R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Search: Posts Made By: dale_gribble
Showing results 1 to 8 of 8
Search took 0.00 seconds.
02-10-2012, 01:31 PM
Replies: 11
Views: 7,948
Posted By dale_gribble

After all this BS, the castle cooler motor fan...

After all this BS, the castle cooler motor fan broke a blade during practice yesterday. The thing is totally protected and obviously I had the body on.

So, the castle cooler goes in the garbage.
02-08-2012, 05:27 PM
Replies: 11
Views: 7,948
Posted By dale_gribble

The final step was to solder the new fan leads to...

The final step was to solder the new fan leads to the respective connector. I soldered the wires and shrinkwrapped them individually. Then I shrinkwrapped over that. I tested the fans on the bench...
02-08-2012, 05:26 PM
Replies: 11
Views: 7,948
Posted By dale_gribble

Then, just carefully press the new fan in place. ...

Then, just carefully press the new fan in place. Make sure the new fan's power wires route clean out of the stock location and don't get cut. I routed the wires as shown here. The fan wire leads...
02-08-2012, 05:26 PM
Replies: 11
Views: 7,948
Posted By dale_gribble

Dremel or cut one of the fan mounting tabs off of...

Dremel or cut one of the fan mounting tabs off of the motor cooler or ESC case as shown below.

Speed control case. Note, the new Mamba Max Pros have a 1-piece case. Here you see the older design...
02-08-2012, 05:26 PM
Replies: 11
Views: 7,948
Posted By dale_gribble

Ok, my post count is high enough now. The...

Ok, my post count is high enough now.

The stock fans are press fit in. Simply use a small flathead screwdriver or hobby knife to carefully pry the stock fan out of the housing. Do one side at a...
02-08-2012, 11:16 AM
Replies: 11
Views: 7,948
Posted By dale_gribble

I will post pictures and a full writeup whenever...

I will post pictures and a full writeup whenever I hit the post count required to post links... Stay tuned.
02-08-2012, 11:14 AM
Replies: 11
Views: 7,948
Posted By dale_gribble

36mm blower The blower uses a 30mm x 30mm x...

36mm blower

The blower uses a 30mm x 30mm x 7mm no-name fan. Its part number is YM0503PVS1. Here are it's specs from Alibaba's website:

30x30x7 (mm)
Sleeve bearing + 1 ball bearing
Rated...
02-08-2012, 11:13 AM
Replies: 11
Views: 7,948
Posted By dale_gribble

Castle Mamba Max Pro + 36mm blower FAN REPLACEMENT GUIDE

Hi guys-

I did some research on this and thought it could help someone else out there who may need to replace their fans. I bought a TEN-SCTE from someone who failed to mention the cooling fans...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.