R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
Search: Posts Made By: RC Dad
Showing results 1 to 3 of 3
Search took 0.00 seconds.
Forum: Micro and Mini Scales
06-06-2009, 09:40 PM
Replies: 11
Views: 1,225
Posted By RC Dad

I just measured one and it's 4mm ID and 5mm OD. I...

I just measured one and it's 4mm ID and 5mm OD. I think they came either with the bearing set or possibly with the new axle pins.
Forum: Micro and Mini Scales
06-03-2009, 02:00 PM
Replies: 11
Views: 1,225
Posted By RC Dad

no, put a washer over the shaft. there's a...

no, put a washer over the shaft. there's a shoulder where the threads end that stops the nut from pinching the bushings, but when you put in bearings they're a tish narrower. put the washer on the...
Forum: Micro and Mini Scales
06-03-2009, 08:55 AM
Replies: 11
Views: 1,225
Posted By RC Dad

Did you replace the tiny washers that ride...

Did you replace the tiny washers that ride against the inside bearing races?
Showing results 1 to 3 of 3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.