R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 3
1
2
3
Search: Posts Made By: macke
Showing results 1 to 25 of 56
Search took 0.01 seconds.
Forum: Electric Off-Road
05-26-2012, 10:10 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

Yes, I have used the "solid" ones from Yeah...

Yes, I have used the "solid" ones from Yeah Racing for quite some time now and they are also great! I will never use the "barrel" type again other than for charging leads. Also, when I bought my...
Forum: Electric Off-Road
05-23-2012, 01:28 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

@Tekin: According to this post...

@Tekin: According to this post (http://www.rctech.net/forum/10650629-post14984.html) from Ty Campbell LED 5 is now used for "timing profiles" instead of "throttle profiles". If this is true then the...
Forum: Electric Off-Road
05-23-2012, 01:03 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

Did you read the first sentence of what I wrote?...

Did you read the first sentence of what I wrote? It also seems that you have missed the point of the discussion.

"If you have a 4S pack it is more likely not to happen but if you run a saddle pack...
Forum: Electric Off-Road
05-22-2012, 12:27 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

If you have a 4S pack it is more likely not to...

If you have a 4S pack it is more likely not to happen but if you run a saddle pack config with 2 x 2S (which becomes more and more popular) the cells will only be matched within each pack and there...
Forum: Electric Off-Road
05-20-2012, 12:41 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

The above statement is true but is only valid for...

The above statement is true but is only valid for ONE cell. When connecting four (or more) of them in series you have to look at the total voltage of the pack. The cells have to be extremely well...
Forum: Electric Off-Road
04-01-2012, 02:05 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

I have a question for the Tekin reps... Got...

I have a question for the Tekin reps...

Got an RA# in 30/1/2012 for a broken RX8 but I've not yet sent it in for service/replacement. Is the RA# still valid or should I request for a new one...
Forum: Electric Off-Road
11-19-2010, 01:26 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

Yes four screws is correct, but there should also...

Yes four screws is correct, but there should also be three (empty) holes at the bottom. If you got four holes you've the old case.
Forum: Electric Off-Road
11-19-2010, 09:24 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

Typo? The new updated cases have three holes. You...

Typo? The new updated cases have three holes. You should have received one of those...
Forum: Electric Off-Road
10-27-2010, 10:45 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

I'm with you John, 3.0V is waaaay too low. You...

I'm with you John, 3.0V is waaaay too low. You should never run you lipos to cutoff in the first place but IF you do it, I would say (from personal experience) you should never set the cut off lower...
Forum: Electric Off-Road
09-30-2010, 10:46 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

All think all of them will probably work but the...

All think all of them will probably work but the 3200 40c may be a bit weak. It also depends on if the packs are quality packs, are in good shape, well balanced and have a true C rating. You should...
Forum: Electric Off-Road
09-29-2010, 01:16 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

It's not enough to just talk about the C rating....

It's not enough to just talk about the C rating. 30C doesn't say that much if you don't know the capacity of the battery.

If you have a 4000mAh battery rated at 30C (continuous) it will handle...
Forum: Electric Off-Road
09-15-2010, 01:38 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

In my case the problem can not be caused by a...

In my case the problem can not be caused by a brown out, I already have a capacitor on the receiver (same spec as the Spektrum one). Currently I have my cutoff set at approx 3.48V per cell but I have...
Forum: Electric Off-Road
09-10-2010, 04:14 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

I have had the problem in both 198 and 208.

I have had the problem in both 198 and 208.
Forum: Electric Off-Road
09-10-2010, 02:33 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

Sounds much like the problem I was having and...

Sounds much like the problem I was having and still have occasionally. About 7 min in a run the LVC kicks in and the LC LED lights up. I wait a few seconds and everything is back to normal. If I...
Forum: Electric Off-Road
08-09-2010, 01:45 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

I didn't say there was anything wrong with his...

I didn't say there was anything wrong with his battery... I just asked for more info to better help him analyze the problem. Sure, I could have said that he should send it in to Tekin but with the...
Forum: Electric Off-Road
08-09-2010, 07:20 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

According to the manual the LEDs 1, 3, 5 flashing...

According to the manual the LEDs 1, 3, 5 flashing means, I quote, "Voltage Cutoff set below battery voltage or in hi-temperature thermal shutdown". I think there is a misprint in the manual, they...
Forum: Electric Off-Road
08-09-2010, 03:35 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

Hmmm... that info is a bit sparse. What happens...

Hmmm... that info is a bit sparse. What happens when the car stop running? What does the LEDs show? First thing I would check is the soldering on the motor tabs and on the ESC soldering posts. Do the...
Forum: Electric Off-Road
08-03-2010, 01:56 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

I sure did. The ESC is recalibrated. If I wasn't...

I sure did. The ESC is recalibrated. If I wasn't in neutral I would get the 1, 2, 3 or 5, 6, 7 LEDs.
Forum: Electric Off-Road
08-02-2010, 03:38 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

That can't be true. I have put six packs through...

That can't be true. I have put six packs through it without any problems with the all 7 LEDs flashing. It's not the exactly the same as if I turn off the transmitter, then all 7 will flash...
Forum: Electric Off-Road
07-31-2010, 04:20 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

Bump. Anyone? Am I the only one experiencing...

Bump. Anyone? Am I the only one experiencing this? Temp LED indicators are almost impossible to read when mixed with the "all 7 flash".
Forum: Electric Off-Road
07-28-2010, 01:31 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

Just tested the new firmware today but I don't...

Just tested the new firmware today but I don't understand the new flashing LEDs. Is it supposed to flash all 7 LEDs all the time? The sequence seems to be fash all 7 - NW - flash all 7 - NW and so...
Forum: Electric Off-Road
07-28-2010, 02:55 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

Isn't the stock spur 40T on the Hyper9e? If so,...

Isn't the stock spur 40T on the Hyper9e? If so, and with an internal ratio of 3.9 you would get the following with a 2050.

Pinion Speed
15T 39.1 mph (62.9 km/h)
16T 41.7 mph (67.0...
Forum: Electric Off-Road
07-12-2010, 03:36 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

Yeah I now how lipo's and VC works. What I don't...

Yeah I now how lipo's and VC works. What I don't understand is why turning off the VC would help to further investigate in my problem. If the cutoff is premature, i.e. the battery voltage is way over...
Forum: Electric Off-Road
07-12-2010, 03:05 PM
Replies: 18,851
Views: 2,128,286
Posted By macke

Ok, I set the NW to 15 instead of 10 and it seems...

Ok, I set the NW to 15 instead of 10 and it seems to work better now. I do not experienced any start up problems and I do not loose the reverse anymore.


I'm not sure I fully understand your...
Forum: Electric Off-Road
07-10-2010, 02:20 AM
Replies: 18,851
Views: 2,128,286
Posted By macke

Randy, thank you for taking your time. What...

Randy, thank you for taking your time.

What radio are you using?
Eurgle 3ch (cheap radio but it has many settings like EPA, throttle curves, DR with expo etc). One thing that come to my mind is...
Showing results 1 to 25 of 56
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.