R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Search: Posts Made By: BILKO1
Showing results 1 to 22 of 22
Search took 0.00 seconds.
06-08-2013, 07:17 AM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Thanks.

Thanks.
06-05-2013, 03:40 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Without reading all 1500+ pages of this thread is...

Without reading all 1500+ pages of this thread is there any way to get my old Tekin RS to run a 13.5T on 1 cell in a Supastox? I have updated to the latest firmware and set the speedo to 1s and...
08-19-2010, 03:58 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

The 'N' mark is 30 degrees i know as i asked...

The 'N' mark is 30 degrees i know as i asked Steve weiss about it when i was having trouble with my Tekin and Novak combo. You can download the timing info here...
08-14-2010, 02:39 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Fixed my broken wiring connected up to hotwire...

Fixed my broken wiring connected up to hotwire and found all the settings that i had put in with the dodgy connection had not been taken by the esc. Updated the settings and qualified for the A...
08-08-2010, 01:37 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

When you plugged the hotwire in to the esc did...

When you plugged the hotwire in to the esc did you have the green light pulsating on the hotwire and the centre led on the esc lit up? I had a similar problem last week the hotwire light was on and...
08-06-2010, 04:21 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

I've found the problem with my Tekin, the plug...

I've found the problem with my Tekin, the plug that goes to the receiver has a broken wire just a few strands holding it together under the insulation on the red wire. i guess every time i pull it to...
08-06-2010, 03:04 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

My son and i both ran our Tekins with the new 208...

My son and i both ran our Tekins with the new 208 software tonight not good. I had poor brakes and he kept loosing the turbo after about 3 mins. I changed all my setttings back to what they were on...
08-05-2010, 02:27 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Haven't run any fans since the weight reduction...

Haven't run any fans since the weight reduction to 1350 grams came in.
08-05-2010, 06:34 AM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

No 1/10th touring car running 13.5t.

No 1/10th touring car running 13.5t.
08-04-2010, 04:28 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Thanks for your reply, I'm worried about the...

Thanks for your reply,
I'm worried about the temp going up after the race when the esc is turned off is this normal?
08-04-2010, 02:42 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Probably a stupid question but here goes, i...

Probably a stupid question but here goes, i updated to v208 and in the timing section there is a slider for timing advance, (not seen this in 203) am i correct in assuming this is ignored if running...
07-22-2010, 09:33 AM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

I recently asked about the Novak timing and got...

I recently asked about the Novak timing and got this response.
Originally Posted by Steve Weiss
"Those motors are set to 30 degrees internally. I would just leave the timing there... there is a...
07-22-2010, 08:50 AM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Thanks

Thanks
07-22-2010, 08:49 AM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

I found this a few pages back to but wasn't sure...

I found this a few pages back to but wasn't sure if it was directed at me.

You should not be running 3.0 ramp rate on a track this short. Your end rpm is too low and this is causing your setup to...
07-22-2010, 07:21 AM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Originally Posted by BILKO1 Hi guys, i'm...

Originally Posted by BILKO1
Hi guys, i'm after a little more punch/rip out of the corners. I'm running on a small technical carpet track using an Xray 009 with the 38t pulleys, Novak ballistic...
07-19-2010, 05:08 AM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Sorry, track is 24m x 12m straight is 24m the...

Sorry, track is 24m x 12m straight is 24m the infield is very technical.
07-18-2010, 03:19 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Hi guys, i'm after a little more punch/rip out of...

Hi guys, i'm after a little more punch/rip out of the corners. I'm running on a small technical carpet track using an Xray 009 with the 38t pulleys, Novak ballistic 13.5t and an fdr of 7.42. On the...
06-01-2010, 02:43 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Thanks;)

Thanks;)
06-01-2010, 02:34 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Afaik the timing on the Novak and LRP that i have...

Afaik the timing on the Novak and LRP that i have is fixed ( no timing marks) this worries me as i can not find out what they are set at in the factory ( different forums = different results) I know...
06-01-2010, 09:49 AM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

Need some help with settings on a Tekin RS using...

Need some help with settings on a Tekin RS using v203 firmware and a choice of motors. i've been running a Tekin Redline 10.5 which is ballistic on my present settings but too much for the small...
04-29-2010, 02:59 PM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

I've just dusted off my 1/10 touring car and...

I've just dusted off my 1/10 touring car and updated the software to the new 203 and would like a little guidence to base settings please. I run on a small technical high grip carpet track using...
07-31-2009, 06:27 AM
Replies: 23,359
Views: 2,643,637
Posted By BILKO1

I'm not being lazy but i'm not reading through...

I'm not being lazy but i'm not reading through 365 pages to find an answer that might not be here:) I've just got an Tekin RS and want to know what the highest timing boost i can use on a Novak...
Showing results 1 to 22 of 22


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.