way. What speedo are you trying to tune?
07-29-2018, 10:08 AM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

Okay Hobbywing users.......since there are no...

Okay Hobbywing users.......since there are no problems to answer right now what do you say to sharing some race results or some good experiences you are having because of Hobbywings great...
07-17-2018, 03:40 PM
Replies: 12,729
Views: 1,208,844
Posted By Slotmachine

I think..... because you're running a Motor other...

I think..... because you're running a Motor other than HW you cant run the full sensored mode. I know that when you pair this speedo with the newest HW motor you can take full advantage of all of the...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service