R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 2
1
2
Search: Posts Made By: barrydidntknow
Showing results 1 to 25 of 30
Search took 0.00 seconds.
Forum: Nitro Off-Road
05-20-2010, 10:01 AM
Replies: 4
Views: 2,980
Posted By barrydidntknow

Where did you hear you would need a motor mount?...

Where did you hear you would need a motor mount? Assuming you have the mount the kit came with you can use that. As far as clutch, does it have the old 2 shoe clutch or something more advanced like a...
Forum: Nitro Off-Road
05-09-2010, 09:23 AM
Replies: 2
Views: 563
Posted By barrydidntknow

Nice buggy to start with I think. My first nitro...

Nice buggy to start with I think. My first nitro was an inferno 7.5 when they came out. As far as straightening the main chassis you would be better off looking for one on ebay. You can find them...
Forum: Track Locator Forum
05-08-2010, 03:28 PM
Replies: 1
Views: 1,296
Posted By barrydidntknow

New Track Layout Delta RC Antioch CA

I should have gotten pics but for those of you who go to Delta, the new layout for the outdoor 1/8 track looks like it is going to be a blast. Its much larger than last year and incorporates a back...
Forum: Nitro Off-Road
05-08-2010, 03:17 PM
Replies: 2,373
Views: 263,053
Posted By barrydidntknow

Thanks Easy rider. I will have to try it at some...

Thanks Easy rider. I will have to try it at some point. The old outdoor track I ran on last year was tight and technical so I have been looking for more low end but I just saw it(not finished yet)...
Forum: Nitro Off-Road
05-08-2010, 11:02 AM
Replies: 2,373
Views: 263,053
Posted By barrydidntknow

Anyone know what the stock pipe that came with...

Anyone know what the stock pipe that came with the Hyper 9 1.0 is comparable to? It just says OFNA for.21 on it. I have JP3, a couple 086's and other but what is the stock one most similar too....
Forum: Nitro Off-Road
05-08-2010, 09:38 AM
Replies: 18
Views: 10,805
Posted By barrydidntknow

Is this refering to the needle on the side of the...

Is this refering to the needle on the side of the HSN or on the opposite side of the carb? The manual calls one the meetering needle and one the mixture control needle. Am i correct in assuming you...
Forum: Nitro Off-Road
04-30-2010, 10:53 AM
Replies: 3
Views: 673
Posted By barrydidntknow

Cool. Thanks for the quick answers guys. I just...

Cool. Thanks for the quick answers guys. I just wanted to get some piece of mind.
Forum: Nitro Off-Road
04-30-2010, 10:24 AM
Replies: 3
Views: 673
Posted By barrydidntknow

v-spec HSN ?

Can anyone check out their v-spec and give me a general idea of your tuned HSN setting? I have it tuned to where I get good performance and nice temps in the 220 range max but the HSN is turned in...
Forum: Nitro Off-Road
04-26-2010, 10:27 AM
Replies: 34
Views: 2,282
Posted By barrydidntknow

That suck s they wont fix the points. I go to...

That suck s they wont fix the points. I go to this track every couple of weeks but always practice and never have actually raced. Id say go to another track but assuming you live near me(Pinole)...
Forum: Nitro Off-Road
04-16-2010, 11:26 AM
Replies: 3
Views: 809
Posted By barrydidntknow

I went to there garage sale about a year 1/2 ago....

I went to there garage sale about a year 1/2 ago. I got some good deals actually. I would deffinatley do some homework first if you are looking for anything specific and get there pretty early as...
Forum: Nitro Off-Road
04-08-2010, 01:41 PM
Replies: 14
Views: 1,582
Posted By barrydidntknow

Just did a test run. Deffinatley not the brakes...

Just did a test run. Deffinatley not the brakes at all. Did notice that my flywheel has a groove in it from the bottom of the clutch bell that was from when I had a different engine in the truggy and...
Forum: Nitro Off-Road
04-08-2010, 12:24 PM
Replies: 14
Views: 1,582
Posted By barrydidntknow

hmmmm.......I am noticing that the truggy doesnt...

hmmmm.......I am noticing that the truggy doesnt roll very freely evn with the engine pulled out and the brakes not on. I am use to my hyper 9 buggy that rolls quite easily. Do truggies tend have...
Forum: Nitro Off-Road
04-08-2010, 11:02 AM
Replies: 14
Views: 1,582
Posted By barrydidntknow

That would be odd as the only changes I have made...

That would be odd as the only changes I have made since my break in from factory setting has been to lean about 3/4 hour on the hsn and maybe 1/4 hour on the lsn and I had this issue since break in....
Forum: Nitro Off-Road
04-08-2010, 10:27 AM
Replies: 14
Views: 1,582
Posted By barrydidntknow

Clutch braking?

I am getting alot of off throttle braking, as in when i let off the gas my 8t 2.0 is acting like the breaks are on. I know it is not the brakes engaging and it rolls freelly when just i push it with...
Forum: Nitro Off-Road
04-06-2010, 11:27 PM
Replies: 1
Views: 1,956
Posted By barrydidntknow

lots of interchangable parts between the two for...

lots of interchangable parts between the two for sure. Not sure a full conversion makes sense as you could get a nice used 777 for less than it would cost. Take a look at infernosonly.com. I bet you...
Forum: Nitro Off-Road
04-05-2010, 09:07 AM
Replies: 2,373
Views: 263,053
Posted By barrydidntknow

rc dirtslinger? Yeah they are always breakin down...

rc dirtslinger? Yeah they are always breakin down Hyper 9's and selling the parts. Im keepin an eye on his shop for the screws and probably another set of bb shocks as a back up. Now if I could find...
Forum: Offroad Nitro Engine Forum
04-04-2010, 09:40 AM
Replies: 138
Views: 103,237
Posted By barrydidntknow

The best glow plug ignitor??

So what do the pro's use. Im tired of dealing with these crappy cheapos my hobby shop sells and want one that will last and hold a charge. Do i go with the D size battery powered ones? Is there a...
Forum: Nitro Off-Road
04-03-2010, 08:54 AM
Replies: 7
Views: 872
Posted By barrydidntknow

I have a clockwerks modded evo 2 and have run the...

I have a clockwerks modded evo 2 and have run the 086 and a jp-4. I prefer the jp-4 but again its a engine modded for more torque so for me its a good balance. As far as the 30% nitro you should be...
Forum: Nitro Off-Road
04-03-2010, 08:38 AM
Replies: 2,373
Views: 263,053
Posted By barrydidntknow

Beautiful!! Thanks. Got it for 48.00!!!! And its...

Beautiful!! Thanks. Got it for 48.00!!!! And its not from Taipae or hong kong, straight out Kentucky!
Forum: Nitro Off-Road
04-02-2010, 04:14 PM
Replies: 2,373
Views: 263,053
Posted By barrydidntknow

Difference between gl and 2.0 chasis?

Wondering if there is a difference between the 2.0 and GL chasis? I am sure they are both 4mm longer than the original but what else if anything is different? I got a great deal on fleabay and they...
Forum: Nitro Off-Road
03-28-2010, 09:07 PM
Replies: 7
Views: 752
Posted By barrydidntknow

Post I personally agree that fair is fair and the guy...

I personally agree that fair is fair and the guy who paid you first SHOULD get it but legally speaking the guy who told you he would pay for it the next day and paid late has the legal right to it,...
Forum: Nitro Off-Road
03-26-2010, 09:20 AM
Replies: 2,373
Views: 263,053
Posted By barrydidntknow

Break Caliper Spacing?

So I am doing a complete tear down and rebuild of my hyper 9 as I just got the new chassis and BB shocks are on the way. I am wondering what spacing you guys are using on the breaks. The manual has a...
Forum: Nitro Off-Road
03-15-2010, 10:08 PM
Replies: 13
Views: 731
Posted By barrydidntknow

too much gas can cut an engine out as well. I'd...

too much gas can cut an engine out as well. I'd say put all the needles back to factory settings, maybe new fuel line and glow plug as well, and tune from there. What engine is it?
Forum: Nitro Off-Road
03-15-2010, 08:48 PM
Replies: 33
Views: 3,761
Posted By barrydidntknow

Looks like maybe too much as I always get real...

Looks like maybe too much as I always get real good info from Integra. How does one figure out the power of 2 lipos running together? Add the mah and volts together? I know it cant be simple as that...
Forum: Nitro Off-Road
03-15-2010, 08:34 PM
Replies: 33
Views: 3,761
Posted By barrydidntknow

Too much power? It worked well with 1 batt as...

Too much power? It worked well with 1 batt as well.
Showing results 1 to 25 of 30
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.