R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: aft53
Showing results 1 to 25 of 183
Search took 0.01 seconds.
08-13-2022, 04:17 PM
Replies: 106
Views: 11,292
Posted By aft53

So I would like to get a MIP tool holder for the...

So I would like to get a MIP tool holder for the following:
3.0, 2.5 Ball End, 2.5, 2.0 Ball End, 2.0, 1.5, 7mm Hex Driver, 5.5mm Hex Driver, 4mm turnbuckle wrench.

Can you do it and how much...
07-29-2022, 12:17 PM
Replies: 16,819
Views: 4,271,653
Posted By aft53

F1 Paint Labs

I just bought some from RCF1 Paint Labs a couple of months ago.
05-14-2022, 07:00 AM
Replies: 16,819
Views: 4,271,653
Posted By aft53

Schumacher/Shimizu 572 in the rear and Volante...

Schumacher/Shimizu 572 in the rear and Volante green/ (med hard), blue/ (medium), or purple (med soft) in the front, depending on track conditions. You may not need the medium soft fronts. Also,...
05-04-2022, 05:39 PM
Replies: 16,819
Views: 4,271,653
Posted By aft53

Notoriousjje, I really like your F1 paint job. ...

Notoriousjje, I really like your F1 paint job. BTW, what body is that?
04-28-2022, 08:33 AM
Replies: 1,547
Views: 370,373
Posted By aft53

Does the HW ESC need to be installed without the...

Does the HW ESC need to be installed without the fan?
04-27-2022, 07:17 AM
Replies: 1,547
Views: 370,373
Posted By aft53

When you used the Gear Diff at Camarillo, what...

When you used the Gear Diff at Camarillo, what oil did you use?
04-26-2022, 09:00 AM
Replies: 1,547
Views: 370,373
Posted By aft53

Gear drive Exotek F1 Ultra

My home track is Camarillo, Ca which is a large asphalt track with low-medium grip. I would like to know what people think of using the Xray Gear Diff in these conditions compared to the ball diff?
04-25-2022, 05:26 PM
Replies: 1,547
Views: 370,373
Posted By aft53

Hey Mike: Would you consider your "Long...

Hey Mike:

Would you consider your "Long Track" setup the most up to dat for Camarillo? Also, What are your thoughts about using sway bars and damper tubes on a track like Camarillo?
03-26-2022, 03:44 PM
Replies: 16,819
Views: 4,271,653
Posted By aft53

I have an F1 question. My car seems to be super...

I have an F1 question. My car seems to be super sensitive to throttle input, especially compared to my other cars (Xray T-4 2021, Yokomo BD8 and 3Raacing Mini MG). I can't seem to punch it at all. ...
12-02-2021, 10:43 AM
Replies: 16,819
Views: 4,271,653
Posted By aft53

Are Tamiya F1 tires made by Shimizu?

Are Tamiya F1 tires made by Shimizu?
07-08-2021, 10:43 AM
Replies: 1,675
Views: 643,461
Posted By aft53

Under TCS rules, is traction compound allowed...

Under TCS rules, is traction compound allowed and, if so, what is the best one to use on low grip asphalt when the ambient temperature is around 75° F?
Forum: Nitro On-Road
05-08-2021, 01:36 PM
Replies: 37
Views: 10,548
Posted By aft53

Servos for 1/8 Onroad Nitro

How much torque is needed for the steering servo and how much for the throttle servo?
04-16-2020, 10:28 AM
Replies: 7,826
Views: 1,800,096
Posted By aft53

Also, what are the lane dividers made of?

Also, what are the lane dividers made of?
04-16-2020, 10:24 AM
Replies: 7,826
Views: 1,800,096
Posted By aft53

Is this the Home Depot carpet used above? If you...

Is this the Home Depot carpet used above? If you are running on the bottom side, what is the best way to tape the carpet together? I have a 16' x 18' area and the rolls are only 12" wide.
...
04-08-2020, 02:05 PM
Replies: 7,826
Views: 1,800,096
Posted By aft53

Tire Taping Question

I have read through the posts for the last year plus and looked for You Tubes on the subject but have found no clear answers. Assuming I use Kyosho tire tape. I simply put a layer around the wheel...
04-08-2020, 02:02 PM
Replies: 2,112
Views: 260,677
Posted By aft53

LapTracker question

How does the LapTracker app "pick up" the laps as the car goes by? Do you need to install a transponder in the car? If so, which brands work?
04-02-2020, 10:45 AM
Replies: 7,826
Views: 1,800,096
Posted By aft53

Additional motor mount question

Or is the R246-1352 damper system better to go with the R246-1355 motor mount?
04-02-2020, 10:38 AM
Replies: 7,826
Views: 1,800,096
Posted By aft53

Thanks so much for getting back to me on the...

Thanks so much for getting back to me on the motor mount question. I actually have a R246-1355 ordered and on the way so I guess I should stay with it. Should I still buy the top damper set...
04-01-2020, 02:21 PM
Replies: 7,826
Views: 1,800,096
Posted By aft53

Which motor mount to buy?

First time on the thread. I have an MR-03W RM Sports with a 430GT body. I want to convert it to a 98mm WB with a MM/MML motor mount. which R246 or PN mount should I get and also which top Damper...
03-13-2020, 10:12 AM
Replies: 11
Views: 2,156
Posted By aft53

Which receivers will work with the DX2E...

Which receivers will work with the DX2E transmitter?
02-24-2020, 09:18 AM
Replies: 1,675
Views: 643,461
Posted By aft53

what is the Tamiya part number for the servo...

what is the Tamiya part number for the servo saver upgrade that is allowed in the Stock class?
02-10-2020, 09:08 AM
Replies: 8,906
Views: 831,438
Posted By aft53

Is the Euro Truck class a regular part of your...

Is the Euro Truck class a regular part of your onroad racing?
07-29-2019, 02:39 PM
Replies: 1,972
Views: 598,811
Posted By aft53

M17 Screen

At the bottom of the M17 screen are the D/R settings for ST, TH and BR. Is there any way to change the TH so that Front Brake or BR2 or Aux1 is showing D/R instead?
07-28-2019, 01:52 PM
Replies: 1,972
Views: 598,811
Posted By aft53

Can anyone help me? I just received my M17 radio...

Can anyone help me? I just received my M17 radio and am very impressed? I previously had an M12S. I set up one model without any real issues. However, on my second model I need to use the "car...
Forum: Nitro On-Road
07-25-2019, 08:33 PM
Replies: 11
Views: 3,935
Posted By aft53

Minimum power needed for a 1/8 onroad car.

What is the minimum power needed for a 1/8 onroad car.
Showing results 1 to 25 of 183
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.