R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
Search: Posts Made By: Cameron Kellogg
Showing results 1 to 5 of 5
Search took 0.04 seconds.
Forum: Radio and Electronics
07-22-2013, 11:37 AM
Replies: 13,879
Views: 1,873,285
Posted By Cameron Kellogg

My racing buddy and I are going to try and swap...

My racing buddy and I are going to try and swap out Tekin motors to see if it might be the sensor board on mine.

We have a track rule no passing through the first corner so when my truck does not...
Forum: Radio and Electronics
07-22-2013, 11:12 AM
Replies: 13,879
Views: 1,873,285
Posted By Cameron Kellogg

Anyone figure out the the fix for the SCT Pro ESC...

Anyone figure out the the fix for the SCT Pro ESC when running the Tekin 4600k motor. Mine is down to 3 on the punch setting and it still stutters so bad when I hit the throttle from a stop I am...
Forum: Radio and Electronics
06-16-2013, 03:43 PM
Replies: 13,879
Views: 1,873,285
Posted By Cameron Kellogg

Radio is Rev as recommended. I normally...

Radio is Rev as recommended.

I normally always used Tekin so I get their settings. The punch level I thought was a current limiter on HW but changing from 5 to 4 felt more like a throttle curve...
Forum: Radio and Electronics
06-16-2013, 11:23 AM
Replies: 13,879
Views: 1,873,285
Posted By Cameron Kellogg

Thanks Paul, So what would be the possible...

Thanks Paul, So what would be the possible solution. Just keep turning down the punch setting until I can get full throttle from a stop? Seems if I pull the trigger enough for the motor to move then...
Forum: Radio and Electronics
06-16-2013, 09:26 AM
Replies: 13,879
Views: 1,873,285
Posted By Cameron Kellogg

So punch level is not a throttle curve setting? ...

So punch level is not a throttle curve setting?

Only run this for a couple weeks and I have updated the software. HW SCT pro with a Tekin 4600. Radio end point turned down to 85% and punch level...
Showing results 1 to 5 of 5


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.